ページ1に含まれる内容の要旨
HCC662 Ceramic Hob
Manual for Installation, Use and Maintenance
Passionate about style
Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY
T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.eu
ページ2に含まれる内容の要旨
Important The CDA Group Ltd cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note that CDA reserve the right to invalidate the guarantee supplied with this product following incorrect installation or misuse of the appliance or use in a commercial environment. This appliance is not designed to be used by people (including children) with reduced physical, sensorial or mental capacity, or who lack experience or knowledge about it,
ページ3に含まれる内容の要旨
Please note: • Ceramic hobs become hot and remain hot during and immediately after use. Do not touch the hob until it has been allowed to cool. • Keep children away from the appliance when in use. • Never put cooking foil or plastic materials on the ceramic surface when the hob is hot. These materials could melt and cause damage to the hob. • Never use the hob top for storage. • Pan handles should never stand out beyond the edge of the worktop. This will ensure children cannot re
ページ4に含まれる内容の要旨
Using your hob 2 3 7 8 9 1 4 10 5 6 Fig.1 Zones: 5. Zone indicators 1. Front left 0.7/2.1 kW 130/220 mm dual 6. Zone displays 2. Back left 1.2 kW 160 mm 7. Zone selection key 3. Back right 1.8 kW 190 mm 8. Power level + key 4. Front right 1.2 kW 160 mm 9. Power level - key 10. Power on/off key Control panel: Power level Type of cooking 0 switched off 1/2 for melting (butter/chocolate) or keeping food warm 2/3 keeping food hot or to heat small quantities of liquid 3/4 heat larger quant
ページ5に含まれる内容の要旨
Using your hob To switch the zone on • Touch the power key. • Select the zone required by touching the zone selection key until the required zone flashes a 0 in the zone display. The order for zone selection is clockwise starting at the front right zone. The zone display will flash for approximately ten seconds when the zone will be set at the power level selected or switch off if no power level is set. Please note: • To activate a zone, touch the zone selection key until the required zone
ページ6に含まれる内容の要旨
Efficient Use of your Hob Before using your hob for the first time, switch the zones on for a FEW SECONDS to burn off any grease left over from the manufacturing process The ceramic glass retains heat, so to make best use of the residual heat, switch off the zone five minutes prior to the end of cooking. To reduce the cooking time, the zone can be set to the maximum setting at the beginning of cooking, and then reduced during cooking time. The hob is equipped with zones of different sizes, de
ページ7に含まれる内容の要旨
Care and Maintenance Always disconnect the appliance from the power supply before undertaking any cleaning or maintenance. You should use a non-abrasive cleaner to clean the hob top. Any abrasive cleaner (including Cif) will scratch the surface and could erase the control panel markings. Types of residues Clean with Cleaning advice Wipe over the zone to be cleaned with a sponge and hot Light Cleaning sponge and soft cloth water, and then wipe off with a soft dry cloth. Wipe over the zone to
ページ8に含まれる内容の要旨
Mains Electricity Connection Warning! this appliance must be earthed We recommend that the appliance is connected by a qualified electrician, who is a member of the N.I.C.E.I.C. and who will comply with the I.E.E. and local regulations. This appliance is intended to be connected to fixed wiring and is not suitable for connection to a 13a plug or 13a supply. This appliance is intended to be connected to fixed wiring by a double pole switch, having a contact separation of at least 3mm in all po
ページ9に含まれる内容の要旨
Fitting the Hob Unpacking the hob: • Take care not to lose or mishandle any parts. Fitting position of the hob: This appliance must be installed a minimum of 50mm from any back wall and a minimum of 190mm away from any adjacent vertical surfaces, e.g. a tall cupboard end panel. This may be reduced to 100mm if the adjacent surface is resistant to fire (tiles or steel, for example). These dimensions are shown in Fig.4. If fitting a cooker hood above the hob: If a cooker hood is to
ページ10に含まれる内容の要旨
How to Install the Hob How to install the hob: Overall dimensions of the hob: Width: 580mm Depth: 510mm Worktop cut-out dimensions: Width: 560mm Depth: 490mm 1. Make the required hole in the worktop. Before doing this, you must check the instructions supplied with any cooker hood to ensure that you will have the required clearance. The cut-out (Fig.4) shows a 60mm gap from the wall to the cut-out edge. The distance from the hob, when fitted, to the back wall is 50mm. If a splashback/wo
ページ11に含まれる内容の要旨
ページ12に含まれる内容の要旨
To contact our Customer Care Department, or for Service, please contact us on the details below. Passionate about style Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.eu Dis.S506__-909 Cod.099230009833 Rev.1 del 11/10
