ページ1に含まれる内容の要旨
ELECTRIC HOB
FEH 610
GB
35685-3501
INSTRUCTION BOOKLET
ページ2に含まれる内容の要旨
Important Safety Information You MUST read these warnings carefully before installing or using the hob. If you need assistance, contact our Customer Care Department on 08705 950950 Installation Environmental Information This hob must be installed by qualified personnel, After installation, please dispose of the packaging with according to the manufacturer’s instructions and to due regard to safety and the environment. the relevant British Standards. When disposing of an old appliance, make
ページ3に含まれる内容の要旨
Contents For the User For the Installer Important Safety Information 2 Installation 9 Description of the Hob 3 Building In 9 Operation 4 Electrical connections 10 Maintenance and Cleaning 5 Wiring diagram 11 Something Not Working? 6 Service and Spare Parts 6 Guarantee Conditions 7 Description of the Hob 3 4 2 1 6 5 7 1. Hob Top 2. Normal Hotplate - 1570 W - 180 mm dia. 3. Normal Hotplate - 1040 W - 145 mm dia. 4. Rapid Hotplate - 2090 W - 180 mm dia. 5. Rapid Hotplate - 1570 W - 145 mm dia.
ページ4に含まれる内容の要旨
Operation Electric Hotplates Suggestions for the correct setting of the plates are given To switch on a hotplate, turn the relevant control knob in the following table. anticlockwise to the required heat setting. The control knob is numbered 1 - 6 OFF 0 0 - OFF Very Gentle 1 To keep food warm 1 - Minimum To melt butter and chocolate 6 - Maximum. Gentle 2 To prepare cream-sauces, The hob has two types of hotplates: stews and milk puddings or to fry eggs Normal Hotplates We recommend the pla
ページ5に含まれる内容の要旨
Take care never to lean or reach over a hot electric plate. Always point pan handles inward or over the work surface next to the hob to avoid accidentally knocking over a pan as you pass by. Take care when frying food in hot oil or fat, as the overheated splashes could easily ignite. If the control knobs become difficult to turn, please contact your local Service Force Centre. Maintenance and Cleaning Before any maintenance or cleaning can be carried out, you must DISCONNECT the hob from the el
ページ6に含まれる内容の要旨
Something Not Working? If the hob is not working correctly, please carry out the following checks before contacting your local Service Force Centre. IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee. SYMPTOM SOLUTION The plate does not heat up. Check that the unit is plugged in and the electrical supply is switched on Check that the RCCB has not tripp
ページ7に含まれる内容の要旨
Guarantee Conditions Standard guarantee conditions European Guarantee If you should move to another country within Europe then We, EHP, undertake that if, within 12 months of the date your guarantee moves with you to your new home of the purchase, this Firenzi appliance or any part thereof subject to the following qualifications: is proved to be defective by any reason only of faulty * The guarantee starts from the date you first workmanship or materials, we will, at our option, repair or purcha
ページ8に含まれる内容の要旨
50 mm 100 mm 50 mm 100 mm 50 mm 50 mm 600 mm Instructions for the Installer Engineers technical data Overall dimensions Heating elements Ratings Width: 580 mm. Normal front left Hotplate Ø 180 mm 1570 W Depth: 500 mm. Normal back left Hotplate Ø 145 mm 1040 W Rapid front right Hotplate Ø 145 mm 1570 W Rapid back right Hotplate Ø 180 mm 2090 W Total rating 6270 W Cut out dimensions Width: 550 mm. Depth: 470 mm. INSTALLATION GUIDANCE INSTRUCTIONS CLEARANCES REQUIRED WHEN FITTING THE HOB WITHOUT A
ページ9に含まれる内容の要旨
Installation The hob must be installed according to the When the hob is first installed instructions supplied. Once the hob has been installed, it is important The hob must be installed by qualified personnel to remove any protective materials, which were to the relevant British Standards. put on in the factory. The manufacturer will not accept liability, should Please, ensure that, once the hob is installed, it the above instructions or any of the other safety is easily accessible for the engin
ページ10に含まれる内容の要旨
Building over a kitchen unit 3 with door Proper arrangements must be taken in designing the furniture unit, in order to avoid any contact with the bottom a of the hob which can be hot when in operation. The 60 recommended solution is shown in diagram 3. The panel fitted under the hob ("a") should be easily b removable to allow easy access if technical assistance is needed. The space behind the kitchen unit ("b") can be used for connections. FO 1013 Dimensions are given in mm. Fitting the Hob in
ページ11に含まれる内容の要旨
The hob is supplied without a supply cable. A 3 core Ensure that the hob supply cord does not come flexible supply cable must be fitted, in accordance with into contact with surfaces with temperatures the specification given in the relevant tables. higher than 50 deg. C. 1) Remove the mains terminal cover plate from the underside of the hob, to expose the mains Supply Cable Specifications terminal block. For Uk use only 2) Loosen the two cable clamp screws and lift the top section of the clamp
ページ12に含まれる内容の要旨
35685-3501 09/03 Grafiche MDM - Forlì
