ページ1に含まれる内容の要旨
HCC570 ceramic hob
Manual for Installation, Use and Maintenance
Passionate about style
Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY
T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.eu
ページ2に含まれる内容の要旨
Contents: 1 Important notes 2 User information 3 Using your hob 4 Efficient use of your hob 5 Care and maintenance 6 Mains Electricity Connection 7 Fitting the hob 8 How to install the hob
ページ3に含まれる内容の要旨
Important The CDA Group Ltd cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note that CDA reserve the right to invalidate the guarantee supplied with this product following incorrect installation or misuse of the appliance or use in a commercial environment. This appliance is not designed to be used by people (including children) with reduced physical, sensorial or mental capacity, or who lack experience or knowledge about it,
ページ4に含まれる内容の要旨
User information Please note: • Ceramic hobs become hot and remain hot during and immediately after use. Do not touch the hob until it has been allowed to cool. • Keep children away from the appliance when in use. • Never put cooking foil or plastic materials on the ceramic surface when the hob is hot. These materials could melt and cause damage to the hob. • Never use the hob top for storage. • Pan handles should never stand out beyond the edge of the worktop. This will ensure chil
ページ5に含まれる内容の要旨
Using your hob Zones: 1. Front left 1.7 kW 180 mm 2 2. Back left 1.2 kW 145 mm 3 3. Back right 1.7 kW 180 mm 4. Front right 1.2 kW 145 mm Control panel: 1 5. Front right zone control 4 6. Back right zone control 7. Back left zone control 8. Front left zone control 9. Residual heat indicator lights 10. Power indicator light 10 9 8 7 6 5 Fig.1 Residual heat indicator: To warn when the zone is still hot after the power is switched off, the residual heat indicator will be lit for that zon
ページ6に含まれる内容の要旨
Efficient Use of your Hob The hob is equipped with zones of different sizes, designed to accommodate most shapes and sizes of pan. For best results, only use pans with flat bottoms and choose an appropriate zones depending on the size of the pan. The most efficient use of the hob is shown below, where the pan and zones are correctly chosen. Use pan lids where possible to minimize the energy usage of your appliance. Turn off each zone a few minutes before the end of cooking time. The residual h
ページ7に含まれる内容の要旨
Care and Maintenance Always disconnect the appliance from the power supply before undertaking any cleaning or maintenance. You should use a non-abrasive cleaner to clean the hob top. Any abrasive cleaner (including Cif) will scratch the surface and could erase the control panel markings. Types of residues Clean with Cleaning advice Wipe over the zone to be cleaned with a sponge and hot Light Cleaning sponge and soft cloth water, and then wipe off with a soft dry cloth. Wipe over the zone to b
ページ8に含まれる内容の要旨
Mains Electricity Connection Warning! This appliance must be earthed We recommend that the appliance is connected by a qualified electrician, who is a member of the N.I.C.E.I.C. and who will comply with the I.E.E. and local regulations. This appliance is intended to be connected to fixed wiring and is not suitable for connection to a 13A plug or 13A supply. This appliance is intended to be connected to fixed wiring by a double pole switch, having a contact separation of at least 3mm in all po
ページ9に含まれる内容の要旨
Fitting the Hob Unpacking the hob: • Take care not to lose or mishandle any parts. Fitting position of the hob: This appliance must be installed a minimum of 50mm from any back wall and a minimum of 190mm away from any adjacent vertical surfaces, e.g. a tall cupboard end panel. This may be reduced to 100mm if the adjacent surface is resistant to fire (tiles or steel, for example). These dimensions are shown in Fig.4. If fitting a cooker hood above the hob: If a cooker hood is to
ページ10に含まれる内容の要旨
How to Install the Hob How to install the hob: Overall dimensions of the hob: Width: 580mm Depth: 510mm Worktop cut-out dimensions: Width: 560mm Depth: 490mm 1. Make the required hole in the worktop. Note that before doing this, check the instructions supplied with any cooker hood to ensure that you will have the required clearance. The cut-out (Fig 4) shows a 61.5mm gap from the wall to the cut-out edge. The distance for the hob, when fitted, to the back wall is 50mm. 2. Position th
ページ11に含まれる内容の要旨
9
ページ12に含まれる内容の要旨
To contact our Customer Care Department, or for Service, please contact us on the details below. Passionate about style Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.eu
