ページ1に含まれる内容の要旨
P3PC-E387-01XA
fi-486PRRE Imprinter
Operator’s Guide
Operator’s Guide
English
Japanese
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
fi-486PRRE Imprinter Operator’s Guide Operator’s Guide English
ページ4に含まれる内容の要旨
ページ5に含まれる内容の要旨
INTRODUCTION Thank you for purchasing the fi-486PRRE Imprinter. The fi-486PRRE is the fi-4860C image scanner option. The fi-486PRFR and the fi-486PRRE can be installed in the fi-4860C image scanner together.However, they cannot be used at a time.Either fi-486PRRE or fi-486PRFR can be used during scanning. The fi-486PRRE installation should be done by a trained service engi- ATTENTION neer. fi-486PRRE The fi-486PRRE prints on the front side of documents. Printing is done prior to scanning a d
ページ6に含まれる内容の要旨
6. ERROR MESSAGES This chapter explains the error messages and the recovery process. 7. SPECIFICATIONS This chapter describes the specifications of the fi-486PRRE imprinter option. This manual provides necessary information to make the best use of the fi-486PRRE. August, 2002 ii
ページ7に含まれる内容の要旨
Revisions FCC declaration This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to
ページ8に含まれる内容の要旨
International ENERGY STAR® Program As an ENERGY STAR® Partner, PFU LIMITED has determined that this product meets the ENERGY STAR® guidelines for energy efficiency. The International ENERGY STAR® Office Equipment Program is an international program that promotes energy saving through the penetration of energy efficient computers and other office equipment. The program backs the development and dissemination of products with functions that effectively reduce energy consumption. It is an ope
ページ9に含まれる内容の要旨
Preface Safety Precautions This manual describes important details for ensuring the safe and correct use of this product. Thoroughly read this manual before you start to use this product. In particular, be sure to read and fully understand the Safety Precautions described in this manual before you use this product. Also, store this manual in a safe place so that it can be easily referred to during use of this product. Warning Indications Used In This Manual This manual uses the follo
ページ10に含まれる内容の要旨
Symbols Used In This Manual This manual uses the following symbols in explanations in addition to warning indications. This symbol alerts operators to particularly important information. ATTENTION Be sure to read this information. This symbol alerts operators to helpful advice regarding opera- HINT tion. A TRIANGLE symbol indicates that special care and attention is required. The drawing inside the triangle shows the specific caution. A CIRCLE with a diagonal line inside shows action which u
ページ11に含まれる内容の要旨
Safety Precautions WARNING The following describes important warnings described in this manual. Do not install in locations subject to oil smoke, steam, humidity, and dust. Do not install the scanner in locations subject to oil smoke, steam, humidity, and dust. Doing so might cause fire or electric shock. Do not use the scanner if you smell strange odor. If you sense heat coming from devices or detect other malfunctions such as smoke, strange smells or strange noises, immediately press
ページ12に含まれる内容の要旨
Do not allow liquids to get inside the scanner. Do not insert or drop foreign metal objects in to the scanner. Do not scan wet document or document with paper clips. Do not splash or allow the scanner to get wet. If foreign objects (water, small metal objects, liquids, etc.) get inside the scanner, immediately press down the power button to turn off the scanner and disconnect the power plug from the power outlet. Then contact the agent where you bought the scanner or Mainte- nance Service Cent
ページ13に含まれる内容の要旨
CAUTION The following describes important cautions described in this manual. Protect the scanner from static electricity. Install the scanner away from strong magnetic fields and other sources of noise. Also, protect the scanner from static electricity as this might cause the scanner to malfunction. Do not use aerosol sprays near the scanner. Do not use aerosol sprays, for example, to clean the scanner. Air sprayed from aerosol sprays causes dirt and dust to enter the scanner, resulting sca
ページ14に含まれる内容の要旨
Fujitsu Group Offices Please send your comments on this manual or on Fujitsu products to the following addresses: FUJITSU COMPUTER PRODUCTS OF FUJITSU CANADA, INC. AMERICA, INC. 2800 Matheson Boulevard East, 2904 Orchard Parkway, San Jose, CA Mississauga, Ontario L4W 4X5, Canada 95134-2009, U.S.A. Phone: (1-905)602-5454 Phone: (1-800)591-5924; Fax: (1-905)602-5457 (1-408)432-6333 Website: http://www.fujitsu.ca/ Technical Assistance Center: E-mail: imaging@fujitsu.ca (1-800)626-4686 (
ページ15に含まれる内容の要旨
FUJITSU TAIWAN LTD. FUJITSU HONG KONG LTD. 19th Fl., No39, Sec.1,Chung-hwa Rd., 10/F., Lincoln House, 979 King's Road, Taipei, Taiwan R.O.C. Taikoo Place, Island East, Hong Kong Phone: (886-2)2311-2255 Phone: (852)2827-5780 Fax: (886-2)2311-2277 Fax: (852)2827-4724 Website: http://fw.fujitsu.com/ Website: http://hk.fujitsu.com/ E-mail: scanner@fujitsu.com.hk FUJITSU SYSTEMS BUSINESS FUJITSU KOREA LTD. (THAILAND) LTD. 5-11 Fl., Coryo Finance Center Building, 12th Fl., Olympia Thai Tower, 444 Yo
ページ16に含まれる内容の要旨
Screen Examples In This Manual The screen examples in this manual are subject to change without notice in the interest of product improvement. If the actual displayed screen differs from the screen examples in this manual, operate by following the actual displayed screen referring to the User's Manual of the scanner application you are using. Furthermore, the screenshots in this manual are for the FUJITSU TWAIN32 scanner driver and the Image Capturing Software Utilities "ScandAll 21" for ®
ページ17に含まれる内容の要旨
CONTENTS 1 PREPARATIONS ...........................................1 Checking the Contents of the Imprinter Package ..............................2 Outer View .........................................................................................3 2 BASIC OPERATIONS ...................................5 Installing the Print Cartridge ..............................................................6 Adjusting Print Position ......................................................................8
ページ18に含まれる内容の要旨
xiv
ページ19に含まれる内容の要旨
1 PREPARATIONS This chapter explains how to prepare the imprinter, fi-486PRRE for use. 1.1 Checking the Contents of the Imprinter Package ..............2 1.2 Outer View..............................................................................3 1
ページ20に含まれる内容の要旨
1.1 Checking the Contents of the Imprinter Package Please confirm that all of the following parts are included in the package. If any parts are missing or defective, contact the FUJITSU Scanner dealer where you purchased the product. Handle the imprinter and the accessories with care. Imprinter and Accessories o Imprinter o Print Cartridge o Operator's Guide o Installation screws o Positioning seal o Imprinter Cover (Qty 2) o Imprinter Cable 2 1.1Checking the Contents of the Imprinter Packa
