ページ1に含まれる内容の要旨
SERVICE MANUAL ROSCO
A4 Monochrome Page Printer
EPSON EPL-6200/EPL-6200L
SEPG03002
ページ2に含まれる内容の要旨
Notice All rights reserved. No part of this manual may be reproduced, stored in a retrieval system, or transmitted in any form or by any means electronic, mechanical, photocopying, or otherwise, without the prior written permission of SEIKO EPSON CORPORATION. All effort have been made to ensure the accuracy of the contents of this manual. However, should any errors be detected, SEIKO EPSON would greatly appreciate being informed of them. The contents of this manual are subject to change wi
ページ3に含まれる内容の要旨
PRECAUTIONS Precautionary notations throughout the text are categorized relative to 1)Personal injury and 2) damage to equipment. DANGER Signals a precaution which, if ignored, could result in serious or fatal personal injury. Great caution should be exercised in performing procedures preceded by DANGER Headings. WARNING Signals a precaution which, if ignored, could result in damage to equipment. The precautionary measures itemized below should always be observed when performing repair/maintena
ページ4に含まれる内容の要旨
About This Manual This manual describes basic functions, theory of electrical and mechanical operations, maintenance and repair procedures of the printer. The instructions and procedures included herein are intended for the experienced repair technicians, and attention should be given to the precautions on the preceding page. Manual Configuration Symbols Used in this Manual This manual consists of six chapters a
ページ5に含まれる内容の要旨
Safety Precautions To prevent accidents during a maintenance procedure, strictly observe the Warnings Internal Laser Radiation and Cautions and never depart from the instructions given in this document. Do not do anything that is dangerous even if not specifically described in this manual. In work operations, always take great care to ensure safety in consideration of not only Semiconductor Laser Specifications the precautions described below but also gener
ページ6に含まれる内容の要旨
Laser Safety and Caution Labels Warning labels and caution labels are affixed to this printer for accident prevention. In maintenance work, check that the labels are free from peeling and soiling. Laser safety label Laser caution label As shown below, a laser safety label is stuck on the rear panel of the printer beside As shown below, a laser caution label is stuck on the inside of the printer. the AC inlet.
ページ7に含まれる内容の要旨
Revision Status Revision Date of Issue Description A September 5, 2003 First release
ページ8に含まれる内容の要旨
EPSON EPL-6200/EPL-6200L Revision A Contents 1.3.4 Names of Parts of EPL-6200L.................................................................... 37 Chapter 1 Product Description 1.4 Controller Specification ...................................................................................... 38 1.1 Outline ................................................................................................................. 13 1.4.1 Basic Controller Specifications ..................................
ページ9に含まれる内容の要旨
EPSON EPL-6200/EPL-6200L Revision A 1.10.3 About the Moist Environment Mode Select ............................................. 60 2.2.7.2 Paper Feed Mechanism ....................................................................... 87 2.2.7.3 Paper Cassette Empty Sensor.............................................................. 88 1.11 Status Sheet ....................................................................................................... 61 2.2.7.4 Cassette Type Sensor .........
ページ10に含まれる内容の要旨
EPSON EPL-6200/EPL-6200L Revision A 3.2.15 EEPROM Error....................................................................................... 114 4.2.1 Locations of Fuses.................................................................................... 134 3.2.16 Engine Initialization Error ...................................................................... 115 4.2.2 Paper Feed Roller ..................................................................................... 134 3.2.17 Other Har
ページ11に含まれる内容の要旨
EPSON EPL-6200/EPL-6200L Revision A 4.7 Duplex Unit (Option) ........................................................................................ 163 4.7.1 Right Cover............................................................................................... 163 4.7.2 Left Cover................................................................................................. 163 4.7.3 Duplex Unit Control Board ...................................................................... 163 4.7.
ページ12に含まれる内容の要旨
CHAPTER 1 PRODUCT DESCRIPTION
ページ13に含まれる内容の要旨
EPSON EPL-6200/EPL-6200L Revision A Toner life 1.1 Outline Table 1-2. Toner Life EPSON EPL-6200 and EPSON EPL-6200L are non-impact page printer with Model Initial Replacement semiconductor laser and electrophotographic technology. EPL-6200 3000 pages 3000 pages 6000 pages EPL-6200L 1500 pages 3000 pages 1.1.1 Features ENGINE FEATURES Photoconductor Unit A compact and lightweight A4 engine. The Photoconductor Unit can be assembled with the Developer Cartridge (toner Hig
ページ14に含まれる内容の要旨
EPSON EPL-6200/EPL-6200L Revision A CONTROLLER FEATURES Host-based controller CPU : EPSON 32 bit RISC S1C33000 48 MHz High-speed controller RAM : Standard RAM is 2 MB CPU : TMPR4955BFG 200 MHz (Same as for EPL-N2500) RAM can be not expanded. RAM : 8 MB fitted as standard RAM and Expandable up to 136 MB Two standard interfaces Max. IEEE1284 compatible parallel interface supporting ECP. Exclusive RAM DIMM for EPSON (Same as for EPL-6100) USB interf
ページ15に含まれる内容の要旨
EPSON EPL-6200/EPL-6200L Revision A SOFTWARE FEATURE (ONLY WITH EPL-6200) OTHER FEATURE (ONLY WITH EPL-6200L) Printer status and printer environment are monitored by bidirectional EJL and Toner save image is made by Printer Driver. ESC/Page. Physical engine offset setting function (It is set by printer driver) The following modes and resolution are supported. Printer sharing (Printer driver’s function) Table 1-3. Supported Modes 1200dpi 600dpi 300dpi Note ESC/Page PCLXL PC
ページ16に含まれる内容の要旨
EPSON EPL-6200/EPL-6200L Revision A 1.1.2.2 “EPL-6200L” Differences from EPL-6100L 1.1.2 Differences between Models Printing speed is 20 ppm (EPL-6100L: 16 ppm) 1.1.2.1 “EPL-6200” Differences from EPL-6100 CSIC with Developer Cartridge (toner cartridge) Table 1-5. “EPL-6200” Differences from EPL-6100 The ECP/Nibble switch jumper is disused. Item EPL-6200 EPL-6100 Note The High humidity/Normal humidity switch jumper is disused. (The setting is Engine speed 20 ppm 16 ppm enable by printe
ページ17に含まれる内容の要旨
EPSON EPL-6200/EPL-6200L Revision A 1.1.3 Other (Only with EPL-6200L) 1.1.3.1 Restrictions on Use of EPL-6200L The printer itself cannot print the Status Sheet. When the printer is connected to a parallel interface, printing via devices such as a printer switch, LAN-Parallel converter, or USB-Parallel converter is not guaranteed. → Direct connection to a printer port of the host computer with an ECP supporting cable is premised. Using a converter for a USB connectio
ページ18に含まれる内容の要旨
EPSON EPL-6200/EPL-6200L Revision A 1.2.2 Printer Basic Specifications 1.2 Basic Specifications Resolution: 1.2.1 Process Specifications Table 1-8. Resolution Printer Type Model Resolution Note Semi-conductor laser beam scan and dry single-component non-electromagnetic EPL-6200 600 dpi/1200dpi 1200 dpi is by half speed control toner electrophotography EPL-6200L 600 dpi Light Source Semi-conductor laser Warming Up Time: Photoconductor Unit 21 or less seconds...... Time from pow
ページ19に含まれる内容の要旨
EPSON EPL-6200/EPL-6200L Revision A Normal paper (including labels and transparencies) Thick paper Table 1-10. Continuous Printing Speed with Plain Paper (Unit: ppm or more) Table 1-11. Continuous Printing Speed with Thick Paper (Unit: ppm or more) EPL-6200 EPL-6200L EPL-6200 EPL-6200L Simplex Duplex Simplex Paper Size 600 dpi 1200 dpi 600 dpi Paper 600 dpi 1200 dpi ppm down* ppm down* ppm down* Size 600 dpi 1200 dpi 600 dpi 1-sheet 2-sheet 1-sheet 2-sheet A4 16.0 12.0 8.0 6.0 16.0 12.0 circ
ページ20に含まれる内容の要旨
EPSON EPL-6200/EPL-6200L Revision A Thick paper ppm control For thick paper printing, sheets of paper is fed at wider intervals (ppm Down) as described below to prevent temperature rise at both ends of the fuser unit. The ppm Down control will be started after a lapse of 100 seconds from the start of Thick Paper printing. NOTE: However, if the motor has already been running for more than 100 seconds to execute jobs (continuous or intermittent printing) before starting thick paper printing
