ページ1に含まれる内容の要旨
RG70
Gas Hob
User Guide
&
Installation & Service Instructions
U109926 - 02
ページ2に含まれる内容の要旨
Contents 1. Before You Start... 1 2. Hob Overview 3 3. Cleaning Your Hob 5 4. Troubleshooting 7 5. Installation 8 6. Conversion to LPG Gas 12 7. Circuit Diagram 13 8. Technical Data 14 9. Warranty/After Sales Service 15
ページ3に含まれる内容の要旨
DocNo.011-0001 - Introduction gas 1. Before You Start... Thank you for buying a Rangemaster hob. It should give you Personal Safety many years trouble-free cooking if installed and operated Accessible parts will become hot during use and will correctly. It is important that you read this section before you retain heat even after you have stopped cooking. start, particularly if you have not used a gas hob before. Keep babies and children away from the hob and This appliance is designed f
ページ4に含まれる内容の要旨
Cleaning In the interests of hygiene and safety, the hob should be kept clean at all times as a build up of fats and other foodstuffs could result in a fire. Clean only the parts listed in this guide. Clean with caution. If a wet sponge or cloth is used to wipe spills on a hot surface, be careful to avoid steam burns. Some cleansers can produce noxious fumes if applied to a hot surface. 2
ページ5に含まれる内容の要旨
DocNo.021-0002 - Overview RG70 gas 2. Hob Overview Fig.2-1 ArtNo.316-0006 RG70 hob The diagram by each of the control knobs indicates which Fig.2-2 burner that knob operates (Fig.2-1). Each burner has a special Flame Safety Device (FSD) that stops the flow of gas if the flame goes out. To light a burner, push in and turn the associated control knob anti-clockwise (Fig.2-2) to the ‘high’ position indicated ArtNo.316-0001 RG60 hob control by the large flame symbol [ ]. Keep the knob pressed down
ページ6に含まれる内容の要旨
Pans and kettles with concave bases or down turned base Fig.2-5 rims should not be used (Fig.2-5). Simmering aids, such as asbestos or mesh mats, are NOT recommended. They will reduce burner performance and could damage the pan supports (Fig.2-6). ArtNo.311-0002 Pan with rim You should also avoid using unstable and misshapen pans that may tilt easily, and pans with a very small base diameter, e.g. milk pans, single egg poachers (Fig.2-7). The minimum recommended pan diameter is 120mm. The
ページ7に含まれる内容の要旨
DocNo.041-0002 - Cleaning gas 5-element 3. Cleaning Your Hob Essential information Fig.3-1 Allow the cooker to cool and then isolate the electricity � supply before carrying out any thorough cleaning. Never use paint solvents, washing soda, caustic cleaners, biological powders, bleach, chlorine based bleach cleaners, coarse abrasives or salt. Do not � mix different cleaning products – they may react � together with hazardous results. All parts of the hob can be cleaned with hot soapy wate
ページ8に含まれる内容の要旨
Cleaning Table � � � ������� �� � � � � � ����� ���� ���������� � Refer to the cleaning tables (Table 3-1 and Table 3-2) for details on cleaning the hob. ������� ��� �� ������������ ������� �������� ��� �� ������������� ��������� The cleaners listed are available from supermarkets or ����� � ��� � ������������������������� �������� ������� ��� �� � electrical retailers. For enamelled surfaces use a cleaner that is approved fro use on vitreous enamel. The Vitreous � ��������� �� �������� ���
ページ9に含まれる内容の要旨
DocNo.051-0001 - Troubleshooting - BI hob gas 4. Troubleshooting If there is an installation problem and I don’t get my original installer to come back to fix it, who pays? You do. Service organisations will charge for their call- outs if they are correcting work carried out by your original installer. Therefore, it’s in your own interest to keep track of this installer so that you can contact them as required. Hotplate ignition or hotplate burners faulty. Is the power on? If not, there mayb
ページ10に含まれる内容の要旨
INSTALLATION Check the appliance is electrically safe and gas sound when you have finished. DocNo.061-0002 - Installation - RG70 gas hob 5. Installation In the Republic of Ireland: Dear Installer The installation must be carried out by a competent person Before you start your installation, please complete the details and installed in accordance with the current edition of IS 813 BELOW. “Domestic Gas Installations”, the current Building Regulations ��������� � ������ and reference should be ma
ページ11に含まれる内容の要旨
INSTALLATION Check the appliance is electrically safe and gas sound when you have finished. You will need the following equipment to complete the hob Fig.5-1 installation satisfactorily: ������ ��� • Gas Pressure tester • Flexible gas hose • Multimeter ����� ��������������� You will also need the following tools: ����� ����� � ��� 1. Electric drill 2. Jigsaw � ��� ��������� ������������ 3. Steel tape measure � ������ ������� ��������� ��� ������ 4. Cross head screwdriver 5. Pencil 6. Adjustable
ページ12に含まれる内容の要旨
INSTALLATION Check the appliance is electrically safe and gas sound when you have finished. For safety reasons curtains must not be fitted immediately • It must be easy to inspect the entire pipe length in order behind the hotplate. to check its state of wear. • The pipe must be replaced within the date stamped on the pipe itself. Conversion to LP If the appliance is to be converted to LP gas do the If in doubt, contact your supplier. conversion at this point. See the conversion section of thes
ページ13に含まれる内容の要旨
INSTALLATION Check the appliance is electrically safe and gas sound when you have finished. Electrical Connections Fig.5-4 This appliance must be installed by a qualified electrician to comply with the relevant Institute of Electrical ��� Engineers (I.E.E.) regulations and also the local electricity � ���� �� supply company requirements. ����� WARNING: THIS APPLIANCE MUST BE EARTHED Note: All external wiring must comply with the IEE Regulations for the Electrical Equipment of Buildings. ���
ページ14に含まれる内容の要旨
WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished. DocNo.071-0002 - LP gas conversion - BI hobs 6. Conversion to LPG Gas Check in the ‘Technical Data’ section at the back of the Fig.6-1 instructions that the cooker is convertible to the gas you want to use. This conversion must be performed by a suitably competent person, in accordance with these instructions and with the loca
ページ15に含まれる内容の要旨
DocNo.091-0002 - Circuit diagram - RG70/RGG77 gas 7. Circuit Diagram N L � ArtNo.080-0016 - RG70/RGG77 circuit diagram � � � � � A Spark generator B Ignition switch 13
ページ16に含まれる内容の要旨
8. Technical Data The hob is an independent Class 3 built-in unit. This hob is category II2H3+ It is supplied set for group H natural gas. A conversion kit from NG to LP gas is packed with the hob. INSTALLER: Please leave these instructions with the user. DATA BADGE LOCATION: Base of the hob. COUNTRY OF DESTINATION: GB/IE Gas Electric Natural Gas 20mbar 220 – 240V 50Hz Butane 29mbar Propane 37mbar (See appliance data badge for test pressures) Dimensions 100mm; Above worktop 50mm; Overall hei
ページ17に含まれる内容の要旨
DocNo.111-0002 - Warranty No.9 9. Warranty/After Sales Service If consultation or technical assistance is needed, please provide the local authorised service agent with the purchase invoice and the product code/serial number. The 2 years free maintenance for the operation of the appliance started from the date of purchase of this product. Any cosmetic damage to the appliance must be reported within 90 days of delivery. For in-warranty service please call: 0845 6035312. For general enquiries
ページ18に含まれる内容の要旨
16
ページ19に含まれる内容の要旨
17
ページ20に含まれる内容の要旨
DocNo.000-0001 - Back cover Rangemaster � � �� � ����������� �������� ������� ������� �� w w w . r a n g e m a s t e r . c o . u k ArtNo.000-0003 CE logo
