Summary of the content on the page No. 1
INSTRUCTION MANUAL
GUIDE FOR USING THE DISHWASHER AND THE WASHING PROGRAMS
Summary of the content on the page No. 2
Contents 1. Safety and operating instructions ___________________________ 2 2. Installation and hook-up___________________________________ 5 3. Description of the controls _________________________________ 9 4. Operating instructions ___________________________________ 17 5. Cleaning and maintenance _______________________________ 31 6. Troubleshooting ________________________________________ 35 Thank you for choosing one of our products. You are advised to read this
Summary of the content on the page No. 3
Safety instructions 1. Safety and operating instructions THIS MANUAL FORMS AN INTEGRAL PART OF THE APPLIANCE: IT MUST ALWAYS BE KEPT INTACT TOGETHER WITH THE DISHWASHER. BEFORE USING THE APPLIANCE, CAREFULLY READ ALL THE INSTRUCTIONS CONTAINED IN THIS MANUAL. INSTALLATION MUST BE PERFORMED BY A QUALIFIED TECHNICIAN, IN COMPLIANCE WITH THE REGULATIONS IN FORCE. THIS APPLIANCE IS INTENDED FOR DOMESTIC USE, AND COMPLIES WITH THE EEC DIRECTIVES 73/23, 89/336 (INCLUDING 92/31
Summary of the content on the page No. 4
Safety instructions OBSOLETE APPLIANCES MUST BE RENDERED UNUSABLE. CUT OFF THE MAINS POWER CORD AFTER UNPLUGGING IT FROM THE WALL OUTLET, AND MAKE SAFE ANY COMPONENTS WHICH MIGHT BE DANGEROUS FOR CHILDREN (LOCKS, DOORS, ETC.). THIS APPLIANCE IS MARKED ACCORDING TO THE EUROPEAN DIRECTIVE 2002/96/EC ON WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT (WEEE). BY ENSURING THIS PRODUCT IS DISPOSED OF CORRECTLY, YOU WILL HELP PREVENT POTENTIAL NEGATIVE CONSEQUENCES FOR THE ENVIRONMEN
Summary of the content on the page No. 5
Safety instructions LEANING OR SITTING ON THE DISHWASHER DOOR WHEN OPEN MAY CAUSE THE APPLIANCE TO OVERTURN, PUTING PEOPLE AT RISK. NEVER LEAVE THE DISHWASHER DOOR OPEN; PEOPLE MIGHT TRIP OVER IT. DO NOT DRINK THE WATER RESIDUES WHICH MAY BE PRESENT INSIDE THE DISHES OR DISHWASHER AT THE END OF THE WASHING PROGRAM AND BEFORE THE DRYING CYCLE. KNIVES OR OTHER SHARP-ENDED COOKING UTENSILS MUST BE PLACED IN THE CUTLERY BASKET BLADE-DOWN, OR LAID HORIZONTAL IN THE TOP BASKE
Summary of the content on the page No. 6
Installation instructions 2. Installation and hook-up Remove the polystyrene basket retainers. Position the appliance in the desired place of installation. The back or sides of the dishwasher may be placed up against walls or other furniture units. If the dishwasher is installed near a heat source, fit the special insulating panel to prevent overheating and malfunction of the appliance. To ensure stability, install integrated or built-under dishwashers only under co
Summary of the content on the page No. 7
Installation instructions 2.1 Water supply connection Preventing the risk of clogging or damage: if the water pipe is new or has not been used for a long time, before connecting to the water supply check that the water is clear and free of impurities, to prevent damage to the appliance. The dishwasher must always be connected to the water system with new hoses; old or used hoses must never be reused. CONNECTING TO THE WATER SUPPLY Connect the intake hose
Summary of the content on the page No. 8
Installation instructions 2.2 Electrical connection and precautions CHECK THAT THE VOLTAGE AND THE FREQUENCY OF THE MAINS MATCH THE RATINGS ON THE NAME PLATE OF THE APPLIANCE POSITIONED ON THE INNER EDGE OF THE DOOR. THE PLUG ON THE SUPPLY CORD AND THE CORRESPONDING SOCKET OUTLET MUST BE OF THE SAME TYPE AND MEET THE REGULATIONS IN FORCE. THE PLUG MUST BE ACCESSIBLE AFTER INSTALLATION. NEVER DISCONNECT THE PLUG BY PULLING ON THE POWER SUPPLY LEAD. IN THE EVEN
Summary of the content on the page No. 9
Installation instructions FOR GREAT BRITAIN ONLY: THIS APPLIANCE MUST BE EARTHED. Fuse replacement If the mains lead of this appliance is fitted with a BS 1363A 13amp fused plug, to change a fuse in this type of plug use an A.S.T.A. approved fuse to BS 1362 type and proceed as follows: 1. Remove the fuse cover A and fuse B. 2. Fit replacement 13A fuse into fuse cover. 3. Refit both into plug. The fuse cover must be refitted when changing a fuse
Summary of the content on the page No. 10
User instructions 3. Description of the controls 3.1 Front panel All the dishwasher's controls and indicators are located on the front panel. Programming and option selection are only possible with the door closed. 1 WASHING PROGRAM SELECTOR 2 ON/OFF SELECTOR 3 START/PAUSE BUTTON 4 PROGRAM DELAY BUTTON 5 ½ LOAD WASH BUTTON 6 "3/1" OPTION BUTTON 7 START/PAUSE LIGHT 8 INFORMATION DISPLAY 9 ½ LOAD WASH LIGHT 10 "3/1" OPTION LIGHT 11 SALT WARNING LIGHT
Summary of the content on the page No. 11
User instructions SETTING THE WASHING PROGRAM To select the most suitable washing program, refer to the table below which indicates the recommended washing according to dish type and the degree of soiling. Once the most suitable washing program has been selected using the table provided, turn the WASHING PROGRAM SELECTOR (1) to set the program required, placing it against the identification symbol or nummer. QUANTITY DETERGENT INFORMATION PROGRAM DISHES TYPE P
Summary of the content on the page No. 12
User instructions PROGRAM DURATION CONSUMPTION PROGRAM SEQUENCE INFORMATION PRE- WASH COLD HOT DRYING MINUTES WATER POWER DISPLAY WASH RINSE RINSE (2) LITRES (1) Kwh (2) SOAK _ _ COLD 1 NO 15' 6 0,01 P1 DISH WARMER _ _ _ 68°C YES 40' 3,5 0,70 P2 QUICK _ 38°C 1 58°C NO 45' 13 0,85 P3 LIGHT _ 45°C 1 68°C YES 70’ 12 1,00 P4 ECO _ 55°C 1 68°C YES 125’ 14 1,25 P5 BIO (*) EN 50242 COLD 50°C 1 62°C YES 180' (**) (**) P6 AUTO 40-50
Summary of the content on the page No. 13
User instructions 3.3 Washing programs The dishwasher is equipped with a control panel and an INFORMATION DISPLAY (8), described in chapter "1. Description of the controls", from which it is possible to carry out all the power switch-on, switch-off and programming operations. Before starting a washing program make sure that: • The water supply tap is open. • The correct amount of detergent has been added to the dispenser. • The baskets have been correctly
Summary of the content on the page No. 14
User instructions HALF-LOAD FUNCTION (available in all programs except the soak program) This function is recommended for loads of up to 7 place-settings, and cuts down on the use of water and electricity. It can be selected using the HALF LOAD button (5) and there are three different options: 1) pressing the button just once selects the top basket (confirmed by the U symbol in the top of the display); 2) pressing the button a second time selects the bottom basket (c
Summary of the content on the page No. 15
User instructions DELAYING THE PROGRAM (available in all programs except the soak program) The PROGRAM DELAY button (4) can be pressed to delay the start of the washing program by up to 12 hours. This means that the dishwasher can be operated at the time of day of your choice. Press the PROGRAM DELAY button (4) again; the INFORMATION DISPLAY (8) will show the number of hours of delay with which the appliance will start. The INFORMATION DISPLAY (8) shows the set w
Summary of the content on the page No. 16
User instructions "3/1" OPTION BUTTON (available in all programs except the soak program) By pressing the button (6) you activate the "3/1" option, confirmed when the relative light comes on. This option has been studied for the use of dishwashing powder or tablets with integrated substances in place of regenerating salt or rinse-aid known on the market as “3 in 1” or “triple action” products; in this case the dishwasher will use the product in an optimal way avoiding
Summary of the content on the page No. 17
User instructions STARTING THE DISHWASHER After correctly carrying out all the preceding operations, to start the dishwasher simply press the START/PAUSE button (3) for a few seconds, until the start cycle acoustic device sounds. The INFORMATION DISPLAY (8) will show the duration of the program in minutes. The duration time is only approximate, because it depends on the washing conditions (quantity of dishes, water temperature, etc.), and is also continually updated as the
Summary of the content on the page No. 18
User instructions 4. Operating instructions Once the dishwasher has been correctly installed, prepare for use as follows: • Adjust the water softening system; • Add the regenerating salt; • Add the rinse aid and detergent. 4.1 Using the water softening system The amount of scale contained in the water (water hardness index) can cause whitish staining on the dry dishes, which tend to become dull over time. The dishwasher is equipped with
Summary of the content on the page No. 19
User instructions • Do not use table salt as it contains insoluble substances which, over time, may damage the water softening system. • When necessary, refill the regenerating salt container before starting the washing program. In this way, the excess saline solution will be immediately removed by the water; the prolonged presence of salt water inside the tank may lead to corrosion. Be careful not to confuse the salt and detergent packages; adding detergen
Summary of the content on the page No. 20
User instructions WATER HARDNESS TABLE WATER HARDNESS SETTING German Degrees (°dH) French Degrees (°dF) 0 - 4 0 - 7 Setting N. 1 NO SALT 5 - 15 8 - 25 Setting N. 1 16 - 23 26 - 40 Setting N. 2 24 - 31 41 - 60 Setting N. 3 32 - 47 61 - 80 Setting N. 4 48 - 58 81 - 100 Setting N. 5 Contact your local water board for information on the hardness of your water supply. 4.2 Using the rinse aid and detergent dispensers The detergent and rinse aid dispense
