ページ1に含まれる内容の要旨
FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 1
INSTRUCTIONS for INSTALLATION
and USE
Gas Hob
W810
This appliance must be installed in accordance with
regulations in force and only in a well ventilated place.
Ensure that the hob unit is securely fixed to the worktop
before use.
To the Installer
Before installation fill in the product details on the back cover of this
booklet. The information can be found on the rating plate.
To the User
You must read the instructions prior to using
ページ2に含まれる内容の要旨
FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 2 CONTENTS Introduction 3 For Your Safety – Always 4 For Your Safety – Never 5 Using The Hob 6 Care & Cleaning 7 Something Wrong? 8 Installation 9 - 14 Key contacts Back Cover Retention of this Instruction Book This Instruction Book must be kept handy for reference as it contains important details on the safe and proper use of the appliance. If you sell or pass the appliance to someone else, or move house and leave it behind, make sure thi
ページ3に含まれる内容の要旨
FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 3 INTRODUCTION Your new hob is guaranteed* and will give lasting service. This guarantee is only applicable if the appliance has been installed in accordance with the installation instructions detailed in this booklet. To help make best use of your cooking equipment, please read this booklet carefully. The hob is designed specifically for domestic use and responsibility will not be accepted for use in any other installation. * The gua
ページ4に含まれる内容の要旨
FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 4 FOR YOUR SAFETY When used properly, your appliance is completely safe but as with any product there are certain precautions that must be observed. PLEASE READ THE PRECAUTIONS BELOW BEFORE USING YOUR APPLIANCE. ALWAYS Always make sure you understand the controls prior to using the appliance. Always keep children away from the appliance when in use as the surfaces will get extremely hot during and after cooking. Always make sure all c
ページ5に含まれる内容の要旨
FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 5 FOR YOUR SAFETY NEVER Never leave children unsupervised where a cooking appliance is installed as all cooking surfaces will be hot during and after use. Never allow anyone to sit or stand on any part of the appliance. Never store items above the appliance that children may attempt to reach. Never leave anything on the hob surface when unattended and not in use. Never heat up unopened food containers as pressure can build up ca
ページ6に含まれる内容の要旨
FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 6 USING THE GAS HOB - FEATURES In order to obtain maximum performance from the burners, use pans with the following diameters: Rapid burner 22 - 28 cm Standard burner 14 - 22 cm Auxillary burner 10 - 14 cm All pans should be positioned centrally over the burners. DO NOT allow young children near to the appliance when the hob is in use as the surfaces get extremely hot. OPERATION WHEN USING THE GAS HOB Step 1 Check that the electricity is s
ページ7に含まれる内容の要旨
FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 7 CARE AND CLEANING SWITCH OFF THE ELECTRICITY SUPPLY BEFORE CLEANING. BEFORE SWITCHING ON AGAIN, ENSURE THAT ALL CONTROLS ARE IN THE OFF POSITION. NEVER USE BIOLOGICAL WASHING POWDER, HARSH ABRASIVES, SCOURING PADS, AEROSOL CLEANERS OR OVEN CHEMICAL CLEANERS OF ANY KIND. Clean the hob regularly and wipe up spills soon after they occur to prevent them from becoming burnt on. CLEANING MATERIALS TO AVOID 1. Household abrasive powders, e.g.
ページ8に含まれる内容の要旨
FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 8 SOMETHING WRONG ? IF THE IGNITION DOES NOT WORK Is the electricity switched on? If the electricity supply has failed, the burners can be lit with a match. If only a hotplate burner is failing to ignite, check that the burner body and cap are seated correctly and that the slots in the burner body are not blocked (see care and cleaning). May we wish you many years of carefree successful cooking. Disposal of your product To minimise the ri
ページ9に含まれる内容の要旨
FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 9 INSTALLATION - electrical requirements WARNING – THIS APPLIANCE MUST BE EARTHED. CONNECT TO A 230-240V A.C. SUPPLY ONLY. Connection to the electricity supply should be made via a properly earthed, readily accessible wall socket which is adjacent to but not directly above, and not more than 1.25m away from the appliance and capable of electrical isolation. Should this plug not fit the socket outlet in your home it should be cut off and r
ページ10に含まれる内容の要旨
FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 10 INSTALLATION INSTRUCTIONS Gas Category II2H3+ (GB,IE) Model Numbers W810, BG05 These models are set to burn NATURAL GAS (G20) at 20mbar. They can also be converted to burn BUTANE GAS (G30) at 28mbar or PROPANE GAS (G31) at 37mbar using the conversion kit included. Technical Data 1 1 Rp /4 ( /4” BSP female) Gas Connection Burner injector Pressure test point None Gas rate adjustment None Aeration adjustment o 230-240V ac. 50Hz Heat re
ページ11に含まれる内容の要旨
FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 11 INSTALLATION INSTRUCTIONS Prior to installation, ensure that the local distributions (nature of the gas and gas pressure) and the adjustment conditions are compatible. The adjustment conditions for this appliance are stated on the rating plate which is fitted on the underside of the base panel. This appliance is not designed to be connected to a combustion products evacuation device. It must be installed and connected in accordance wit
ページ12に含まれる内容の要旨
FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 12 INSTALLATION SITING THE HOB The hob is designed to fit into worktop and base unit(s) with a cutout as shown in Fig.1. Any obstruction such as supports or side panels must be removed to allow 30mm minimum depth below the worktop cutout. Any overhead surface of combustible material must not be closer than 600mm. When installing next to a tall cupboard, partition or wall, for a minimum distance of 400mm above the hotplate a side clearance
ページ13に含まれる内容の要旨
558mm FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 13 INSTALLATION Fig. 1 IMPORTANT Minimum unobstructed depth 30mm 50mm Front edge of worktop Worktop thickness Preferred 30-40mm 19mm minimum recommended Fig. 2 FIXING CLAMP Note: Do not over tighten the hob clamps as distortion of the hob may occur. 13 489mm
ページ14に含まれる内容の要旨
FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 14 INSTALLATION INSTRUCTIONS LPG Conversion Instructions for Model W810, BG05 Read the Gas Hob instructions before conversion, installation and using the Gas Hob. Contents of kit: 1 Rapid burner injector marked 92 - 1 off 2 Semi-rapid burner injector marked 72 - 2 off 3 Auxillary burner injector marked 55 - 1 off Hotplate Burner Injector Change and Bypass Screw Adjustment Ensure that the Gas Hob is disconnected from the gas and electricity
ページ15に含まれる内容の要旨
FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 15 15
ページ16に含まれる内容の要旨
FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 16 Key Contacts Service Creda has the largest appliance manufacturer’s service team in Europe, trained specialists directly employed by us to ensure your complete confidence. Repair Service UK: 08709 066 066 Republic of Ireland: 1850 302 200 You will be asked for the following information:- Name, address and postcode. Telephone number Model / Serial number of the appliance Clear and concise details of the query or fault Place and Date of p
