Jackson Rack Conveyor Dishmachine user manual

Summary of the content on the page No. 1

Rack Conveyor Dishmachine
Maintenance Instructions
Motor Assembly
Replacement
07610-003-20-17
March 14, 2006

Summary of the content on the page No. 2

MAINTENANCE INSTRUCTIONS REPLACING CONVEYOR MOTOR The instructions provided here are for maintenance per- STEPS sonnel only. Unauthorized persons should not attempt any of the steps contained in these instructions. 1. Remove the (4) nuts holding the mounting plate in position. Warning: many of the instructions and steps within this document require the use of tools. Only authorized per- sonnel should ever perform any maintenance procedure on the dishmachine! PREPARATION 1. Power must be secured

Summary of the content on the page No. 3

MAINTENANCE INSTRUCTIONS REPLACING CONVEYOR MOTOR Removing the pump gasket Removing the rear clamp 10. Remove the wiring cover on the new motor assembly and pull 4. Remove the motor support bracket. the wires free. Install the conduit fitting. 11. Run the conduit to the motor, pulling the machine wires through and into the motor wiring box. 12. Rewire the motor exactly the same way the old one was wired and/or refer to the motor schematic to determine how the motor should be wired for the incomi

Summary of the content on the page No. 4

MAINTENANCE INSTRUCTIONS REPLACING CONVEYOR MOTOR SPECIAL PARTS 16. Attach the motor support rear clamp. Bracket, Motor Support 17. Adjust the motor support bracket so that the motor assembly is 05700-021-73-42 level and tighten down. Clamp, Motor Support 18. Attach the motor wiring cover. 04730-002-32-15 CONTACT INFORMATION AFTER MAINTENANCE ACTIONS Jackson MSC Inc. provides technical support for all of the Reconnect the incoming water (if disconnected) and turn dishmachines detailed in this m