Summary of the content on the page No. 1
BUILT-IN HOB
ZXS 646 IT
INSTRUCTION BOOKLET
UA SI HR
1
Summary of the content on the page No. 2
Important Safety Information These warnings are provided in the interest of safety. You MUST read them carefully before installing or using the appliance. cooking appliance, ensure that electric cables are not About Installation, Cleaning in contact with it and keep them far enough from the and Maintenance heated parts of this appliance. • It is mandatory that all operations required for the • If the appliance is out of order, disconnect it from the installation are carried out by a qualified o
Summary of the content on the page No. 3
Contents For the Installer For the User Important Safety Information 2 Technical Data 7 Instruction for the User 3 Instruction for the Installer 7 Cleaning and Maintenance 6 Gas connection 8 European Guarantee 13 Electrical Connection 9 Adaptation to different types of gas 10 Building In 11 Possibilities for insertion 12 This appliance complies with the following E.E.C. Directives: MANUFACTURER: - 2006/95 (Low Voltage Directive); ELECTROLUX ITALIA S.p.A. - 2004/108 (Electromagnetical Compatibil
Summary of the content on the page No. 4
Using the hob correctly To ensure maximum burner efficiency, it is strongly recommended that you use only pots and pans with a bottom fitting the size of the burner used, so that flame will not spread beyond the bottom of the vessel (fig. 2 -a). It is also advisable, as soon as a liquid starts boiling, to Burner minimum maximum turn down the flame so that it will barely keep the liquid diameter diameter simmering. Use only pans or pots with flat bottom. Medium (semirapid) 120 mm. 220 mm. Small (
Summary of the content on the page No. 5
Before the First Use of the Appliance Before using the appliance remove all packaging, including the advertising labels and any protective film. When using the hob for the first time: 1) place on all the plates a pan filled with some water; 2) switch the plates on for about 10 minutes at “maximum” position until water inside the pans boils; 3) then, turn the control knob to “minumum” and allow the plates to run for approximately 20 minutes; 4) open a window for ventilation. During this time, th
Summary of the content on the page No. 6
Cleaning and Maintenance Disconnect the appliance from the electrical supply, before carrying out any cleaning or manteinance work. General cleaning Wash the enamelled components with warm soapy water. Never use abrasive cleaners Frequently wash the "caps" and the "crowns" with hot soapy water, carefully taking away any built-up of food. Regularly wipe over the hob top using a soft cloth weel wrung out in warm water to which a little liquid detergent has been added. Avoid the use of the followin
Summary of the content on the page No. 7
Technical Data Gas Burners Rating Auxiliary Burner 1 kW Semirapid Burner 2 kW Appliance Class 3 Category II 2H3B/P Setting LPG G30/G31 30/37 mbar Gas connection G 1/2" Electric hotplates Small hotplate Ø 145 mm. 1000 W Large hotplate Ø 180 mm. 2000 W Electric Supply 230 V ~ 50 Hz Hob recess dimensions Length 550 mm. Width 470 mm. Instruction for the Installer The following instructions about installation and maintenance must be carried out by qualified personnel in compliance with
Summary of the content on the page No. 8
Gas connection Choose fixed connections or use a flexible pipe in stainless steel in compliance with the regulation in force. If using flexible metallic pipes, be careful they do not come in contact with mobile parts or they are not squeezed. Use the same attention when the hob is combinated with an oven. IMPORTANT - To ensure a correct operation, a saving of energy and the long-life of the appliance, the voltage pressure of the appliance must correspond to the recommended values. The adjustab
Summary of the content on the page No. 9
Electrical Connection The following instructions about installation RIGID COPPER PIPE OR must be carried out by qualified personnel in FLEXIBLE PIPE IN STAINLESS compliance with the regulation in force. STEEL YES The appliance is designed to be connected to 230 V monophase electricity supply. The connection must be carried out in compliance with the laws and regulations in force. Before the appliance is connected: 1) check that the main fuse and the domestic installation can support the load (se
Summary of the content on the page No. 10
Adaptation to different types of gas Injectors replacement • Remove the pan supports. • Remove the burner's caps and crowns. • With a socket spanner 7 unscrew and remove the injectors (Fig. 7), and replace them with the ones required for the type of gas in use (see table 2). • Reassemble the parts, following the same procedu- re backwards. • Replace the rating label (placed near the gas supply pipe) with the relevant one for the new type of gas supply. You can find this label in the package of
Summary of the content on the page No. 11
580 PE Building In PE SR These hobs can be inserted in a built-in kitchen unit whose depth is between 550 and 600 mm. The hobs dimensions are shown in the relevant diagram. The edge of the cut out must have a minimum distance A from the rear wall of 55 mm. If there are side walls, or sides of the furniture unit near the hob, the cut out edges must have a minimum distance of 100 mm. Hanging furniture units or hoods must be placed at 650 mm. minimum from the hob. A = Auxiliary burner Dimensions ar
Summary of the content on the page No. 12
Possibilities for insertion Kitchen unit with door Kitchen unit with oven Proper arrangements must be taken in designing the The hob recess dimensions must comply the indication furniture unit, in order to avoid any contact with the given in Figs. 13 and 14 and must be provided with bottom of the hob which can be heated when it is brackets to allow a continuous supply of air. operated. The recommended solution is shown in Fig. To avoid overhating, the building in should be carried out 12. as sho
Summary of the content on the page No. 13
European Guarantee This appliance is guaranteed by Electrolux in each of the countries listed at the back of this user manual, for the period specified in the appliance guarantee or otherwise by law. If you move from one of these countries to another of the countries listed below the appliance guarantee will move with you subject to the following qualifications:- · The appliance guarantee starts from the date you first purchased the appliance which will be evidenced by production of a valid pur
Summary of the content on the page No. 14
14
Summary of the content on the page No. 15
15
Summary of the content on the page No. 16
35675-9104 R.B 05/09
