Summary of the content on the page No. 1
Full Duplex Conference Phone
and Wireless Microphone System
Installation Instructions
and User’s Guide
Summary of the content on the page No. 2
TABLE OF CONTENTS SoundStation Premier Chapter 1 SoundStation Premier ......................................................1 – 1 Introduction ...................................................................................1 – 2 Checklist of Parts............................................................................1 – 2 To Ensure Better Performance........................................................1 – 2 Installing the conference phone...............................................
Summary of the content on the page No. 3
INTRODUCTION INSTALLING THE CONFERENCE PHONE Thank you for selecting the SoundStation Premier, the next generation of full duplex conference 1. Plug the long SoundStation cable from the Wall Module into the slot under the phones. It will forever change your expectations regarding voice quality. Its super sensitive SoundStation Premier console as illustrated below. hypercardioid microphones allow you to zero in on meeting participants, while its high fidelity neodymium speaker provides both clar
Summary of the content on the page No. 4
5. Place the SoundStation Premier console on a flat, stable surface in the To access digital services, such as voice mail, where only pulse dialing is available, center of the room, then press the “On/Off” button to hear a dial tone. SoundStation Premier can provide temporary tone dialing. When the phone is ON, press If you don’t hear a dial tone, you may not be connected to an analog SHIFT, then press REDIAL. The display must read TONE DIALING for this feature to be telephone line. activated. O
Summary of the content on the page No. 5
To place the call on hold or mute To program and use One-Touch dialing At any time during a phone call, press SHIFT, then press MUTE on the main keypad to place a NOTE: The main keypad does call on HOLD, or simply press HOLD on the remote keypad. This shuts off the speaker and all not enable One-Touch microphones. The display will show HOLD and all LEDs begin blinking red. dialing. When the phone is off, up to six phone numbers can be stored from the remote keypad. To program One-Touch dialing p
Summary of the content on the page No. 6
Muffled or “in a well” reception SoundStation Premier with t Speak closer to the unit so the microphones can pick up your speech. Extended Hypercardioid Microphones t Add more sound absorbency to the room. Excessive noise t Noisy equipment, such as a computer or fan, may make it difficult for you to hear the other party. Both parties should turn off any noisy equipment. t Try calling again to see if another line provides a better connection. Physical damage t If physical damage is severe enough
Summary of the content on the page No. 7
INTRODUCTION INSTALLING SOUNDSTATION PREMIER WITH EXTENDED MICROPHONES Thank you for selecting the SoundStation Premier, the next generation of full duplex conference 1. Plug the long SoundStation Premier cable from the Wall Module into the slot under the phones. It will forever change your expectations regarding voice quality. Its super sensitive SoundStation Premier console as illustrated below. hypercardioid microphones allow you to zero in on meeting participants, while its high fidelity ne
Summary of the content on the page No. 8
4. Insert the Wall Module plug into a nearby electrical outlet. The SoundStation Premier will run a brief self-test, and then you’ll hear a tone. If you don’t hear the tone, make sure the outlet is working and the power is switched on. 5. Plug the short cable from the Wall Module into a modular wall jack for a standard analog phone line. Your telephone system administrator or service technician can help you identify a standard analog phone line. A standard analog line supports fax machines, ans
Summary of the content on the page No. 9
To access digital services, such as voice mail, where only pulse dialing is available, USING THE SOUNDSTATION PREMIER WITH TWO SoundStation Premier can provide temporary tone dialing. When the phone is ON, press EXTENDED HYPERCARDIOID MICROPHONES SHIFT, then press REDIAL. The display must read TONE DIALING for this feature to be To place a call: activated. Once the phone is hung up, dialing will revert to its previous mode. Press ON/OFF to turn the SoundStation Premier console on, and dial the
Summary of the content on the page No. 10
To place the call on hold or mute To program and use One-Touch dialing At any time during a phone call, press SHIFT, then press MUTE on the main keypad to place a NOTE: The main keypad does call on HOLD, or simply press HOLD on the remote keypad. This shuts off the speaker and all not enable One-Touch microphones. The display will show HOLD and all LEDs begin blinking red. dialing. When the phone is off, up to six phone numbers can be stored from the remote keypad. To program One-Touch dialing p
Summary of the content on the page No. 11
PERMANENT INSTALLATION Lavalier Wireless Microphone System To hide cables and install permanently: 1. Locate microphones 6 to 8 feet from the SoundStation Premier console. Chapter 3 2. Drill holes in table to accommodate for thickness of cord. For the extended mircrophone, drill a 1/2" hole. For the SoundStation Premier console, drill a 5/8" hole. 3. Route cables through holes under table. SoundStation Premier Full Duplex Conference Phone and Wireless Microphone User’s Guide SoundStation Premier
Summary of the content on the page No. 12
INTRODUCTION (8) Low Battery LED (2) Softwire Antenna Thank you for choosing the SoundStation Wireless Microphone System. This system operates on a long-range, interference-free VHF high band frequency. It also utilizes a patented companding noise reduction system for excellent dynamic range (120 dB) and hiss-free performance. (7) On/Off Switch (5) Output Jack CHECKLIST OF PARTS Your SoundStation Wireless Microphone System includes the following items: (4) Signal LED (6) Power Jack (3) Mute Cont
Summary of the content on the page No. 13
LAVALIER WIRELESS TRANSMITTER SPECIFICATIONS Transmitter Operation Slide the transmitter’s battery cover open and place the included 9V battery into the Battery Compartment (4), observing the correct polarity. Turn on the transmitter by pushing the Transmitter O N / O F F Switch (2) to the O N position. The “Low Battery” LED (3) will give a single quick flash. In the case of a dead or low battery, the LED will not go on at all or will stay on continuously, indicating a battery voltage below 7V.
Summary of the content on the page No. 14
THE SOUNDSTATION Premier Full Duplex Conference THE SOUNDSTATION Premier Full Duplex Conference Specifications Audio Bandwidth 200 to 3500 Hz Extended Microphones Loudspeaker Volume 89dBSPL Dimensions: Weight: Network Interface Two-wire RJ-11 analog PBX or Public Switched Cabling: Two-wire RJ9, 8 feet Telephone Network interface Power Requirements Remote Keypad Console Dimensions: Size: Weight: Weight: Batteries: 2, A A AA l k a l i n e typical power __________ Power Supply/ Telephone Int
Summary of the content on the page No. 15
Polycom’s obligation to repair, replace, or refund, as set forth above, is your exclusive remedy. THE SOUNDSTATION Premier Full Duplex Conference Except as specifically set forth above, Polycom, its affiliates, suppliers, and dealers make no warranties, express or implied, and specifically disclaim any warranties of merchantability or fitness for a particular purpose. Wireless Microphone Limitation of Liability System Specifications Except as provided below, the liability of Polycom and its affi
Summary of the content on the page No. 16
SoundStation Premier Full Duplex Conference Phone and Wireless Microphone User’s Guide SoundStation Premier Full Duplex Conference Phone and Wireless Microphone User’s Guide
