Radio Shack 63-984 user manual

Summary of the content on the page No. 1

63-984.fm Page 1 Wednesday, September 8, 1999 4:42 PM
Cat. No. 63-984
Wireless Intercom Door Chime
Your RadioShack Wireless Intercom — light so you can easily
Indicators
Door Chime operates as a two-tone confirm the chime’s operation.
doorbell and an intercom. The chime
is simple to install because it requires
WARNING: To reduce the risk of fire or
no wiring. Your chime's two channel shock hazard, do not expose this product to rain
or moisture.
switch and digital coding prevent other
transmit

Summary of the content on the page No. 2

63-984.fm Page 2 Wednesday, September 8, 1999 4:42 PM Connecting the Receiver to AC PREPARATION Power Setting the Channel and Code Locate a standard AC outlet in the area The transmitter and receiver are where you want to hear the chime and equipped with two selectable operation use the intercom. Plug the receiver's channels and two selectable digital power cord into the outlet. POWER codes, to ensure positive operation and lights. prevent interference from similar prod- ucts nearby. Select

Summary of the content on the page No. 3

63-984.fm Page 3 Wednesday, September 8, 1999 4:42 PM 2. Place the batteries into the battery BELL on the transmitter. The chime compartment as indicated by the should sound. polarity symbols (+ and –) marked BELL inside. 3. Be sure the rubber seal around the battery compartment is properly positioned, then replace the cover and tighten the screw. Replace all four batteries if the transmit- 2. If the chime does not sound, make ter’s indicator lights dimly or not at all certain that the trans

Summary of the content on the page No. 4

63-984.fm Page 4 Wednesday, September 8, 1999 4:42 PM low). Then insert an anchor into 4. Once the transmitter is securely on each hole. the bracket, insert the two supplied pan-head machine screws through 3 /16 Inch Diameter Hole the two holes on the lower edge of the transmitter and into the threaded 50mm holes in the bracket. 85mm 2. Align the metal mounting bracket with the holes you just drilled and drive a screw through the bracket into each hole. Do not overtighten Mounting the Receive

Summary of the content on the page No. 5

63-984.fm Page 5 Wednesday, September 8, 1999 4:42 PM 3. Route the AC power cord beneath CARE the tabs on either side of the chan- nel on the back of the receiver To use your RadioShack Wireless Inter- com Door Chime system for a long time: 4. Align the receiver's keyhole slots with the screw heads and slide the • Keep the system dry. If it gets wet, receiver down to secure it. wipe it dry immediately. • Use and store the system only in normal temperature environments. OPERATION • Handle the

Summary of the content on the page No. 6

63-984.fm Page 6 Wednesday, September 8, 1999 4:42 PM Dimensions (HWD): Changes or modifications to this product 7 7 7 6 /16 · 3 /16 · 1 /16 in not expressly approved by RadioShack, (163 · 88 · 36 mm) or operation of this product in any way 7 other than as detailed by this Owner’s Weight .............................................. 7 /16 oz Manual, could void your authority to op- (210 g) erate the product. RECEIVER Channel Frequency: Channel A ........................... 49.860 MHz SPECIFI