Summary of the content on the page No. 1
4-259-438-12 (1)
For your safety
Digital Photo Let’s get the photo
frame ready
Frame
Let’s view an image
DPF-A710/A700
Try using various functions
Troubleshooting
Additional information
Operating Instructions
Before operating this unit, please read this manual thoroughly and
retain it for future reference.
Owner’s Record
The model and serial numbers are located at the rear.
Record the serial number in the space provided below. Refer to
these numbers whenever you call upon your Sony dealer
reg
Summary of the content on the page No. 2
Declaration of Conformity WARNING Trade Name: SONY Model No.: DPF-A710 To reduce fire or shock hazard, do not Responsible Party: Sony Electronics Inc. expose the unit to rain or moisture. Address: 16530 Via Esprillo, San Diego, CA 92127 U.S.A. Do not expose the batteries to Telephone No.: 858-942-2230 excessive heat such as sunshine, fire This device complies with part 15 of the FCC or the like. Rules. Operation is subject to the following two conditions: CAUTION (1) This device may not ca
Summary of the content on the page No. 3
safety, performance or data integrity reasons require a For the Customer in Europe permanent connection with an incorporated battery, this This product has been tested and found compliant battery should be replaced by qualified service staff with the limits set out in the EMC Directive for using only. To ensure that the battery will be treated properly, connection cables shorter than 3 meters (9.8 feet). hand over the product at end-of-life to the applicable collection point for the recyc
Summary of the content on the page No. 4
Notice for users Read this before using Program © 2010 Sony Corporation Notes on playback Documentation © 2010 Sony Corporation Connect the AC adaptor to an easily accessible AC outlet. Should you notice an abnormality in it, disconnect it from the AC outlet immediately. All rights reserved. This manual or the software described herein, in whole or in part, may not be Notes on copyrights reproduced, translated or reduced to any machine Duplication, edition, or printing of a CD, TV readable
Summary of the content on the page No. 5
Table of Contents Read this before using ..................................................................................... 4 For your safety Checking included items .................................................................................. 7 Identifying the parts ......................................................................................... 8 x Digital photo frame ............................................................................................... 8 x Remote con
Summary of the content on the page No. 6
Troubleshooting If an error message appears ...........................................................................23 If trouble occurs .............................................................................................23 Additional information Precautions ....................................................................................................25 Installation ...............................................................................................................25
Summary of the content on the page No. 7
For your safety oyousaey For your safety Checking included items Make sure that the following items are included. Digital photo frame (1) Stand (1) Attaching to the screw hole (page 10) , Remote control (1) (DPF-A710 only) Removing the protective sheet (page 10) , AC adaptor (1) Connecting to the AC power source (page 12) , Operating Instructions (this manual) (1) The supplied CD-ROM contains the Digital Photo CD-ROM (Digital Photo Frame Frame Handbook that explains operations and setup
Summary of the content on the page No. 8
Identifying the parts x Digital photo frame Front Remote sensor (DPF-A710 only) LCD screen Sony logo Rear BACK button ENTER button Direction (v/V) buttons Direction (B/b) buttons MENU button VIEW MODE button (page 15) 1 (on/standby) button Standby Indicator USB mini B connector (page 22) Memory card slot (page 14) Access lamp Holes for hanging unit on the wall DC IN 5 V jack Stand GB 8
Summary of the content on the page No. 9
For your safety x Remote control (DPF-A710 only) VIEW MODE buttons 1 (on/standby) button SLIDE-SHOW ( ) button SINGLE button CLOCK ( ) button INDEX ( ) button MENU button Zoom in ( ) button Direction (B/b/v/V) buttons ENTER ( ) button BACK button Zoom out ( ) button SELECT DEVICE button IMPORT ( ) button ROTATE ( ) button DELETE ( ) button About descriptions in this manual The operations described in this manual are based on those with the buttons on the photo frame. When an operation is per
Summary of the content on the page No. 10
Let’s get the photo frame ready P Notes Remote control (DPF-A710 only) � If the remote control stops working: Replace the battery (CR2025 Pull out the protective sheet before use as shown in the lithium battery) with a new one. � When the lithium battery becomes figure. weak, the operating distance of the remote control may shorten, or the remote control may not function properly. In this case, replace the Protective sheet battery with a Sony CR2025 lithium battery. Use of another batt
Summary of the content on the page No. 11
Let’s get the photo frame ready To display the photo frame on the wall PNotes � Use screws suitable for the quality of the material of the wall. The 1 Prepare screws (not supplied) suitable for the screw screws may be damaged, depending on the type of material holes on the rear panel. used in the wall. Set the screws in a pillar or stud in the wall. 3 4 mm ( /16 inch) � When you want to re-insert the memory card, remove the photo frame from the wall, then eject and More than 25 mm (1 in
Summary of the content on the page No. 12
PNotes Turning the photo frame on � The socket outlet should be as close as possible to the unit, and easily accessible. � Do not place the photo frame on an 1 Insert the plug of the AC adaptor into the DC IN 5 V unsteady or tilted surface. jack on the rear of the photo frame. � Connect the AC adaptor to an easily accessible wall outlet close by. If 2 Connect the AC adaptor to the wall outlet. trouble occurs while using the The photo frame is automatically turned on. adaptor, immediately
Summary of the content on the page No. 13
Let’s get the photo frame ready Operations in an initial state zTips When the photo frame is turned on, the initial display appears. x If the photo frame is not operated If the photo frame is not operated for 10 seconds, the demo mode is displayed. x Releasing the demonstration mode If any other button than the power button is pressed, the screen returns to the initial display. Setting the current time P Tip The B/b buttons become activated 1 Press MENU, and B/b to select the (Settings
Summary of the content on the page No. 14
Let’s view an image PNote Inserting a memory card When using a memory card of the following types, make sure to insert it in an appropriate adaptor. Insert a memory card firmly into the corresponding slot If you insert it without an adaptor, with its label side facing toward you (when you are facing you may be unable to remove it. As shown in the right-most illustration the back side of the photo frame). below, make sure to insert the following types of memory cards with inserted in the
Summary of the content on the page No. 15
Let’s view an image Changing the display 1 Press VIEW MODE repeatedly to select the view mode you want to display. PNote If you do not operate the photo frame for a certain period of time, The display changes to the selected view mode. the style indicated by the cursor is automatically selected. Using the remote control (DPF-A710 only) Press the VIEW MODE button corresponding to the view z Tip mode you want to display. Style descriptions: CD-ROM (Handbook) page 15 VIEW MODE buttons to page
Summary of the content on the page No. 16
4Setting information About the information displayed Icons Meaning on the LCD screen Protect indication Associated file indication (Displayed when there is an associated file such as a motion file or a miniature e-mail image file.) 5Image number (folder-file number) This is displayed if the image is DCF compliant. If the image does not comply with DCF, its file name is displayed. The following information is displayed. If you named or renamed the file on your 1Display type (In the Single
Summary of the content on the page No. 17
Try using various functions Try using various functions z Tips Various functions x Importing The number of images to be saved in the internal memory: � Importing an image (a memory card b the internal � Resize: approx. 250 images memory) � Original: the number of images � Exporting an image (the internal memory b may vary, depending on the original image file size. a memory card) x Exporting � Deleting an image Any memory card that is not recognized by this photo frame is shown in gray and
Summary of the content on the page No. 18
Specifying the playback device z Tips x What is “playback 1 Press MENU then select the (Select device) tab device”? with B/b. A memory card or the internal memory. x Using the remote control (DPF-A710 only) Press SELECT DEVICE. P Note During Clock and calendar display, you cannot select the (Select device) tab. Using the remote control (DPF-A710 only) Press SELECT DEVICE. 2 Press v/V to select the device you want to display and press ENTER. Adjusting image size and orientation (Zoom in
Summary of the content on the page No. 19
Try using various functions Rotating 1 Press MENU, B/b to select the (Editing) tab, P Note v/V to select [Rotate], and then press ENTER. An enlarged image cannot be rotated. zTip When displaying the images in the internal memory, the information used to rotate the image is retained even after the power is turned off. 2 Press v/V to select the angle of rotation and press ENTER. You select an angle of rotation from 90 degrees, 180 degrees or 270 degrees in clockwise direction. Using the r
Summary of the content on the page No. 20
3 Press v/V to select [Setup method], and then press ENTER. Then, press v/V to select [Simple] or [Auto off], and then press ENTER. [Simple] 1Press V to select [Time setting] , ENTER. 2Press v/V to select [Power-ON timer] or [Power-OFF timer] , ENTER. 3Press v/V to select [Enable] , ENTER. 4 [Auto ON time]/ [Auto OFF time] setting v/V: Set the time. AM or PM is displayed when you select [12 hours] on the time display setting. 5[Auto ON day] / [Auto OFF day] setting v/V: Add a check m
