Summary of the content on the page No. 1
DCX 770
Expansion Handset
OWNER'S
MANUAL
Summary of the content on the page No. 2
Welcome Congratulations on your purchase of the Uniden DCX770 handset and charger. This expansion handset is for use with the DMX7 series (e.g., DMX776, DMX778, etc.). Each main base model in this series can support up to four handsets. You can place a fully-featured cordless handset anywhere as long as there is AC power to connect the handset charging cradle. IMPORTANT The DCX770 expansion handset will not operate unless it has been registered to your main base. This manual describes how
Summary of the content on the page No. 3
Step 1: Connect the Charger Connect the AC adapter to the DC 1 IN 9V jack and to a standard 120V AC wall outlet. Set the charger on a desk or tabletop, 2 and place the handset in the charger with the keypad facing forward. Make sure the charge LED illuminates. 3 If the LED does not illuminate, check to see that the AC adapter is plugged in and that the handset makes good contact with the charger charging contacts. Use only the supplied AD-0005 AC adapter. Do not use any other AC adapte
Summary of the content on the page No. 4
Step 2: Register the Handset YOU NEED TO REGISTER THE DCX770 TO A MAIN BASE BEFORE USE! Be sure the handset battery is fully charged. 1 With the main base in standby mode (i.e., not being used), place 2 the handset in the main base to begin registration. For compatible models in the DCT6 and DCT7 series: 1)Disconnect the AC adapter. 2)While holding the following key, connect the AC Adapter: DCT646 & DCT746 models - find handset DCT6465 & DCT6485 models - intercom DCT648 models - intercom/find h
Summary of the content on the page No. 5
Using Your Expansion Handset Now that your new handset is registered, it can perform all the same functions as the handsets originally included with your phone. With your new handset, you can Transfer calls or intercom between handsets Use two handsets as 2-way radios in DirectLink mode Use two handsets as a baby/room monitor Hold 3 or 4 way conference calls (depends on the model) Access the integrated answering device or voice mail using Handset Send Text Messages between Handset
Summary of the content on the page No. 6
Select the highlighted option by pressing the center of the joystick. (You can also press the OK soft key.) Anytime the display prompts you to press OK or Enter, you can press the center of the joystick. You can go back to the previous menu at any time by pressing the BACK soft key. Using your handset with compatible DCT6 and DCT7 series phones To get more information on DCX770 handset features, down load DMX7 series owner's manual from our web site at www.uniden.com. Not all feature
Summary of the content on the page No. 7
Set Animation Displays 1)Select menu option . 2)Scroll to Animations and select. 3)To preview Animations press the VIEW soft key. 4)Press the OK soft key. Set Wallpaper Displays 1)Select menu option . 2)Scroll to Themes and select. 3)To preview wallpaper press the VIEW soft key. 4)Press the SELECT soft key. Set Keypad Lock 1)Select menu option . 2)Scroll to Keypad Lock and select. 3)Select Lock, and press the OK. You'll hear a confirmation tone, and your keypad is locked. Unlock your keypad by g
Summary of the content on the page No. 8
Creating and Editing Phonebook Entries To go to the phonebook, press the joystick to the left and press the OPTION soft key. Select New Entry. Enter the name, number, unique ring, unique display, phonebook group, and speed dial as you want. Press the center of the joystick to enter each entry and confirm the selection. When you're finished, press the DONE soft key to save this phonebook entry. Battery Information Low battery alert When the batteries are very low and need to be charged, the
Summary of the content on the page No. 9
Installing a Replacement Battery Follow the steps if you need to replace a battery. Press down on the handset battery 1 case cover (use the finger indention for a better grip) and slide the cover downward to remove. Remove the existing battery and 2 unplug the connector from the jack. Plug the battery pack connector 3 (red, black, and white wires) into the jack inside the battery compartment. (The connector notches fit into the grooves of the jack only one-way.) Match the wire colors to
Summary of the content on the page No. 10
I.C. Notice TERMINAL EQUIPMENT NOTICE: This equipment meets the applicable Industry Canada Terminal Equipment Technical Specifications. This is confirmed by the registration number. The abbreviation, IC, before the registration number signifies that registration was performed based on a Declaration of Conformity indicating that Industry Canada technical specifications were met. It does not imply that Industry Canada approved the equipment. NOTICE: The Ringer Equivalence Number (REN) for this
Summary of the content on the page No. 11
One Year Limited Warranty Important: Evidence of original purchase is required for warranty service. WARRANTOR: UNIDEN AMERICA CORPORATION (“Uniden”) ELEMENTS OF WARRANTY: Uniden warrants, for one year, to the original retail owner, this Uniden Product to be free from defects in materials and craftsmanship with only the limitations or exclusions set out below. WARRANTY DURATION: This warranty to the original user shall terminate and be of no further effect 12 months after the date of original
Summary of the content on the page No. 12
REGISTER ONLINE TODAY! THANK YOU FOR BUYING A UNIDEN PRODUCT. ©2004 Uniden America Corporation, Fort Worth, Texas. Contains additional foreign articles. Custom manufactured in China. UUZZ01888BZ FOR ACCESSORIES, GO ONLINE @ WWW.UNIDEN.COM
