Summary of the content on the page No. 1
4-205-744-64
R
420574464
Trinitron Colour
Television
GB
Operating Instructions
KV-28FX65 U
KV-32FX65 U
© 2000 Sony Corporation
Summary of the content on the page No. 2
NOTICE FOR CUSTOMERS IN THE UNITED KINGDOM A moulded plug complying with BS1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a 13 AMP fuse approved by ASA ASTA or BSI to BS 1362 (i.e. marked with T or ) must be used. When an alternative type of plug is used it should be fitted with a 13 AMP FUSE, other- wise the circuit should be protected by a 13 AMP FUSE at the distribution board. If the plug supplied with this equipme
Summary of the content on the page No. 3
GB 1
Summary of the content on the page No. 4
Safety Information For your safety This set is to operate on a 220-240V AC supply For environmental and safety reasons, it is Never push objects of any kind into the set as only. Take care not to connect too many recommended that the TV set is not left in this could result in a fire or electric shock. Never appliances to the same power socket as this could standby mode when not in use. Disconnect spill liquid of any kind on the set. If any liquid or result in fire or electric shock. from the mai
Summary of the content on the page No. 5
Table of Contents . Table of Contents Installation 1. Checking the accessories supplied 4 2. Inserting batteries into the remote control 4 3. Connecting the TV 5 4. Switching on the TV 6 5. Tuning your TV 7 6. Finding your video channel 7 Operation Overview of the TV set buttons 8 Overview of the remote control buttons 9 NexTView 10 Teletext 12 Using the TV menu system 14 Adjusting the picture and sound 14 Using the Features menu 16 Re-arranging the TV channels 17 Manually tuning the TV 17 Nam
Summary of the content on the page No. 6
Installation Follow steps 1-6 to install the TV and view TV programmes. 1. Checking the accessories supplied - + + - Batteries Remote control 2. Inserting batteries into the remote control Always observe the correct polarity when inserting batteries. Always remember to dispose of used batteries in an environmentally friendly way. 4
Summary of the content on the page No. 7
Installation 3. Connecting the TV Connecting an aerial to your TV If you are not connecting your TV to a VCR, please connect the aerial lead (as shown left) and proceed to section ‘4. Switching on the TV’. If you are connecting your TV to a VCR please refer to the section below. 1. Connect your existing aerial lead to the socket marked on the rear of the TV set. Connecting an aerial and VCR to your TV The scart lead is optional. If it can be used however, this additional connection can improve
Summary of the content on the page No. 8
Installation 4. Switching on the TV I I/O 1. Connect the TV plug to the mains socket (220-240V AC, 50Hz). 2. Push in the on/off button on the front of the TV. If the standby mode indicator on the front of the TV is lit, press the TV button on / the remote control to switch on the TV set. Please be patient as the picture may take a few moments to appear on the TV screen. 6
Summary of the content on the page No. 9
Installation 5. Tuning your TV Before you tune your TV, you will be asked to set your language and country. 1. The Language/Country menu appears on the TV screen with the Language country word ‘English’ highlighted. Language Čeština Dansk Country Deutsch English Español 2. Press the v or V buttons on the remote control to select your Français Italiano chosen language then press the OK button to confirm. Select Language: Confirm: 1 2 3 3. Press v or V to select the country in which you wish to
Summary of the content on the page No. 10
Advanced Digital 100Hz Plus p - + s 4 4 MONO L/ G/ S/I 4 R/ D/ D/ D p - + s 4 4 MONO L/G/S/I 4 R/D/D/D Operation Overview of the TV set buttons Press the door flap as shown. The control panel appears. Programme Up (+) or Down (-) buttons. Press to select TV channels. Video input button. Press to select the input signals from VCR etc. Volume control buttons. Press to increase (+) /decrease (-) volume. Master Reset button. Press to return the picture and sound levels to factory sett
Summary of the content on the page No. 11
Operation Overview of the remote control buttons To temporarily switch off TV Press to temporarily switch off TV. Press again to switch To mute sound on from standby mode. To save energy, we recommend Press to mute TV sound. Press again to restore the switching off completely when TV is not in use. sound. NOTE: After 15-30 minutes without a TV signal and without any button being pressed, the TV switches automatically into standby mode. To reveal on screen information Press to reveal all on-scree
Summary of the content on the page No. 12
Operation NexTView* * depending on availability of service NexTView is an electronic programme guide with up to 1 week* of programme information on those channels included in the selected provider. *If the data exceeds the memory of NexTView, you will get information on less than 7 days. When looking for information you can search by theme (sports, art etc.), date or time (e.g. broadcasts between 8 p.m. and 9 p.m.). When you’ve found a programme you can go directly to this programme, use the ti
Summary of the content on the page No. 13
Operation NexTView* Individual Setting When you select there will be no personal pre-selection. lets you make your own individual selection of themes, limiting the search to the marked ones. 1. Select using v or V. Push B to enter. The menu Individual Settings is displayed. 2. Select the item you wish to mark using v or V. Confirm by pressing OK. Repeat step 2 for all the items you wish to have in your list. 3. When finished with the list, select using B and pres
Summary of the content on the page No. 14
Operation Teletext Most TV channels broadcast information via Teletext. The index page of the teletext service (usually page 100) gives you information on how to use the service. Please use a TV channel with a strong signal, otherwise there may be Teletext errors. Switching Teletext on and off 1. Select the TV channel which carries the teletext service you want to view. 2. Press the button once to get Teletext only. 3. Press twice for Mix mode. m 4. Press a third time to switch off Teletext.
Summary of the content on the page No. 15
Operation Teletext Using the Teletext menu 1. With Teletext switched on, press the MENU button on the remote control to display the menu on the TV screen. Teletext 2. Press v or V to select your chosen item on the screen then press B to display the relevant Top / Bottom / Full sub menu. Text Clear 3. To remove the Teletext menu from the screen, press the MENU button. Reveal Time Page Page Overview Top/Bottom/Full Select: Enter Menu: The Top/Bottom/Full sub menu allows you to enlarge different
Summary of the content on the page No. 16
Operation Using the TV menu system The TV consists of a menu system which is based on a series of user friendly on-screen displays and menus. These displays will help you get the most from your TV, helping you to change picture and sound settings, to alter the size of the TV picture and to rearrange the TV channels etc. Adjusting the picture and sound The picture and sound are preset at the factory. You can however adjust them to suit your own taste. 1. Press the MENU button on the remote contro
Summary of the content on the page No. 17
Using the TV menu system: Sound Control Item Effect/Operation Personal Vocal Audio Adjustment Jazz Rock Equaliser Mode Equaliser Mode V Personal Equaliser Adjustment Vocal 0 Balance Jazz Off Loudness Off Rock Space Auto Vol. Control Off Pop NICAM Dual Sound Stereo Volume v Flat (fixed setting, cannot be adjusted) NICAM Dual Sound Stereo Select Mode : Confirm: OK Equaliser adjustment You can adjust the mode selected in Equaliser mode by cutting and boosting the 5 s
Summary of the content on the page No. 18
Using the TV menu system: Using the Features menu 1. Press the MENU button on the remote control to display the menu on the TV screen. Features 2. Press the v or V buttons to select for the ‘Features’ menu then press B to enter the ‘Features’ Off Auto Format menu. On Format Correction 3. Press the v or V buttons to select the desired menu item then press B to confirm. For a description Sleep Timer Off Parental Lock Off of the menu items and their effects, see the table below. TV AV 2 Output
Summary of the content on the page No. 19
Using the TV menu system: Re-arranging the TV channels After tuning the TV, you can use this feature to change the order of the channels on the TV. Set Up Auto Tuning Programme Sorting AV Preset Manual Set Up 1. Press the MENU button on the remote control to display the menu on the TV screen. Select: Enter: 2. Press the V button to select the symbol on the menu screen then press B to enter the ‘Set Up’ Programme Sorting menu. PROG CH LABEL 1 C03 TV 5 2 C05 PRO 7 3 C07 EU-SP 4 C08 SWF 3.
Summary of the content on the page No. 20
Using the TV menu system: Naming a channel Names for channels are usually taken automatically from Teletext if available. You can however name a channel or an input video source using up to five characters (letters or numbers). 1. Press the MENU button on the remote control to display the menu on the TV screen. Manual Set Up 2. Press the V button to select the symbol on the menu screen then press B to enter the ‘Set Language/Country Manual Programme Preset Up’ menu. Further Programme Preset RGB
