Summary of the content on the page No. 1
Operating Instructions
HOB
Contents
GB
Installation, 2-5
Positioning
GB
Gas connection
Data plate
English,1
Burner and nozzle specifications
Electrical connection,6
Description of the appliance, 7
Overall view
Start-up and use, 8-9
Practical advice on using the burners
Precautions and tips, 10
General safety
Disposal
GF750TX
Recycling & Disposal Information
GF761RFX
Maintenance and care, 11
Switching the appliance off
Cleaning the appliance
Gas tap maintenance
Troubleshooting, 12
Guarantee, 13
A
Summary of the content on the page No. 2
Installation ! Before operating your new appliance please read this also be equipped with vents to allow gas to escape in the GB instruction booklet carefully. It contains important information event of a leak. As a result LPG cylinders, whether for safe use, installation and care of the appliance. partially or completely full, must not be installed or stored in rooms or storage areas that are below ground level ! Please keep these operating instructions for future (cellars, etc.). It is advisab
Summary of the content on the page No. 3
45 mm. Front There is an adjustable L L L L L-shaped pipe fitting on the GB appliance supply ramp and this is fitted with a seal in order to prevent leaks. The seal must always be replaced after rotating the pipe fitting (seal provided with appliance). The gas supply pipe fitting is a threaded 1/2 gas cylindrical male attachment. Connecting a flexible jointless stainless steel pipe to a threaded attachment The gas supply pipe fitting is a threaded 1/2 gas Hooking position Back cylindrical male a
Summary of the content on the page No. 4
Replacing the nozzles on separate “double flame “ 3. Having adjusted the flame to the required low setting, GB burners: while the burner is alight, quickly change the position of the knob from minimum to maximum and vice versa 1. remove the grids and slide the burners from their several times, checking that the flame does not go out. housings. The burner consists of 2 separate parts (see figure); 4. Some appliances have a safety device (thermocouple) fitted. If the device fails to work when the
Summary of the content on the page No. 5
Burner and nozzle specifications GB Table 1 Liquid Gas Natural Gas Burner Diameter Thermal Thermal By-Pass Nozzle Flow* Thermal Nozzle Flow* (mm) power power 1/100 1/100 g/h power 1/100 l/h kW kW kW (p.c.s.* (p.c.s.*) (p.c.s.*) Ridot. Nomin. (mm) (mm) *** ** Nomin. (mm) Reduced Fast (RR) 100 0.70 2.60 39 80 189 186 2.60 110 (Y) 248 Semi Fast (S) 75 0.40 1.90 28 70 138 136 1.90 106 181 Auxiliary (A) 55 0.40 1.00 28 50 73 71 1.00 79 95 Triple Crown (TC) 130 1.50 3.30 61 91 240 236 3.60 145 (H1) 34
Summary of the content on the page No. 6
Electrical Connection Power supply voltage and frequency: 220-240V a.c. rating of 45 amp. In this case the cable is not GB 50/60Hz. supplied. Disposing of the plug ! The supply cable must be positioned so that it Ensure that before disposing of the plug itself, you never reaches at any point a temperature 50°C make the pins unusable so that it cannot be higher than the room temperature. The cable must accidentally inserted into a socket. Instructions for be routed away from the rear vents. Shoul
Summary of the content on the page No. 7
Description of the appliance Overall view GB GAS BURNERS Support Grid for COOKWARE Control Knobs for GAS BURNERS SAFETY DEVICES * Ignition for GAS BURNERS * • GAS BURNER ignition* enables a specific burner • GAS BURNERS differ in size and power. Use the to be lit automatically. diameter of the cookware to choose the most appropriate burner to cook with. • SAFETY DEVICE* stops the gas flow if the flame is accidentally extinguished. • Control Knobs for GAS BURNERS adjust the power or the size of t
Summary of the content on the page No. 8
Start-up and use ! The position of the corresponding gas burner or To turn on one of the rings, press the relative knob in GB electric hotplate* is shown on every knob. all the way and turn it anti-clockwise to the high setting . The burner is fitted with an electronic Gas burners igniter that automatically starts when the knob is Each burner can be adjusted to one of the following pressed in. settings using the corresponding control knob: Since the burner is equipped with a safety device, Since
Summary of the content on the page No. 9
Practical Advice on Using the Half Fish-Kettle GB Burner * The two "Half Fish-Kettle" burners, are eliptic in form and can be turned up to 90°. This makes the cooktop more flexible in terms of how it can be used. To turn the two burners 90°, proceed as follows: • Make sure that the burners are cool; • Lift the burner completely out of its housing; • Replace it in its housing in the position desired; • Make sure that the burners are positioned correctly before use. In addition, the two burners ca
Summary of the content on the page No. 10
Precautions and tips ! This appliance has been designed and manufactured in • Prevent children and the disabled from coming into contact or GB compliance with international safety standards. The following having access at the ceramic glass cooking surface (if warnings are provided for safety reasons and must be read present) immediately before and after use, as the cooking carefully. surface will remain hot for at least a half hour after being turned off; General safety • Contact service centers
Summary of the content on the page No. 11
Maintenance and care Switching the appliance off Gas tap maintenance GB Disconnect your appliance from the electricity supply Over time, the taps may become jammed or difficult to before carrying out any work on it. turn. If this happens, the tap must be replaced. ! This procedure must be performed by a qualified Cleaning the appliance technician authorised by the manufacturer. ! Do not use abrasive or corrosive detergents such as stain removers, anti-rust products, powder detergents or sponges
Summary of the content on the page No. 12
Troubleshooting It may happen that the appliance does not function properly or at all. Before calling the service centre for GB assistance, check if anything can be done. First, check to see that there are no interruptions in the gas and electrical supplies, and, in particular, that the gas valves for the mains are open. Problem Possible causes/Solution The burner does not light or the flame is not • The gas holes on the burner are clogged. even around the burner. • All the movable parts that ma
Summary of the content on the page No. 13
Guarantee 12 months Parts and Labour Guarantee Your appliance has the benefit of our manufacturer’s guarantee, which covers the cost of breakdown repairs for twelve months from the date of purchase. This gives you the reassurance that if, within that time, your appliance is proven to be defective because of either workmanship or materials, we will, at our discretion, either repair or replace the appliance at no cost to you. This guarantee is subject to the following conditions: - The appliance h
Summary of the content on the page No. 14
After Sales Service No one is better placed to care for your Hotpoint appliance during the course of its working life than us – the manufacturer. Essential Contact Information Hotpoint Service We are the largest service team in the country offering you access to 400 skilled telephone advisors and 1000 fully qualified engineers on call to ensure you receive fast, reliable, local service. UK: 08448 224 224 Republic of Ireland: 0818 313 413 www.hotpointservice.co.uk Please note: Our advisors will r
Summary of the content on the page No. 15
Notes GB 15
Summary of the content on the page No. 16
Notes 06/2010 - 195084552.00 XEROX FABRIANO GB 16
