Summary of the content on the page No. 1
19230
Wireless Door Chime
User’s Manual
Chime
Push Button
Thank you on your purchase
of the Wireless Door Chime.
Before installation, please
read this manual carefully
and keep for future reference.
Summary of the content on the page No. 2
Required Tools • Flathead screwdriver • Drill • 1/16” drill bit • 5/32” drill bit • Phillips screwdriver Included Hardware: • 2 – Plastic anchors • 4 – Screws • 1 – Double sided Tape • 1 – 12 Volt battery Battery Installation: Chime Unit: 1. Make sure the Chime power is switched to the “OFF” position. 2. Remove battery cover by pressing the tab in the direction of the arrow and lifting at the same time. 3. Install 2 “AA” batteries noting the battery orientation inside the battery compartme
Summary of the content on the page No. 3
Linking the Push Button to the Chime Unit: 1. Switch the Chime power to the “ON” position. The red LED will begin blinking slowly. Press 2. Within 10 seconds of turning on the power, press the push button. The LED on the chime will blink rapidly and turn off. The Chime and Push Button have been successfully linked. Press 3. To test, press the Push Button and the Chime Unit should chime. Note: If linking fails or you change the batteries or turn the Chime Unit off and back on, you will h
Summary of the content on the page No. 4
Installation using the provided screws: 1. Remove the old push button and use this location to install your new Push Button. 2. Remove the battery cover as described in the installation of the battery. 3. Use the battery cover as a template to mark the position of the screws. 4. Using a 1/16th inch drill bit, drill a pilot hole for each screw. 5. Using a Phillips head screwdriver, mount the back cover using the screws provided. (Note: The back cover has an arrow and the word “Up” embo
Summary of the content on the page No. 5
5. Press the Push Button on to the back cover by inserting the top of the Push Button onto the top of the back cover first and then pressing on the bottom of the Push Button to snap the bottom of the Push Button into place. Installing the Chime Unit: Note: Avoid mounting the Chime Unit on metal surfaces, as this may result in reduced range of transmission. The Chime Unit should also be mounted no farther than 150 feet from the Push Button. No further than 150 feet away 1. Select a mountin
Summary of the content on the page No. 6
Chime Template
Summary of the content on the page No. 7
Troubleshooting: 1. Make sure the batteries are installed according to the polarity markings inside the battery compartment on the Chime Unit. 2. Make sure the battery is installed according to the polarity markings inside the battery compartment on the Push Button. 3. Try installing new batteries. 4. Make sure the Chime Unit is no farther than 150ft. from the Push Button. 5. Try moving the Chime Unit to a different location that is within the 150ft. range. 6. Make sure the Push button is not
Summary of the content on the page No. 8
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
