ページ1に含まれる内容の要旨
Installation Instructions Installation Instructions Installation Instructions Installation Instructions Installation Instructions
Cooktop
E30GC64ESS E36GC65ESS E46GC66ESS E46GC67ESS 5995426250
ページ2に含まれる内容の要旨
Safety 2 IMPORTANT SAFETY INSTRUCTIONS Safety Precautions Do not attempt to install or operate your unit until you have read the safety precautions in this manual. Safety items throughout this manual are labeled with a Warning or Caution based on the risk type. Definitions ! This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death. ! WARNING WARNING WARNING WARNING WARNING WA
ページ3に含まれる内容の要旨
Safety 3 SAFETY PRECAUTIONS ! WARNING WARNING WARNING WARNING WARNING • Read all instructions before using the appliance. Improper installation, adjustment, alteration, service, or maintenance can cause personal injury or property damage. Refer to these instructions and the accompanying Use & Care Manual. For assistance or additional information, consult a qualified installer, service agency, manufacturer (dealer), or the gas supplier. For your safety: - Do not obstruct the flow of combustio
ページ4に含まれる内容の要旨
Safety 4 ! WARNING WARNING WARNING WARNING WARNING Based on safety considerations, the top burner flame should be adjusted so it does not extend beyond the edge of the cooking utensil. Cooking utensils should not be used on the open top broiler section. If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury, or death. What to do if you smell gas: - Do not try to light any appliance. - Do not touch any electrical
ページ5に含まれる内容の要旨
Finding Information 5 READ AND SAVE THESE INSTRUCTIONS Attach your sales NO NO NO NO NOTE TE TE TE TE receipt to this page for future Installer: Leave instructions with owner. reference. Owner: Read your cooktop Use & Care Manual. It contains important safety information for operating this appliance. It also has many suggestions for getting the best results from your cooktop. Read all instructions before installing the cooktop. For your safety, please read and observe all safety instructions. Th
ページ6に含まれる内容の要旨
Finding Information 6 TABLE OF CONTENTS Safety ................................................................... 2 Definitions .......................................................... 2 Important Safety Instructions .............................. 2 Safety Precautions ............................................. 3 Finding Information ........................................... 5 Please Read And Save This Guide ................... 5 Questions? .................................................
ページ7に含まれる内容の要旨
Preparing for Installation 7 VERIFY PACKAGE CONTENTS • Use & Care Manual Cleaning Kit Hold Down Bracket Kit Grill Drip Pan (E46GC67ESS only) Grate/Burner Cap Pack Grill U-Burner (E46GC67ESS only) Burner Set Grill Heat Control Channels (E46GC67ESS only) Gas Pressure Regulator Grill (E46GC67ESS only) LP Conversion Kit Grease Control Box (E46GC67ESS only) CABINET/COUNTERTOP PREPARATION The installation of this built-in appliance must be completed by a qualified app
ページ8に含まれる内容の要旨
Preparing for Installation 8 IMPOR IMPOR IMPOR IMPOR IMPORTTTTTANT ANT ANT ANT ANT When installing the cooktop into a laminated (Formica, etc.) or synthetic (Corian, etc.) countertop, radius the corners of the cutout to prevent cracking of the countertop. Follow the countertop manufacturer’s instructions regarding the minimum corner radius, use of heat reflective tape, reinforcement of corners, etc. If cabinet storage space is to be provided directly above the cooktop, the risk of personal
ページ9に含まれる内容の要旨
Preparing for Installation 9 Figure 3 4" (102mm) 21" Chassis height (533mm) 30" (762mm) 1/4" (6mm) Min. to combustibles Vertical below chassis combustible surface Rear 7 1/2" (191mm) Min. wall to combustible 3 1/8" side wall above (79mm) the cooktop 2 1/4" 27 1/2" (both sides) (57mm) Min. (699mm) 19 7/8" (505mm) 25" (635mm) Minimum 2" (51mm) Min. Cutout Dimensions for the E30GC64ESS Figure 4 4" (102mm) 21" Chassis height (533mm) 36" (914mm) 1/4" (6mm) Min. to combustibles below chassis Vertical
ページ10に含まれる内容の要旨
Making the Gas/Electric Connection 10 REQUIREMENTS ! WARNING WARNING WARNING WARNING WARNING If the gas or electric service provided does not meet the product specifications, do not proceed with the installation. Call the selling dealer, the gas supplier, or a licensed electrical or plumbing contractor. The grounding plug must not, under any circumstances, be cut or removed. This appliance must be installed by a licensed plumber or gas fitter when installed within the Commonwealth of Massa
ページ11に含まれる内容の要旨
Making the Gas/Electric Connection 11 Gas and Electrical Supply Requirements The correct voltage, frequency and amperage must be supplied to the appliance from an isolated, grounded circuit which is protected by a properly sized circuit breaker or time-delay fuse. The cooktop must be connected to the power supply with copper wire only. The use of aluminum wire may result in unsatisfactory connections. Flexible armored or nonmetallic, sheathed copper cable (with a grounding wire) should be used t
ページ12に含まれる内容の要旨
Installation 12 INSTALLING THE COOKTOP Place and center the cooktop within the cutout. Secure the Figure 6 cooktop to the countertop utilizing the two (2) hold-down brackets provided. Do not overtighten the screws. See Figure 6. IMPOR IMPOR IMPOR IMPOR IMPORTTTTTANT ANT ANT ANT ANT Hold down bracket mounting holes (both sides) Do not use a hardening compound or caulking to permanently Electric Gas seal the cooktop into place, as the unit must be readily removable for service. If such a hardenin
ページ13に含まれる内容の要旨
Installation 13 GAS AND ELECTRIC REQUIREMENTS TABLE Refer to the following table for more information on gas and electric requirements. Model No. Electrical Total Gas type Manifold Minimum gas circuit connected pressure supply required load pressure Natural 4” Water Column 5” Water Column E30GC64ESS Natural 4” Water Column 5” Water Column E36GC65ESS 0.25 Amps 120VAC, Natural 4” Water Column 5” Water Column (0.03 Kw) 60Hz, 15A E46GC66ESS E46GC67ESS Natural 4” Water Column 5” Water Column Above mo
ページ14に含まれる内容の要旨
Installation 14 INSTALLING THE BURNER COMPONENTS ! WARNING WARNING WARNING WARNING WARNING Never attempt to operate the cooktop with any of the burner rings, burner caps, grates or grill components removed. Burner Components Remove the brass burner rings, porcelain burner caps, and porcelain grates from their shipping packages. Place each burner ring onto its corresponding burner base, being certain that the five alignment tabs slide into the matching notches in the base. Set each porcelain burn
ページ15に含まれる内容の要旨
Installation 15 MAKING THE ELECTRICAL CONNECTION ! WARNING WARNING WARNING WARNING WARNING Ensure that the power supply is disconnected before proceeding. Verify that the power supply matches the ratings found on the appliance data plate before proceeding. The complete appliance must be properly grounded at all times when electrical power is applied. Do not ground the appliance with the neutral (white) house supply wire. A separate ground wire must be utilized. If aluminum house supply
ページ16に含まれる内容の要旨
Operation 16 VERIFYING THE OPERATION ! WARNING WARNING WARNING WARNING WARNING If the cooktop fails to operate properly, ensure that the electrical power supply and gas supply are turned on and that all installation steps have been carefully followed. Call a qualified service technician if the cooktop still does not operate properly. The cooktop and shut-off valve must be disconnected from the gas supply piping during any pressure testing exceeding 1/2 pound per square inch (3.5 kPA). The
ページ17に含まれる内容の要旨
Operation 17 Turn on the main gas supply to the cooktop by opening the gas shut-off valve. Test each burner separately by pressing and turning one control knob at a time counterclockwise to the “HI/LITE” position. All ignitors will spark simultaneously. (It will take approximately four seconds for ignition to occur, at which time all igniters will stop sparking. If ignition does not occur within four seconds, turn off the knob, wait for at least two minutes to allow any gas to dissipate, then re
ページ18に含まれる内容の要旨
ページ19に含まれる内容の要旨
ページ20に含まれる内容の要旨
www.electroluxusa.com 1-877-4Electrolux www.electroluxca.com
