Summary of the content on the page No. 1
Instruction booklet
DISHWASHER
Contents
EN
Installation, 2-5
Positioning and levelling
English, 1
Technical data
Electrical connection
Connecting the water supply
Ecodesign Regulation
Description of the appliance, 6
Overall view
Control panel
Loading the racks, 7
Lower rack
Cutlery basket
Upper rack
Start-up and use, 8-9
Starting the dishwasher
LFT 2284
Loading the detergent
Washing options
Wash cycles, 10
Wash cycle table
Rinse aid and refined salt, 11
Loading the rinse aid
Loading the refined
Summary of the content on the page No. 2
Installation Keep this instruction manual in a safe place for future Advice regarding the first wash cycle EN reference. If the appliance is sold, given away or moved, After the appliance has been installed, immediately before please ensure the manual is kept with the machine, so that running the first wash cycle, completely fill the salt dispenser the new owner may benefit from the advice contained within with water and add only then approximately 1 kg of salt it. see chapter entitled Rinse ai
Summary of the content on the page No. 3
The dishwasher meets the requirements set out by the Changing the Plug EN regulations in force concerning safety and electrical Cut off and dispose of the supplied plug if it does not fit equipment. your socket. Any technical checks should be conducted exclusively by a trained and authorised technician: Repairs carried To avoid a shock hazard DO NOT insert the discarded out by unaithorised persons will invalidate the guarantee, plug into a socket anywhere else. as well as posing a potential ha
Summary of the content on the page No. 4
Connecting the water supplies Sink Waste System EN Connect the outlet hose (without bending it) to a drain duct Connection to the water and electricity supplies should with a minimum diameter of 32 mm. only be performed by a qualified technician. The dishwasher should not stand on top of the water hoses or the electricity supply cable. Connecting the water inlet hose The water inlet and outlet hoses and the electricity supply cable may be positioned towards the right or the left in order to a
Summary of the content on the page No. 5
Anti-flooding protection* EN To ensure floods do not occur, the dishwasher: - is provided with a special system which blocks the water supply in the event of anomalies or leaks from inside the appliance. Some models are also equipped with the supplementary safety device New Acqua Stop*, which guarantees anti- flooding protection even in the event of a supply hose rupture. WARNING: HAZARDOUS VOLTAGE! Under no circumstance should the water inlet hose be cut as it contains live electrical parts. T
Summary of the content on the page No. 6
Description of the appliance Overall view EN 1. Upper rack 2. Upper sprayer arm 3. Tip-up compartments 4. Rack height adjuster 5. Lower rack 6. Lower sprayer arm 7. Cutlery basket 8. Washing filter 9. Salt dispenser 10. Detergent and rinse aid dispensers 11. Data plate 12. Control panel*** Control panel Low rinse aid indicator light* Wash cycle number Select wash light-up indicator cycle button ON/OFF Delayed start button* indicator light ON/OFF/Reset Low salt button Delayed start indicator ligh
Summary of the content on the page No. 7
Loading the racks Upper rack Before loading the racks, remove all food residue from EN Load this rack with delicate and lightweight crockery: glasses, crockery and empty liquids from glasses and cups. cups, saucers and shallow salad bowls. After loading the appliance, make sure that the sprayer arms can rotate freely. Lower rack and cutlery basket The lower rack can hold pans, lids, plates, salad bowls, cutlery, etc. Large plates and lids should ideally be placed at the sides of the rack. Adjus
Summary of the content on the page No. 8
Start-up and use Starting the dishwasher Measuring out the detergent EN A good wash result also depends on the correct 1. Turn the water tap on. amount of detergent being used; exceeding the 2. Open the door and press the ON/OFF button: you will stated amount does not result in a more effective hear a short beep and the display and option indicator wash and increases environmental pollution. lights switch on. 3. Measure out the detergent (see below). Only use detergent which has been sp
Summary of the content on the page No. 9
Wash options EN If an option is not compatible with the selected was cycle (see Table of wash cycles), the corresponding LED flashes rapidly 3 times and 2 short beeps will sound. Delayed start It is possible to delay the start time of the cycle by 3, 6 or 9 hours. 1. Press the DELAYED START button: every time it is pressed a buzzer sounds and the selected period of time is displayed. 2. Select the wash cycle and shut the door: after the beep sounds, the timer begins counting down. 3. Once this t
Summary of the content on the page No. 10
Wash cycles If the crockery is only lightly soiled or if it has been rinsed with water before being placed in the dishwasher, EN reduce the amount of detergent used accordingly. The number and type of wash cycles and options may vary depending on the dishwasher model. Detergent Wash Wash cycle (A) = compartment A cycles duration Wash cycle selection instructions Wash cycle Options (B) = compartment B which (tolerance include ±10%) Powder Liquid Tablets drying Hrs. Min. Environme
Summary of the content on the page No. 11
Rinse aid and refined salt - Press the P button repeatedly until the desired hardness level Only use products which have been specifically EN has been reached (1-2-3-4-5* see Water hardness table). designed for dishwashers. - To exit the function, wait approximately few seconds or press Do not use table salt or industrial salt, or washing another option* button, or switch off the machine using the ON/ up liquid. OFF button. Follow the instructions given on the packaging. Even if using multi-func
Summary of the content on the page No. 12
Care and maintenance Shutting off the water and electricity Clean the water inlet filter at the tap outlet regularly. EN - Turn off the water tap. supplies - Unscrew the end of the water inlet hose, remove the filter • Turn off the water tap after every wash cycle to avoid and clean it carefully under running water. leaks. - Replace the filter and screw the water hose back into • Always unplug the appliance when cleaning it and when position. performing maintenance work. Cleaning the filters Cle
Summary of the content on the page No. 13
Precautions and advice The appliance was designed and manufactured in Saving energy and respecting the EN compliance with current international safety standards. The environment following information has been provided for safety reasons and should therefore be read carefully. Saving water and energy • Only start a wash cycle when the dishwasher is full. While General safety waiting for the dishwasher to be filled, prevent unpleasant • This appliance is not intended for use by persons (including
Summary of the content on the page No. 14
Troubleshooting Whenever the appliance fails to work, check for a solution from the following list before calling for Assistance EN (see Assistance). Problem: Possible causes / Solutions: The dishwasher does not start or • Switch off the appliance by pressing the ON/OFF button, switch it back on after cannot be controlled approximately one minute and reset the program. • The appliance has not been plugged in properly. • The dishwasher door has not been shut properly. The door won’t close
Summary of the content on the page No. 15
After Sales Service After Sales Service Appliance Registration EN No one is better placed to care for your Hotpoint We want to give you additional benefits of Hotpoint appliance during the course of its working life ownership. To activate your free 5 year parts guarantee than us - the manufacturer. you must register your appliance with us. UK: 08448 24 24 24 Republic of Ireland: 01 230 0800 Essential Contact Information www.hotpointservice.co.uk Hotpoint Service We are the largest service team
Summary of the content on the page No. 16
Guarantee 195087744.01 03/2012 pb - Xerox Fabriano Guarantee EN 12 months Parts and Labour Guarantee Your appliance has the benefit of our manufacturer’s guarantee, which covers the cost of breakdown repairs for twelve months from the date of purchase. This gives you the reassurance that if, within that time, your appliance is proven to be defective because of either workmanship or materials, we will, at our discretion, either repair or replace the appliance at no cost to you. This guarantee is
