Summary of the content on the page No. 1
®
®
V ViewSonic iewSonic
-- Q Quick Start Guide uick Start Guide
Digital Photo Frame
Digital Photo Frame
- Guide de démarrage rapide
- Guía de Inicio Rápido
DPX702 DPX802
M Mo od de ell N No o.. :: V V S S11220 07 78 5
Summary of the content on the page No. 2
English Compliance Information FCC Statement This device complies with part 15 of FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reason
Summary of the content on the page No. 3
Important Safety Instructions 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this unit near water. 6. Clean with a soft, dry cloth. If still not clean, see “Cleaning the Display” in this guide for further instructions. 7. Do not block any ventilation openings. Install the unit in accordance with the manufacturer’s instructions. 8. Do not install near any heat sources such as radiators, heat registe rs, stoves,
Summary of the content on the page No. 4
English Declaration of RoHS Compliance This product has been designed and manufactured in compliance with Directive 2002/95/EC of the European Parliament and the Council on restriction of the use of certain hazardous substances in electrical and electronic equipment (RoHS Directive) and is deemed to comply with the maximum concentration values issued by the European Technical Adaptation Committee (TAC) as shown below: Proposed Maximum Actual Substance Concentration Concentration Lead (Pb)
Summary of the content on the page No. 5
Package contents Check your Digital Photo Frame package for the following items. • Digital Photo Frame • Power adapter • Stand • Quick Start Guide • USB cable • Replacement front panel* * The bundled front panel varies depending on the model you purchase. Replacing front panel If your Digital Photo Frame package contains a spare front panel, follow these instructions to replace the front panel for personal preference. 1. Locate the indent on the edge near the memory card socket. 2. Follow the
Summary of the content on the page No. 6
English Connect 1. Align the head of the stand with the socket, then rotate clockwise until the stand locks into place. 2. Plug the power adapter from the device to a power outlet. Locatecontr ol keys(in the back panel) Locate the control buttons in the back panel according to the following table. Button Function OK Enter or confirm the selection Move to the previous or left selection Left Right Move to the next or right selection Up Move upward Down Move downward Power On/Off Turn ON/OF
Summary of the content on the page No. 7
Remote Control Refer to the following image and table for details of the remote control. 1 2 3 4 26 5 25 6 24 7 23 8 22 9 21 10 20 11 19 12 View 18 13 Setting 17 14 16 15 No. Item Description No. Item Description 1 POWER Disabled on this model 14 EXIT Go back one menu level 2 MUSIC Shortcut to the Audio menu 15 ROTATE Rotate photo 90° clockwise Navigate down in menus/ 3 VIDEO Shortcut to the Video menu 16 DOWN/NEXT skip to next available media 4 MUTE Mute audio output 17 FULL SCREEN Enlarge imag
Summary of the content on the page No. 8
English Settings Brightness Allows you to adjust the screen brightness. Language Allows you to select the language you need. Default Go to SETTINGS >Default , then select Yes to retore to the factory default setting or No to discard the selection. Set Beep Allows you to turn on/off the key control sound. Status Displays the software version and the current memory size. Auto Tilt Automatically adjusts the orientation of the screen when you rotate the frame. The default value is On. Auto T
Summary of the content on the page No. 9
View Photos From the main screen, press the Up and Down navigation keys to select PHOTO, then select the photo source you want to display. Photos pre-stored in the device will appear when no memory card or USB flash disk is connected. When photo source is selected, press OK to switch between 3 view modes: • Browsemode : manual viewing of photos one-by-one • Thumbnail mode : list of all photos When viewing photos in Thumbnail mode, hold the Down navigation key for 2 seconds then release t
Summary of the content on the page No. 10
English Copy multi-photos 1. In Thumnail mode, select one photo, then press the Down navigation key . The selected photo is labeled with a "+" mark. 2. Repeat step 1 to other photos you want to copy to a source. 3. Finishing selection, repeat step 2–5 in section Copy photos fromyour photo source . Delete photos from your photo source 1. In Thumnail mode, press the navigation keys to select one photo. 2. Hold the Down navigation key for 2 seconds then release to quickly enter the setting
Summary of the content on the page No. 11
Supported format JPEG: JPEG Baseline (4:4:4/4:2:2/4:2:0, support up to 8000x8000 pixels), Progressive JPEG (Support up to 1024x1024 pixels) BMP: MS Windows V3.1/4/8/16/24 uncompressed Bitmap. (Support up to 1024x1024 pixels) The system allows you to display 4000 photos at most from your own memory card or USB flash disk. Quick start guide 11 English
Summary of the content on the page No. 12
English View Video From the main screen, press the navigation keys to select VIDEO, then select the video source you want to play. Videos pre-stored in the device will appear when no memory card or USB flash disk is connected. 1. Insert your memory card containing video into the corresponding slot, or insert your USB flash disk into the USB port. Videos on your memory card will appear after a few seconds. See page 9 for memory card and USB port locations. 2. Press the navigation keys to s
Summary of the content on the page No. 13
Copy multi-video 1. Select one video, then press the Right navigation key. The selected video is labeled with a "+" mark. 2. Repeat step 1 for the other videos you want to copy to a source. 3. Finishing selection, repeat step 2–5 in section Copyvideos from your videosour ce . Delete video from your video source 1. Press the navigation keys to select one video. 2. Press View on the remote control or hold the Right navigation key for two seconds to enter the video settings menu. 3. Sele
Summary of the content on the page No. 14
English Play Audio From the main screen, press the navigation keys to select AUDIO, then select the audio source you want to play. Audio pre-stored in the device will appear when no memory card or USB flash disk is connected. 1. Insert your memory card containing audio into the corresponding slot, or insert your USB flash disk into the USB port. Audio on your memory card will appear after a few seconds. See page 9 for memory card and USB port locations. 2. Press the navigation keys to sel
Summary of the content on the page No. 15
Copy multi-audio 1. Select one audio, then press the Right navigation key. The selected audio is labeled with a "+" mark. 2. Repeat step 1 for the other audio you want to copy to a source. 3. Finishing selection, repeat step 2–5 in section Copy audio fromyour audio source . Delete audiofr om your audio source 1. Press the navigation keys to select one audio. 2. Press View on the remote control or hold the Right navigation key for two seconds to enter the audio settings menu. 3. Selec
Summary of the content on the page No. 16
English Customer Support For technical support or product service, see the table below or contact your reseller. Note: You will need the product serial number. T=Telephone Country/Region Web Site E-mail F=Fax AUS=1800 880 818 Australia/New Zealand www.viewsonic.com.au service@au.viewsonic.com NZ=0800 008 822 T (Toll-Free)= 1-866-463-4775 Canada www.viewsonic.com T (Toll)= 1-424-233-2533 service.ca@viewsonic.com F= 1-909-468-1202 Europe/Middle East/ Baltic countries/North www.viewsoniceurope.c
Summary of the content on the page No. 17
