ページ1に含まれる内容の要旨
Instructions for Installation and Use
Gas Hob
Models GD74, GD74 CH,GD64, GF740, GE740TCX
To the Installer
Before installation fill in the product details on the back cover of this book.
The information can be found on the rating plate.
To the User
You must read the instructions prior to installing and using the appliance and
then retain them for future reference.
ページ2に含まれる内容の要旨
CONTENTS Introduction 3 For Your Safety 4 Know your Hob 5 How to use your Hob 5 Practical Advice 6 Care and Cleaning 6 Troubleshooting 7 Installation 8-10 Electrical Connection 11 Characteristics of Burners and Nozzels 12 After Sales Service 14 Hotpoint Guarantee 15 Key Contacts Back Cover Retention of this Instruction Book This Instruction Book must be kept handy for reference as it contains important details on the safe and proper use of the appliance. If you sell or pass the appliance to some
ページ3に含まれる内容の要旨
Introduction Your new hob is guaranteed* and will give lasting service. This guarantee is only applicable if the appliance has been installed in accordance with the installation instructions detailed in this booklet. To help make best use of your cooking equipment, please read this booklet carefully. The hob is designed specifically for domestic use and responsibility will not be accepted for use in any other installation. * The guarantee is subject to the provisions that the appliance: (a) Has
ページ4に含まれる内容の要旨
For Your Safety When used properly your appliance is completely safe but as with any electrical product there are certain precautions that must be observed. PLEASE READ THE BELOW PRECAUTIONS BEFORE USING YOUR APPLIANCE. To maintain the efficiency and safety of this appliance, we recommend you do the following: - only call the Service Centres authorised by the manufacturer. - always use genuine spare parts. ALWAYS: NEVER: - make sure you remove all packaging and dispose of safely. - attempt to in
ページ5に含まれる内容の要旨
Know your Hob Model GD74, GD74 CH A TC F RR B S C D Model GF740, GE740TCX Model GD64 S A S A RR B R B S C C S B. Pan Support for Cookware A. Auxilliary Burner C. Control Knobs for Gas Burners R Rapid Burner D. Ignitor for Gas Burners S. Semi Rapid Burner F. Flame Failure Device - Activates if the flame accidentally RR. Reduced Rapid Burner goes out (spills, drafts, etc.), interrupting the delivery of TC. Triple Crown Burner (Wok Burner) gas to the burner. How To Use Your Hob The position of the
ページ6に含まれる内容の要旨
Practical Advice Practical Advise on Using the Burners Burner Cookware Diameter For best performance, follow these general guidelines: (cm) • Use the appropriate cookware for each burner (see Rapid (R) 24 - 26 table) in order to prevent the flame from reaching the Reduced Rapid (RR) 22 - 24 sides of the pot or pan; Semi-Rapid (S) 16 - 20 • Alwasy use cookware with a flat bottom and keep the Auxilliary (A) 10 - 14 lid on; Triple Crown (TC) 24 - 26 • When the contents come to a boil, turn the knob
ページ7に含まれる内容の要旨
Troubleshooting Before calling service for assistance, check through the If the burner does not remain on when set to "Low". following list, there may be nothing wrong. Check to make sure that: First of all, check to see that there are no interruptions in the • The gas holes are not clogged. gas and electrical supplies, and, in particular, that the gas • There are no draughts near the cooking surface. valves for the mains are open. • The minimum has been adjusted correctly (see Installation sect
ページ8に含まれる内容の要旨
Installation The following instructions are intended for the installer so that the d) Liquidified petroleum gases are heavier than air and, as a result, installation and maintenance procedures may be followed in the settle downwards. Rooms in which LPG tanks are installed most professional and expert manner possible. Important: must be fitted with ventilation openings to the outside in order to Disconnect the appliance from the electrical supply before allow the gas to escape in the event of a l
ページ9に含まれる内容の要旨
45 mm. Installation Before fastening the hob in place, position the seal When installing the hob above a built-in oven without forced (supplied) along the perimeter of the worktop, as shown ventilation, ensure that there are air inlets and outlets for ventilating in the figure. the interior of the cabinet adequately. Clamps are provided to fasten the hob to counters measuring from 20 to 40 mm in thickness. To fasten the Gas Connection for the Hob hob securely, it is recommended that all the clam
ページ10に含まれる内容の要旨
Installation Adapting the Hob for Different Types of Gas Regulation of Air Supply to the Burner To adapt the hob to a different type of gas than that for which it The burners do not need a primary air regulator. was designed, (see the sticker under the hob or on the packaging), Minimum Regulation the burner nozzles must be changed, as follows: • Turn the gas valve to minimum. • Remove the pan supports and slide the burners out of the • Remove the knob and turn the regulator screw (positioned coo
ページ11に含まれる内容の要旨
Electrical Connection Before connecting to the power supply, make sure that: Electrical connection • the limiter switch and the domestic system can WARNING: THIS APPLIANCE MUST BE EARTHED. withstand the load from the appliance (see rating The hob is designed to work with alternating current, the plate). supply voltage and frequency indicated on the rating plate • the supply system is efficiently earthed according to (situated under the hob). Make sure that the local supply standards and laws in
ページ12に含まれる内容の要旨
Characteristic of the burners and nozzles Table 1 Liquid Gas Natural Gas Burner Diameter Thermal Power By-pass Nozzle Flow* Nozzler Flow* (mm) kW (p.c.s.*) 1/100 1/100 g/h 1/100 l/h (mm) Nom. Red. (1) (mm) *** ** (mm) Fast Rapid 100 3.00 0.7 41 39 86 218 214 116 286 (L (Large) (R) arge) (R) Reduced Fast Reduced 100 2.60 0.70 41 39 80 189 186 110 248 (RR) Rapid (RR) Semi Rapid Semi Fast 75 1.65 0.4 30 28 64 120 118 96 157 (Medium) (S) (Medium) (S) Auxiliary 55 1.00 0.4 30 28 50 73 71 71 95 (Small
ページ13に含まれる内容の要旨
Notes 13
ページ14に含まれる内容の要旨
"No company is better positioned to offer an after sales service on a Hotpoint appliance than us - the manufacturer" As part of our commitment to you, all Hotpoint appliances have the added benefit of a fully inclusive parts and labour guarantee for the first 12 months. In addition to this you also have the advantage of free replacement parts for the first 5 years when fitted by a Hotpoint engineer. When the 12 months parts and labour guarantee expires we offer the following after sales servic
ページ15に含まれる内容の要旨
Guarantee "Satisfaction guaranteed or your money back" We give you a unique 'satisfaction guaranteed' promise - valid for 90 days - after you have purchased your Hotpoint appliance. If there is a technical problem simply call Hotpoint Repair service or visit our web-site at www.theservicecentre.co.uk and where necessary, we will arrange for an engineer to call. If the technical problem is not resolved under this guarantee, we will replace your machine or, if you prefer, give you your money ba
ページ16に含まれる内容の要旨
Key Contacts After Sales Service Over 1200 trained specialists, directly employed by us, ensure that you can have complete confidence in both the appliances and services we offer. Repair Service and Information Desk UK: 08709 066 066 (Open 8 to 8 Mon - Fri, 8 to 6 Sat, 10 to 4 Sun & Bank Holidays) www.theservicecentre.co.uk Republic of Ireland: 1850 302 200 Note: Our operators will require the following information: Model number: Serial number: Extended Warranties UK: 08709 088 088 (Open 8 to 8
