Summary of the content on the page No. 1
INSTALLATION, MAINTENANCE AND USE
INSTRUCTIONS FOR
FREE-STANDING COOKERS
90x60 cm (type M91/M91V)
Model X906MFE* , X906 DUAL*,
X906GEV*
READ THE INSTRUCTION BOOKLET BEFORE INSTALLING AND USING
THE APPLIANCE.
The manufacturer will not be responsible for any damage to property or to persons
caused by incorrect installation or improper use of the appliance.
The manufacturer is not responsible for any inaccuracies, due to
Summary of the content on the page No. 2
CONTENTS: INSTALLER TECHNICAL MANUAL ............................................................................................................... pg. 2 Installing the cooker - Installation information ................................................................................................. pg. 2 Ventilation and aeration of rooms .................................................................................................................... pg. 3 Backguard installation instruct
Summary of the content on the page No. 3
I MPORTANT INFORMATION FOR INSTALLING THE APPLIANCE The cooker can be installed separately, as a freestanding unit, on a plinth (Not suitable for X90 6 GEV* and X90 6 DUAL* models), or between kitchen units or between a kitchen unit and the wall. If installing the appliance as a freestanding cooker, screw the height adjustable telescopic legs supplied to the base of the appliance. If installing the appliance on a plinth, screw the levelling feet supplied to the base of the appliance.
Summary of the content on the page No. 4
This appliance shall be installed only by authorised persons and in accordance with the manufacturer's installation instructions, local gas fitting regulations, municipal building codes, electrical wiring regulations, local water supply regulations, AS/NZS 5601.1-2010-Gas Installations–General installations and any other statutory regulations. WARNING: It should be recalled that the appliance utilises a threaded 1/2" gas cylindrical male fitting according to UNI-ISO 228-1. For ease of se
Summary of the content on the page No. 5
WARNING: After completing the above-mentioned replacements, the technician must adjust the burners, as described in the paragraph below, seal any adjustment and pre-adjustment devices and apply the label on the appliance, to replace the existing one, corresponding to the new gas adjustment. This label is contained in the spare nozzle bag. TABLE N°1: Adaption to various types of gas Burner Types of Gas Pressure Nozzle Hourly Gas Diameter Consumption kPa mm. (MJ) Auxiliary NG 1.0 0.
Summary of the content on the page No. 6
WARNING: If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard. For New Zealand - This cooking range must be connected to the supply by a supply cord fitted with an appropriately rated plug that is compatible with the socket-outlet fitted to the final sub-circuit in the fixed wiring that is intended to supply this cooking range. TABLE N°3 : TYPES OF POWER CORDS Work surface operation Oven ope
Summary of the content on the page No. 7
To replace the power cable, lift the terminal board’s cover and replace the cable. To access the terminal board in cookers with a 3x2.5mm² cable, the back panel on the rear of the appliance must be removed. USE AND MAINTENANCE MANUAL WARNING: This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the applian
Summary of the content on the page No. 8
Note: It is recommended not to try to ignite a burner if the relative flame cap is not in the correct position. If the flame does not light after the first attempt, wait 5 minutes for the gas to dissipate before attempting to re-light the burner. Tips for using burners correctly: - Use suitable pots for each burner (see tab. 4 and Fig. 25). - When the liquid is boiling, turn the knob to the MINIMUM position (small flame Fig. 23). - Always use pots with a cover. TABLE N°5 BURNE
Summary of the content on the page No. 9
then release the knob. Make sure that the burner remains on, otherwise repeat the operation. As for cookers without ignition trough knob, press the thermostat knob and the key with the spark symbol, wait about 10 seconds after the burner has been completely lit and then release the knob. Make sure that the burner remains on, otherwise repeat the operation. The ignition device should not be used for more than 15 seconds. If after that period the burner still has not been lit, do not use the
Summary of the content on the page No. 10
- the symbol indicates that the electric fan, and the oven light have been turned on . - the symbol indicates that only the oven light is turned on; USING THE 5 + 0 SWITCH ( only cooker with Dual Enrgy oven) The 5 + 0 switch installed in the Dual Energy oven models is used, along with the electric or gas thermostat. To control the electric fan and the oven elements since they can be turned on by turning the 5 + 0 switch knob and the thermostat knob. Turning just one of the two kno
Summary of the content on the page No. 11
- the symbol indicates that only the top external element (1200W) has been turned on; - the symbol indicates the only the bottom element (1800W) has been turned on; - the symbol indicates that only the grill element (1800W) has been turned on; - the symbol indicates that the top external element (1200W) and the grill element (1800W) have been turned on; - the symbol indicates that the top external element (1200W), the grill element (1800W) and the electric fan have been turned on; - t
Summary of the content on the page No. 12
Before cooking, allow the oven to reach the desired temperature setting waiting for the orange light to turn off. This type of oven is equipped with a circular element around which a fan has been installed that creates forced-air circulation in the horizontal direction. Thanks to this type of operation, the ventilated oven can be used for different types of cooking at the same time, without changing the taste of each food. Only some models are equipped with a removable metallic filter applie
Summary of the content on the page No. 13
Grilling on the shelf: In this case, the shelf supplied is placed on level 1 or 2 and the foods to be grilled are placed on top, while the tray is inserted on the lower levels to collect the cooking juices. Then turn on the grill element switching the thermostat to the relative position (electric oven version). WARNING: Accessible parts may become hot when the grill is in use. Children should be kept away. USING THE VENTILATED ELECTRIC GRILL The ventilated electric grill is a special fun
Summary of the content on the page No. 14
AFTER-SALES TECHNICAL SERVICE AND SPARE PARTS TECHNICAL SERVICE AND SPARE PARTS Before leaving the factory, this appliance was tested and adjusted by specialist skilled staff to give the best operating results. Any subsequent necessary repairs or adjustments must be carried out with the greatest care and attention by authorised personnel. For this reason, we strongly advise you contact the Bertazzoni Service Center, specifying the nature of the problem, the model of the equipment and the
Summary of the content on the page No. 15
Fig. 1 Fig. 3 Fig. 4 Fig. 5 Fig.6 Fig.7 15
Summary of the content on the page No. 16
Fig.8 Fig.9 Fig.10 Fig.11 Fig 12 Fig 13 Fig. 14 16
Summary of the content on the page No. 17
Fig 15 Fig. 16 Fig. 17 T Fig. 18 Fig. 19 Fig. 20 Fig. 21 Fig. 22 Fig. 23 Fig. 24 Fig. 25 17
Summary of the content on the page No. 18
Fig. 26 Fig. 27 Fig.28a Fig.28b Fig.28c Fig.28d 18
Summary of the content on the page No. 19
Fig. 29 Fig. 30 Fig. 31 Fig. 32 19
Summary of the content on the page No. 20
OVERALL DIMENSIONS Cod. 310686 20
