Ikelite DS-200 user manual

Summary of the content on the page No. 1

P Pl le ea as se e R Re ea ad d
Ikelite Digital Housing
We suggest that you read this instruction booklet thoroughly
before use. If you are new to underwater photography, be sure
i n s t r u c t i o n m a n u a l
to read the General and Photo Tips sections.
#6148.11 for Canon PowerShot SX110 IS
We also suggest that you read the camera manual thoroughly
to have a full understanding of where each camera control is
located and what function each control provides.
P Pl le ea as se e R Re ea ad d I

Summary of the content on the page No. 2

- - I In ns st ta al ll li in ng g t th he e C Ca am me er ra a C Cl lo os si in ng g t th he e H Ho ou us si in ng g housing back 1. Pull out on each housing control until it stops. This will get the 1. Place housing face down in your controls out of the way for installing the camera. lap or on flat surface. 2. Remove the back from the housing. The mounting tray for the 2. Check to see that there is an camera is secured to the housing back. Position the camera on o-ring on the housing back an

Summary of the content on the page No. 3

SUBSTROBE w/Lite D DSS 160 Guage Full 3 2 -2 Fuel Off TTL Ready Light D Di if ff fu us se er r O Op pt ti io on na al l A Ac cc ce es ss so or ri ie es s The diffuser should be installed when using the camera’s built in flash. When shooting with the camera’s built-in flash at D DS S D Di ig gi it ta al l S St tr ro ob be es s approximately 2 feet (0.6 m) or less, the lens port on the For the best underwater photographic results, we recommend housing may block a portion of the light from the ca

Summary of the content on the page No. 4

O Op pt ti io on na al l A Ac cc ce es ss so or ri ie es s ( (c co on nt t. .) ) M Ma ai in nt te en na an nc ce e The Ikelite Digital Housing should be given the same care and B Ba ac ck k o o- -r ri in ng g # #0 01 11 10 0 attention as your other photographic equipment. In addition to O-rings last for several years if properly maintained. (See normal maintenance, we recommend that the housing be returned maintenance section). Always carry a spare o-ring in case the to Ikelite periodically to b

Summary of the content on the page No. 5

lubricate shaft P Ph ho ot to o T Ti ip ps s 1. The number one rule in underwater photography is eliminate housing as much water between camera and subject as possible. Get as close as you can to the subject, then use the zoom. If you are using flash, subjects beyond 6 feet (1.8m)will not have pull out to expose shaft much color. 2. The camera’s built-in flash is very close to the camera lens. The flash can light up any suspended particles in the water and they Diagram B can be recorded in your