Summary of the content on the page No. 1
CARE & INSTRUCTIONS MANUAL
GUIDE D’UTILISATION ET D’ENTRETIEN
MANUAL DE INSTRUCIONES Y MANTENIMIENTO
SEMI-INTEGRATED AIS DISHWASHERS:
LAVE-VAISSELLE D’INTÉGRATION:
LAVAVAJILLAS INTEGRABLES:
� LFA-019 IX � LFA-019 SS � LFA-013 IX � LFA-013 SS
NOTE: To avoid accident and damage, please read these instructions carefully before operating the appliance.
NOTE: Veuillez lire ces instructions attentivement a fi n d’éviter accidents et dommages.
NOTA: Por favor, lea este manual de instrucciones atent
Summary of the content on the page No. 2
INDEX ENGLISH GENERAL 3 INSTALLATION AND FITTING 4 OPERATING INSTRUCTIONS A FEW PRACTICAL TIPS 11 APPLIANCE MAINTENANCE AND CLEANING 21 TROUBLE SHOOTING 23 FRANÇAIS GENERAL 27 INSTALLATION ET MONTAGE 28 UTILISATION DE L’APPAREIL ET CONSEILS PRATIQUES 35 NETTOYAGE ET ENTRETIEN DE L’APPAREIL 45 DIAGNOSTIC ET SOLUTION AUX PROBLÈMES 47 ESPAÑOL GENERAL 51 INSTALACIÓN Y MONTAJE 52 USO DEL APARATO Y CONSEJOS PRÁCTICOS 59 MANTENIMIENTO Y LIMPIEZA DEL APARATO 69 LOCALIZACIÓN Y SOLUCIÓN DE PROBLEMAS 71 “C
Summary of the content on the page No. 3
IMPORTANT SAFETY INSTRUCTIONS WARNING – When using your dishwasher, follow basic precautions, including the following: a) Read all instructions before using the dishwasher. b) Use the dishwasher only for its intended function. c) Use only detergents or wetting agents recommended for use in a dishwasher and keep them out of the reach of children. d) When loading items to be washed: 1) locate sharp items so that they are not likely to damage the door seal; and 2) load sharp knives with the handles
Summary of the content on the page No. 4
DISHWASHER INSTALLATION AND FITTING UNPACKING THE DISHWASHER 1 UNPACKAGING Remove the inner protection parts: polystyrene wedges for holding racks firmly.
Summary of the content on the page No. 5
English PLUMBING IN 2 The dishwasher is equipped with a high 3/8” Comp x 3/4” BSP Closing valve pressure water Washer Water connection pipe connection pipe with a 3/4 (1.905 cm) directional internal pipe thread at normal temperature and pressure values (NPT). In order to make its installation easier, the dishwasher includes a 3/8” (0.9525 cm) brass Closing valve 3/4" NPT compression part for 3/4 NPT which adapts the Water connection pipe pipe connector to a 3/8” compression part which incorporat
Summary of the content on the page No. 6
DRAINAGE Connect the drainage pipe incorporated into a waste disposal unit, on a drainage pipe tap or in a residual gap With an air gap depending on plumbing standards in force. Sink It is possible to lengthen Diswasher the drain pipe with material resistant to hot water and detergent. Always keep an inner diameter of at least 5/8” Min. 10" Max. 35" (1.5875 cm). Never exceed the maximum distance of 9” (22.86 cm) to the drainage piping. Sink Diswasher Raise the drain pipe and fasten it to the low
Summary of the content on the page No. 7
English ELECTRICAL CONNECTION 3 Please refer to the When installing or specifications label on moving the dishwasher, the top edge of the door, take care not to damage before making electrical the power cable. connections. Make sure than the voltage sent to the plug socket is the voltage which appears on the label. The dishwasher requires an earthed 120 V, 15 Amp, 60 Hz plug socket. The dishwasher is fitted with a flexible power IMPORTANT cable, ending in a three Inside the door, on the top edge
Summary of the content on the page No. 8
INTEGRATION 4 To install a built-in dishwasher: WORKTOP If the worktop is made of a wood, fit plastic protection over the worktop, which prevents the vapors affecting and damaging this area. b Fit the veneer to the front part of the dishwasher in order to fasten it to the piece of a b furniture. LEGS – LEVELLING c In order to build it into a line of furniture with a single base, loosen the extra bases and remove them. d Bring it to the work top and raise it by turning the rear feet c d away from
Summary of the content on the page No. 9
English DOOR There is a useful template with the assembly instructions. h Using the terminal strips supplied, raise the height of the control panel to reach the height of the furniture drawer. h i i Fit the corresponding template (J-120:K-110), fasten it down and mark the position of the holes. Drill, using a Ø 1,16” bit j and screw in the supports (part which curves upwards) to the decorative door. k Take the Decorative Door and slide the supports k j into the door slots. Pull up until touching
Summary of the content on the page No. 10
m In the event that the door springs are not strong enough, compensate for this with the two additional screws supplied in the accessories bag. n Fit the panel on the m n kitchen appliance, tightening it until the desired measurement is obtained. o Fix the dishwasher to the worktop if it is made of wood. If the worktop is made of granite, fix the dishwasher to the o o adjoining furniture. PRE-WASHING 5 Once the dishwasher has been installed satisfactorily, we recommend pre- washing: Press in On/
Summary of the content on the page No. 11
DISHWASHER OPERATING INSTRUCTIONS – A FEW PRACTICAL TIPS RINSE-AID AND DETERGENT 1 The rinse-aid helps drying and prevents drops of water forming on the dishes after washing. The rinse-aid compartment is inside the door, next to the detergent. The compartment has a RINSEAID COMPARTMENT DISPENSER 4 position dispenser to adjust the quantity of rinse-aid depending on the water quality (the dispenser leaves the factory in position 2). If drops of water can be seen on the dishes, increase the number
Summary of the content on the page No. 12
When should you add EMPTY FULL more rinse-aid? The dishwasher itself will tell you when you need to top up the rinse-aid. Depending on the model, there are two types of indicator: window or pilot light. WINDOW PILOT LIGHT Transparent window next A light on the front of the to the rinse-aid dishwasher shows when compartment cover. If the rinse-aid must be topped window shows a clear up. background, a top-up is required. If the background is dark, there is enough rinse-aid. The detergent is poured
Summary of the content on the page No. 13
English UTENSILS. TYPES AND POSITIONING 2 Types of utensils Not all dishes can be easily although make sure The pictures on used in a dishwasher. It it does not come into decorated porcelain is not advisable to put in contact with silver could be worn away if it wooden or clay cutlery as this can stain. is not good quality. utensils, or non heat Aluminum items can fade resistant plastic. over time. Stainless steel cutlery can be washed IMPORTANT Make sure that the utensils can be used in a dishw
Summary of the content on the page No. 14
c The cutlery, with the exception of knives, should be put in the cutlery rack making sure the handles face down d c FOR 13 PLACE SETTINGS EN-50242 d Fit the more delicate pieces such as cups and glasses made of porcelain or glass, and standard sized plates in the top rack. There is an area specifically for large cutlery. There are also racks which, when vertical, can be used to hold wine glasses. When you choose the Express program, the Top Load or Half Load function the dishes can TOP LOAD onl
Summary of the content on the page No. 15
English Adjusting the racks The racks can be adjusted depending on the load 9 7 The top rack can be 4/9 1/2 fitted at two different heights so that different size plates can be washed. In the high position, it is possible to wash 12 10 standard 7 1/2 plates in 1/5 2/9 the top rack and 12 1/5 plates in the lower rack. Fitting the top rack in the low positions, it is possible to wash 9 4/9 plates on top and 10 2/9 plates below. a Model A, top rack: It can be adjusted without removing it from its r
Summary of the content on the page No. 16
SELECTING THE WASH PROGRAM 3 TIME DELAY EnSav Hyg EnergySaver 1 2 161º F 155º F Hygienizer 3 PROG 4 130º- 150º F 5 150º F 130º F 6 7 130º F ADVANCED INTELLIGENT SYSTEM 8 E 105º F ADDITIONAL STAGES START / PAUSE FUNCTION button buttons Pilot light Button RINSE-AID ON/OFF ON/OFF ADDITIONAL PROGRAMMES PROGRAMME FUNCTION SELÉCTOR pilot lights Hyg 3h 6h 9h Hygienizer 1 2 161º F 3 155º F 4 150º F 5 150º F 6 130º F ADVANCED INTELLIGENT SYSTEM To select the wash program, proceed as foll
Summary of the content on the page No. 17
English There are several types of program depending on the dishwasher model. It is very important to choose the wash program correctly depending on the dirtiness, quantity and type of dishes. AMOUNT OF PROGRAM TEMPERATURE (°F) DISH TYPE DETERGENT (g) For dishes which will Pre-wash Withou not be washed P1 detergent immediately For dishes and Super pans which are intensive 161 25+15 extremely dirty P2 For dishes and Intensive pans which are 155 25+15 P3 very dirty Normal For dirty dishes 150 25+5
Summary of the content on the page No. 18
SELECTING ADDITIONAL FUNCTIONS 4 The wash functions must always be selected after choosing the wash program. Any change of program during selection cancels out the previously selected functions. These functions allow specific adjustments on the wash load, timing and consumption. The additional functions depend on the model: Button: Time delay Button: Energy Saver Button: Top / Low load Allows you to delay wash Shortens the washing and start. There are models drying operation times. This uses onl
Summary of the content on the page No. 19
English START UP 5 Once the dishwasher is switched on, the wash program and the additional functions have been chosen, you only have to press the start button. WASH PROGRAM PROGRESS 6 The active phases at each moment of the EnSav EnSav Hyg Hyg program appear EnergySaver EnergySaver 1 1 successively as the wash 2 2 161º F 161º F 3 3 155º F 155º F Hygienizer Hygienizer PROG PROG 4 4 130º- 150º F 130º- 150º F progresses. 5 5 150º F 150º F 130º F 130º F 6 6 Pilot lights, located over 7 7 130º F 130º
Summary of the content on the page No. 20
When the dishwasher is 1. Press the Pause button. Except if the change in operation and … 2. Put the item in the interferes in the duration of - You wish to put an extra dishwasher and/or the selected wash program plate in the dishwasher. change the wash or is the delay option. They - You wish to change the program. you should press the wash program 3. Press the Start button. ON/OFF button ( ), to change its status. IMPORTANT Please take into consideration that the Start / Pause button is d
