ページ1に含まれる内容の要旨
®
GE Monogram
Installation
Instructions
Professional
Gas Cooktops
48" Natural Gas Models
ZGU48N4G
ZGU48N6R
ZGU48N6D
48" LP Gas Models
ZGU48L4G
ZGU48L6R
ZGU48L6D
36" Natural Gas Models
ZGU36N6
ZGU36N4R
ZGU36N4D
36" LP Gas Models
ZGU36L6
ZGU36L4R
ZGU36L4D
ページ2に含まれる内容の要旨
Before you begin—Read these instructions completely and carefully. IMPORTANT: Save these instructions for local inspector’s use. IMPORTANT: OBSERVE ALL GOVERNING CODES AND ORDINANCES. NOTE TO INSTALLER: Be sure to leave these instructions with the Consumer. NOTE TO CONSUMER: Keep these instructions with your Owner’s Manual for future reference. CAUTION WARNING This appliance must be properly grounded. See “Electrical Supply”, page 6. Proper installation is the responsibility of the For Monogram
ページ3に含まれる内容の要旨
Design Information Professional Gas Cooktops These cooktops are factory set for either Models natural gas or liquid propane gas. Order the Available model for your installation situation. 48" Natural Gas Models: 36" Natural Gas Models: ZGU48N4G ZGU36N4D 4 gas burners, grill and griddle 4 gas burners and griddle ZGU48N6R ZGU36N4R 6 gas burners and grill 4 gas burners and grill ZGU48N6D ZGU36N6 6 gas burners and griddle 6 gas burners 48" Liquid Propane Gas Models: 36" Liquid Propane Gas Models: ZG
ページ4に含まれる内容の要旨
Design Information Professional Gas Cooktops Product 47-7/8" 26-5/8" 48" Wide Hood Dimensions 8-7/16" & Clearances 13" Max. 36" Min. to Refer to Hood Combustible Installation 12" Min. to Material From Instructions 18" Min. Combustible Cooking Material Surface Each Side 2" 17" 48" Wide Models 46-1/8" 7/8" 22-3/4" Min. Cooking Surface Electric/Gas 2-1/2" Supply 8" 26-5/8" 36" Wide Hood 8-7/16" 13" Max. 36" Min. to Refer to Hood Combustible Installation 12" Min. to Material From Instructions 18" M
ページ5に含まれる内容の要旨
Installation Preparation Professional Gas Cooktops These cooktops can be installed in standard • The stainless surface of the cooktop will be Installation 24" or deeper 25" cabinets. 1/2" higher than adjacent countertop. Options • In 24" deep cabinets, the front of the • Cooktop fits flush to rear of cutout, no cooktop will project approximately 1-7/8" additional support is required. beyond the front of the countertop. • In 25" deep cabinets, the cooktop will be Cooktop 1/2" Above Adjacent flush
ページ6に含まれる内容の要旨
Installation Preparation Professional Gas Cooktops • Saw • Gas-resistant pipe joint sealant Tools & • Measuring tape • 5 foot, 5/8" AGA-certified flexible metal gas Materials • Carpenter’s square supply line. (Length must comply with local • Pipe and fittings as required. codes.) Required: • Manual gas line shut-off valve. –If required by local codes, use solid pipe • Gas pressure regulator (supplied) fittings. • Large flat-blade screwdriver Note: Purchase new flexible line. DO NOT • Pipe wrench
ページ7に含まれる内容の要旨
Installation Professional Gas Cooktops • Flatten the carton and use a piece as a pad Use a hand-truck to move this cooktop. on the bottom and back of the hand-truck. Step Lift the cooktop onto the hand-truck Before moving the cooktop indoors: 1 standing on its end, with the bottom of the • Remove outer carton and packing. cooktop resting against the back of the • Remove the straps holding the cooktop to the Remove hand-truck. skid. Packaging Move the cooktop indoors: • Remove the grates and draw
ページ8に含まれる内容の要旨
Installation Professional Gas Cooktops • Lower the cooktop into the opening. Make sure the cooktop is evenly seated and sup- Step ported. A side frame gasket will seal the 3 cooktop to the countertop. • “L” brackets with screws are provided to Install secure the cooktop to the countertop or to adjacent cabinetry. the Alternate Bracket –Alternate screw hole locations on the sides Screw Holes Cooktop of the cooktop allow for varying thicknesses of countertops or side cleats. • Select the bracket l
ページ9に含まれる内容の要旨
Installation Professional Gas Cooktops Step Plug power cord into properly grounded receptacle. 6 Connect Electrical • Replace the burner bowls and burner caps. Igniter • Adjustments should not be required, unless Step vibration during transit or variations in local Burner 7 gas supply make minor adjustments neces- Main Burner sary. Assemble Venturi (rear) Burners, CAUTION: Burner adjustments must be made by a qualified technician at the time of Check installation. Extreme care should be used if
ページ10に含まれる内容の要旨
Installation Professional Gas Cooktops Adjustable low setting • Grip the shaft with pliers and turn counter- The open top burners and grill valves have an clockwise to lower the flame, or clockwise to Step adjustable low setting. Each valve is individu- increase the flame. 7 ally tested and adjusted before it is shipped. CAUTION: Do not turn the flame so low that Minor adjustments may be required due to it goes out, causing the igniter to spark. Assemble fluctuations in local gas pressure. Adjus
ページ11に含まれる内容の要旨
Notes Professional Gas Cooktops 11
ページ12に含まれる内容の要旨
Note: While performing installations described in this book, safety glasses or goggles should be worn. ® For Monogram local service in your area, call 1-800-444-1845. Note: Product improvement is a continuing endeavor at General Electric. Therefore, materials, appearance and specifications are subject to change without notice. ® Monogram. We bring good things to life. GE Consumer Products General Electric Company Pub. No. 49-8812-6 Louisville, KY 40225 Dwg. No. 164D3333P056 © 2003 General Electr
