Gianni Industries DK100 user manual

Summary of the content on the page No. 1

DK-100 Stand Alone Digital Keypad (5 Codes)
Operation User’s Manual




















I. Product Characteristic:
Blue back light keypad, easy to recognize in the dark.
ANSI standard size, convenience for mortise installation
Allows up to 99 PIN codes
Epoxy potting, water-proof design
Dual relays operate simultaneously, able to control locks and other access control
system
Cutting spare delay time after door closes for anti-tailgating
LED display with audi

Summary of the content on the page No. 2

III. The indicator signal chart & Default ： Green LED Relay activated Red LED Power on, stand-by Yellow LED Programming mode LED signal 1 Flashing Yellow LED Key-in Code Confirmed Blue LED Controller Stand-by Flashing Blue LED Controller Locked Bi Key-in, Effective PIN codes Bi － x 2 Entering or Exiting from the Program mode Data computing error, other operation Bi － x 3 Audio mistakes Master Code reset to default （12345 ）or Bi － x 5 remove all stored user codes Master cod

Summary of the content on the page No. 3

Enter Program Mode: 1. Compose twice the master code (Factory master is 「12345 」) → (2 beeps), LED: yellow → "programming mode" 2. Attention: If the system is not entered any codes or data in 60 seconds, it will exit from the programming mode automatically. After 30 wrong codes attempts to enter the master code, the lockout facility will operate for 60 seconds. (Keypad flashes with blue back light) Exiting from the program mode: Press 「＃」 to exit from the programming mode.