Summary of the content on the page No. 1
YOUR LIFE. OUR INSPIRATION.
Dishwasher Installation Instructions
Instructions d’installation du lave-vaisselle
Instrucciones de instalación para lavavajillas
!
"
!
#
Use and Care Manual located on reverse side
Tourner le guide pour les instructions d’utilisation et d’entretien
Voltee el manual para encontrar las instrucciones de uso
Summary of the content on the page No. 2
Summary of the content on the page No. 3
Table of Contents / Important Instructions Table of Contents IMPORTANT INSTRUCTIONS ................................ 1 Placing the Dishwasher ......................................... 10 Tools Needed ........................................................... 2 Securing the Dishwasher ....................................... 10 Materials Needed..................................................... 2 Drain Hose Connection .......................................... 11 Materials Supplied ............
Summary of the content on the page No. 4
Tools and Materials Needed TOOLS NEEDED Hammer Hole Saw Pipe Wrench Adjustable Wrench Tape Measure Slot Screwdriver Phillips Screwdriver Torx Screwdriver Level Wire Cutter Wire Stripper Drill MATERIALS NEEDED (Additional materials may be required to comply with local codes.) Electrical Supply Cable - Minimum #14 AWG, 2 conductor, 1 ground, insulated copper conductors rated 75°C or higher. Hot Water Supply Line - Minimum 3/8” O.D. copper tubing or metal braided dishwasher supply line. Shut-off va
Summary of the content on the page No. 5
Summary of the content on the page No. 6
Enclosure Preparation 23-9/16" WARNING (598mm) Electrical Shock Hazard To avoid electrical shock, make sure the water supply and electrical supply are shut off before 90 90 installation or service. 34" (864mm) ENCLOSURE PREPARATION minimum NOTE: This dishwasher is designed to be enclosed on the top and both sides by standard residential kitchen cabinetry. Select a location as close to the sink as possible for 23-5/8" – 24-1/4" (600–616 mm) easy access to water supply and drain lines. Figure 1 F
Summary of the content on the page No. 7
Electrical Preparation ELECTRICAL PREPARATION WARNING Electrical Shock Hazard To avoid electrical shock, do not work on an energized circuit. Doing so could result in serious 30" injury or death. Only qualified electricians should (762mm) perform electrical work. Do not attempt any work on the dishwasher electric supply circuit until you 21" are certain the circuit is (533mm) de-energized. WARNING Figure 4 Fire Hazard To avoid a fire hazard, make sure electrical work Dishwasher Electrical Rating
Summary of the content on the page No. 8
Plumbing Preparation PLUMBING PREPARATION WARNING Shut off Valve Scald Hazard To avoid being scalded, do not perform any work on a charged hot water line. Serious injury could result. Only qualified plumbers should perform 14" (355mm) plumbing work. Do not attempt any work on the Hot Water dishwasher hot water supply plumbing until you Supply Line are certain the hot water supply is shut off. Figure 6 Temperatures required for soldering and sweating will damage the dishwasher’s base and water
Summary of the content on the page No. 9
Summary of the content on the page No. 10
Summary of the content on the page No. 11
Door Panel Installation DOOR PANEL INSTALLATION SHU/SHE Models - Accessory Panel Installation If you have an SHU/SHE model and have ordered an 25” 1/4” max. accessory panel kit, install the panel prior to sliding the (636 mm) (6 mm) dishwasher into place. The panel dimensions are shown in Figure 15. 23-1/16” SHI Models - Panel Installation (586 mm) SHI models come with additional mounting hardware and a template sheet with installation instructions. The stain- less steel models of the SHI series
Summary of the content on the page No. 12
Summary of the content on the page No. 13
Drain Hose Connection Installation of the Rubber Drain Hose Adaptor 1 Obtain the Rubber Drain Hose Adaptor and the two hose clamps from the Dishwasher Installation Kit. 2 On one outside end of the Rubber Drain Hose Adapter is a raised groove. Insert the drain hose into the end without the raised groove. Be sure to fully insert the drain hose. 3 Secure the connection with the Silver Spring Clamp. 4 Use the Gold Screw Clamp to attach the Rubber Drain Hose Adaptor to the house plumbing. Connecting
Summary of the content on the page No. 14
Hot Water Connection HOT WATER CONNECTION WARNING Scald Hazard To avoid being scalded, do not perform any work on a charged hot water line. Serious injury could result. Only qualified plumbers should perform plumbing work. Do not attempt any work on the dishwasher hot water supply plumbing until you are certain the hot water supply is shut off. NOTE: Make certain that the correct 90° elbow fitting (not supplied) for the hot water supply line has been pur- chased and installed on the dishwasher a
Summary of the content on the page No. 15
Electrical Connection ELECTRICAL CONNECTION Strain WARNING Relief Electrical Shock Hazard Plate To avoid electrical shock, do not work on an energized circuit. Doing so could result in serious injury or death. Only qualified electricians should perform electrical work. Do not attempt any work on the dishwasher electric supply circuit until you Strain Relief are certain the circuit is de-energized. (not supplied) WARNING Fire Hazard Figure 27 To avoid a fire hazard, make sure electrical work is p
Summary of the content on the page No. 16
Electrical Connection/ Door Tension Adjustment/ Base and Toe Panel ELECTRICAL CONNECTION (continued) WARNING Fire Hazard To avoid a fire hazard, make sure there are no loose electrical connections. Make sure all electrical connections are properly made. 1/8” 3mm Do not pre-twist the wires before connecting them with wire nuts. Extend the dishwasher’s stranded wires 1/8” (3mm) Figure 29 beyond the power supply cable’s solid wires, as shown in Figure 29. 5 Using the supplied wire nuts, connect
Summary of the content on the page No. 17
Base and Toe Panel/ Final Instructions BASE AND TOE PANEL (Continued) Plastic Base Access Panel and Toe Panel Installation (SHY66C, SHX99A, SHE66C, SHE99C, SHX57C, and SHV57C models only) 1 Place the Plastic Base Access Panel under and up the a front bottom panel of the dishwasher, as shown in c Figure 32a. 2 Insert the Plastic Base Access Panel screws into the Plastic Base Access Panel, as shown in Figure 32b. b Tighten the Plastic Base Access Panel Screws. 3 Place the Cotton Insulation Strip
Summary of the content on the page No. 18
Customer Service CUSTOMER SERVICE Your Bosch dishwasher requires no special care other than that described in the Care and Cleaning section of the Use and Care Manual. If you are having a problem with your dishwasher, before calling for service please refer to the Self- Help section of the Use and Care Manual. If service is necessary, contact your dealer or installer or an authorized service center. Do not attempt to repair the appliance yourself. Any work performed by unauthorized personnel may
Summary of the content on the page No. 19
Table des Matières / Instrucciones Importantes Table des Matières INSTRUCTIONS IMPORTANTES................................1 Emplacement ........................................................... 10 Outils nécessaires ......................................................2 Fixation du lave-vaisselle ......................................... 10 Matériaux nécessaires ...............................................2 Connexion du tuyau de vidange ............................... 11 Matériaux fournis
Summary of the content on the page No. 20
