Summary of the content on the page No. 2
HV-32/28P40BJ / LCT1687-001A-U / English HV-32&28P40BJ_Eng.book Page 2 Thursday, July 29, 2004 9:25 AM Warning DO NOT cut off the mains plug from this As these colours may not correspond with the equipment. If the plug fitted is not suitable coloured marking identifying the terminals in for the power points in your home or the cable your plug proceed as follows: is too short to reach a power point, then obtain The wire which is coloured blue must be an appropriate safety approved extensi
Summary of the content on the page No. 3
HV-32/28P40BJ / LCT1687-001A-U / English HV-32&28P40BJ_Eng.book Page 1 Thursday, July 29, 2004 9:25 AM How to move the TV When moving the TV, make sure that it is held by two people as shown in the illustration. Be careful not to trap your hands when putting the TV down. 1 2 3 1
Summary of the content on the page No. 4
HV-32/28P40BJ / LCT1687-001A-U / English HV-32&28P40BJ_Eng.book Page 2 Thursday, July 29, 2004 9:25 AM Thank you for buying this JVC colour television. To make sure you understand how to use your new TV, please read this manual thoroughly before you begin. WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CAUTION: • Operate only from the power source specified (AC 220 – 240 V, 50 Hz) on the unit. • Avoid damaging the AC plug and power cord. • When y
Summary of the content on the page No. 5
HV-32/28P40BJ / LCT1687-001A-U / English Safety_Eng.fm Page 3 Thursday, July 29, 2004 5:31 PM To enjoy even better picture quality The picture quality of this TV is controlled by a combination of three functions (PICTURE MODE, DIGITAL VNR, and Super DigiPure). By adjusting these three functions, you can change the picture quality to suit your preferences. The initial settings of the three functions are as follows. PICTURE MODE : BRIGHT DIGITAL VNR : AUTO(LOW) Super DigiPure : AUTO If you w
Summary of the content on the page No. 6
HV-32/28P40BJ / LCT1687-001A-U / English HV-32&28P40BJ_Eng.book Page 4 Thursday, July 29, 2004 9:25 AM CONTENTS Setting up your TV ...................................5 PICTURE menu ...................................... 25 Connecting the aerial and video cassette PICTURE MODE...................................... 25 recorder (VCR)....................................... 5 CONTRAST ............................................. 25 Connecting the power cord to the AC BRIGHT.......................
Summary of the content on the page No. 7
HV-32/28P40BJ / LCT1687-001A-U / English HV-32&28P40BJ_Eng.book Page 5 Thursday, July 29, 2004 9:25 AM Setting up your TV Caution • Turn off all the equipment including the TV before connecting anything. Connecting the aerial and video cassette recorder (VCR) • The connecting cables are not provided. • For further details, refer to the manuals provided with the devices to be connected. If you are connecting a VCR, For example follow A → B → C in the diagram Aerial opposite. 75-ohm If you
Summary of the content on the page No. 8
HV-32/28P40BJ / LCT1687-001A-U / English HV-32&28P40BJ_Eng.book Page 6 Thursday, July 29, 2004 9:25 AM Setting up your TV Connecting the power cord to Initial settings the AC outlet When the TV is first turned on, it goes into the initial settings mode, and you will see the Caution JVC logo. Follow the instructions on the • Operate only from the power source screen display to make the initial settings. specified (AC 220 – 240 V, 50 Hz) on the unit. Yellow button • Failure to use the supp
Summary of the content on the page No. 9
HV-32/28P40BJ / LCT1687-001A-U / English HV-32&28P40BJ_Eng.book Page 7 Thursday, July 29, 2004 9:25 AM Setting up your TV 2 Press the a button 5 Press the blue button to start the AUTO PROGRAM function The LANGUAGE menu appears. The AUTO PROGRAM menu appears > LANGUAGE and received TV channels are automatically stored in the programme numbers (PR). >> AUTO PROGRAM CH 28 14% OK D0002(E)-EN OK 3 Press the 6 buttons to choose D0004-EN ENGLISH. Then press the a • Perform the “ACI function”
Summary of the content on the page No. 10
HV-32/28P40BJ / LCT1687-001A-U / English HV-32&28P40BJ_Eng.book Page 8 Thursday, July 29, 2004 9:25 AM Setting up your TV • The AUTO PROGRAM function does not 6 Press the a button to display the set the programme number PR 0 (AV) for T-V LINK menu your video cassette recorder. You will T-V LINK need to set this using the MANUAL DOWNLOAD TV RECORDING DEVICE function. • In some areas you may get TV reception from more than one transmitter, for example different ITV regions. In this OK c
Summary of the content on the page No. 11
HV-32/28P40BJ / LCT1687-001A-U / English HV-32&28P40BJ_Eng.book Page 9 Thursday, July 29, 2004 9:25 AM Setting up your TV • If you have any questions about the items 1 Turn on the VCR in the Broadcast Selection menu or how to operate the menu, please contact your 2 Press the a button cable TV station. The data transmission begins. • If you do not want to use the ACI TV RECORDING DEVICE function, press the 6 buttons to choose TRANSFER. . . . . ACI SKIP and then press a. D0037-EN • When t
Summary of the content on the page No. 12
HV-32/28P40BJ / LCT1687-001A-U / English HV-32&28P40BJ_Eng.book Page 10 Thursday, July 29, 2004 9:25 AM Setting up your TV Direct Rec T-V LINK functions “What You See Is What You Record” You can easily record to VCR the images When you have a T-V LINK compatible that you are watching on the TV. VCR connected to the EXT-2 Terminal on the TV, it is easier to set up the VCR and to For details, read the manual for your VCR. Use your VCR controls. “DEVICE IS view videos. T-V LINK uses the fol
Summary of the content on the page No. 13
HV-32/28P40BJ / LCT1687-001A-U / English HV-32&28P40BJ_Eng.book Page 11 Thursday, July 29, 2004 9:25 AM TV buttons and functions Turn the main power on Press the A button on the TV. The power lamp lights red and your TV is in standby mode. • If the power lamp lights green, the TV is already on. To turn the main power off: Press the A button again. The power lamp goes off. Caution •The A button on the TV does not fully isolate the TV from the AC supply. If you are not going to use the TV f
Summary of the content on the page No. 14
HV-32/28P40BJ / LCT1687-001A-U / English HV-32&28P40BJ_Eng.book Page 12 Thursday, July 29, 2004 9:25 AM Remote control buttons and functions 1 Muting button 2 Number buttons 3 Information button 4c button 1 ~ 5i button 6b button ! 77 buttons 8g (Text) button 2 9p p buttons 0 VCR/DVD/Teletext control buttons -p buttons =d (Favourite) button ~# (Standby) button 3 @ ! VCR/TV/DVD switch # @G button 4 $ # Colour buttons % 5 $X (Multi) button %f/g (Freeze/Swap) button ^ 6 ^H button & &a button *b b
Summary of the content on the page No. 15
HV-32/28P40BJ / LCT1687-001A-U / English HV-32&28P40BJ_Eng.book Page 13 Thursday, July 29, 2004 9:25 AM Remote control buttons and functions • This TV set has a function which can Choose a TV channel and automatically change over the input watch images from external according to a special signal output from an external device. (The EXT-4 devices and EXT-5 terminals do not support this function.) Use the number buttons: • Since this TV is designed to make full Enter the programme numbe
Summary of the content on the page No. 16
HV-32/28P40BJ / LCT1687-001A-U / English HV-32&28P40BJ_Eng.book Page 14 Thursday, July 29, 2004 9:25 AM Remote control buttons and functions Channel number display: • The VCR sends its playback image along The channel number and channel name the aerial cable as an RF (radio frequency) (when the channel name is registered) of the signal. programme you are watching or the EXT terminal number is displayed. • Also see your VCR instruction manual. Time display: The current time of the teletext
Summary of the content on the page No. 17
HV-32/28P40BJ / LCT1687-001A-U / English HV-32&28P40BJ_Eng.book Page 15 Thursday, July 29, 2004 9:25 AM Remote control buttons and functions 16:9 ZOOM: ZOOM function This zooms up the wide picture (16:9 aspect ratio) to the full screen. You can change the screen size according to the picture aspect ratio. Choose the optimum one from the following ZOOM modes. AUTO: 16:9 ZOOM SUBTITLE: When a WSS (Wide Screen Signalling) This zooms up the wide picture (16:9 aspect signal, which shows the
Summary of the content on the page No. 18
HV-32/28P40BJ / LCT1687-001A-U / English HV-32&28P40BJ_Eng.book Page 16 Thursday, July 29, 2004 9:25 AM Remote control buttons and functions Adjusting the visible area of the OFF: The 3D CINEMA SOUND function switches picture off. If subtitles or the top (or bottom) of the • You can choose the 3D CINEMA picture are cut off, you can adjust the visible SOUND mode with the “SOUND menu” area of the picture manually. (see page 29). 1 Press the c button The ZOOM menu appears. Return to TV cha
Summary of the content on the page No. 19
HV-32/28P40BJ / LCT1687-001A-U / English HV-32&28P40BJ_Eng.book Page 17 Thursday, July 29, 2004 9:25 AM Remote control buttons and functions • When set to 2-pictures multi, the main- Using the “Multi-picture” picture can be changed by pressing the function p p buttons. The sub-picture screen can be changed by pressing the p buttons. 1 Press the X button When set to 12-pictures multi and The “Multi-picture” menu appears. there are more than 12 pictures, the next or previous 12 screens ca
Summary of the content on the page No. 20
HV-32/28P40BJ / LCT1687-001A-U / English HV-32&28P40BJ_Eng.book Page 18 Thursday, July 29, 2004 9:25 AM Remote control buttons and functions • When set to 2-pictures multi and the To return the “Multi-picture” to one headphones are connected, the sound screen: for the main-picture is output from the Press the X button, press the 5 TV speakers and the sound from the buttons to choose one screen, and then sub-picture is output from the press the a button. headphones. • Pressing the b button
Summary of the content on the page No. 1
HV-32/28P40BJ / LCT1687-001A-U / All Cover
HV-32&28P40BJ_Eng.book Page 1 Thursday, July 29, 2004 9:25 AM
HV-32P40BJ
HV-28P40BJ
INSTRUCTIONS
COLOUR TELEVISION
Cover01
