2JANE Professional loudspeakers VX Series user manual

Summary of the content on the page No. 1

VX SERIES
Professional loudspeakers
Quick Start Guide

Summary of the content on the page No. 2

Introduction Designed, engineered and built in the United Kingdom, the VX Series from Tannoy comprises a range of passive loudspeakers for demanding professional and commercial sound applications. Within the VX Series, system designers can choose from a variety of sizes, power levels and coverage patterns to suit particular requirements. This Quick Start Guide presents only the essential information required to properly unpack, connect and (when applicable) configure for bi-amp operations.

Summary of the content on the page No. 3

Unpacking Crossovers Each Tannoy VX Series loudspeaker is carefully tested and inspected VX Series loudspeakers are supplied as standard for passive operation prior to shipment. After unpacking, please check for any exterior via the internal crossover network. If higher peak outputs and additional physical damage, and save the carton and any relevant packaging low frequency output is required, then the VX Series can be used materials in case the loudspeaker again requires packing and in conju

Summary of the content on the page No. 4

6481 0585 / 0911 Bi-Amp Operation Rigging and Safety Procedures The VX 12HP, VX 12Q, VX 12.2Q, VX 15HP, VX 15Q only may be Tannoy Professional loudspeakers should be installed only by fully internally reconfigured for bi-amp operation to supply greater system qualified installers using dedicated Tannoy hardware, in accordance headroom. Reconfiguration is as follows: with all the required safety codes and standards that are applied at the place of installation. First, remove the rear terminat