Hotpoint G320GIX user manual

Summary of the content on the page No. 1

Cooking Hob
ELECTROGAS
Index
GB
GB
English
Instructions for use
Installation, 4
Use, 4
Maintenance, 4
Instructions for the installater
Installation, 6
Gas connection, 6
Electrical connection, 6
User characteristics, 7
Assistance, 8

THIS APPLIANCE IS CONCEIVED FOR
G320GIX
DOMESTIC USE ONLY. THE MANUFACTURER
G3201LIX
SHALL NOT IN ANY WAY BE HELD
RESPONSIBLE FOR WHATEVER INJURIES
OR DAMAGES ARE CAUSED BY INCORRECT
INSTALLATION OR BY UNSUITABLE, WRONG
OR ABSURD USE.

Dear custome

Summary of the content on the page No. 2

Instructions for use Gas Installation GB All the operations concerned with the installation (electrical and gas connections, adaptation to type of gas, necessary adjustments, etc.) must be carried out by qualified technicians, in terms with the standards in force. For specific instructions, kindly read the part reserved for the installation technician. Use Gas burners (Fig. 1-3). The ignition of the gas burner is carried out by putting a small flame to the upper part holes of the burner

Summary of the content on the page No. 3

GB Fig. 2 

Summary of the content on the page No. 4

Instructions for the installer Installation GB This appliance is not provided with a combu-stion product discharge. It is recommended that it be installed in sufficiently aerated places, in terms of the ISO 7/1 laws in force. The quantity of air which is necessary for ISO 228/1 (FR) combu-stion must not be below 2.0 m3/h for each kW of Fig. 3 installed power. See table of burner power. Positioning (Fig. 2) Electrical connection (Fig. 4) The appliance can be fitted into a working area

Summary of the content on the page No. 5

To avoid all risk, if the power cable becomes damaged, GB it must only be replaced by the manufacturer, wok C3 only by an authorised service centre, or by a qualified electrician. Adaptation to various types of gas (Fig. 5) Should the appliance be pre-set for a different type of gas than that available, proceed as follows: • replace the injectors (Fig. 5) with the corresponding type of gas to be used (see table “Uses characteristics”). • to adjust to the minimum, use a screwdriver on the

Summary of the content on the page No. 6

Assistance Before contacting After-Sales Service: GB 1. See if you can solve the problem yourself. 2. Switch the appliance on again to see if the problem has been solved. if it has not, disconnect the appliance from the power supply and wait for about an hour before switching on again. 3. If the problem persists after this course of action, contact After-Sales Service. Specify: • the nature of the fault, • the model • the service number (the number after the word SERVICE on the rating plate

Summary of the content on the page No. 7

Notes