Wayne-Dalton Corp.9000 user manual

Summary of the content on the page No. 1

Rim Cylinder / Night Latch Autolatch ECR Lock
Installation Instructions and Owner’s Manual
All Residential Door Models: 5000, 9700, 9800,
Wayne-Dalton, a Division of
Overhead Door Corporation
8000 & 9000 Series & Wood Doors
P.O. Box 67, Mt. Hope, OH 44660
www.Wayne-Dalton.com
(2)
Parts Breakdown
Keys*
(6) 1/4” - 20 x 9/16”
Rim cylinder*
Track bolts
Lock backup plate
(8300/8500/8700/9700/9800/Wood) Trim ring*
(2) #12 Pan head screws*
(2) Foam tape
Night latch
(9100/9400/9600/5120/5140) (4) #

Summary of the content on the page No. 2

Center stile STEP 1: Drilling Lock Section CAUTION DO NOT DRILL LOCK SECTION OR INSTALL LOCK ON (1) 1-1/4” DOORS WITH OPENERS. THE DOOR AND/ OR OPENER Dia. hole MAY BE DAMAGED IF THE OPENER IS USED WHILE THE DOOR IS LOCKED. (4) Pre-punched holes NOTE: Common practice for doors with the odd number of raised panels is to mount the lock towards the right side of the section when looking out. (3) 3/4” Dia. holes IMPORTANT: REMOVE ALL BURRS FROM THE DRILLED HOLES BEFORE FACE DOWN FACE UP IN

Summary of the content on the page No. 3

STEP 2: Outside Lock Handle Assembly 3/4” dia. #10 Phillips 8000/8100/8200 DOORS, (SEE FIG. 4): Align the outside handle holes head screws assembly with the handle pointing towards the floor and insert the assembly through the previously drilled 3/4” diameter holes in the Shank section. Secure the outside lock handle to the section with (2) #10 phillips head screws. 5120/5140/6100/8300/8500/9700/9800/9100/9400/9600 & WOOD Outside DOORS, (SEE FIG. 5A & FIG. 5B): Align the outside handle a

Summary of the content on the page No. 4

Trim ring STEP 4: Installing The Auto Latch Lock Locate the auto latch striker plates over the pre-punched holes in the Rim plate vertical track nearest the center of the lock section. Fasten the striker (4) #8 x 1/2” cylinder plates to the vertical track using (2) 1/4” - 20 x 9/16” track bolts and Pan head Center stile flanged hex nuts. Align the auto latch flippers such that the arm will screws engage the striker plates. Position the auto latch flipper 1/8” from the edge of the section