ページ1に含まれる内容の要旨
HG654440SM EN GAS HOB USER MANUAL
IE GB
ページ2に含まれる内容の要旨
2 FOR PERFECT RESULTS Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler – features you might not find on ordinary appliances. Please spend a few minutes reading to get the very best from it. ACCESSORIES AND CONSUMABLES In the AEG webshop, you’ll find everything you need to keep all your AEG appliances looking spotless and working perfectly. Along with a wide range of accessories
ページ3に含まれる内容の要旨
Contents 3 CONTENTS 4 Safety information 6 Installation 12 Product description 13 Operation 14 Helpful hints and tips 15 Care and cleaning 17 What to do if… 18 Technical data 19 Environment concerns The following symbols are used in this user manual: Important information concerning your personal safety and information on how to avoid damaging the appliance. General information and tips Environmental information Subject to change without notice
ページ4に含まれる内容の要旨
4 Safety information SAFETY INFORMATION WARNING! These instructions are only valid in the countries whose symbols appear on this booklet's cover. For your safety and correct operation of the appliance, read this manual carefully before installation and use. Always keep these instructions with the appliance even if you move or sell it. Users must fully know the operation and safety features of the appliance. General safety WARNING! Persons (including children) with reduced physical sensory, ment
ページ5に含まれる内容の要旨
Safety information 5 • Pots must not enter the control zone. • Do not use not stable cookware to prevent from tilt and accident. • Do not put flammable products or items that are wet with flammable products, and/or fusible objects (made of plastic or aluminium) and/or fabrics in, near or on the appliance. There is the risk of explosion or fire. • Use only the accessories supplied with appliance. • Be careful when you connect the appliance to the near sockets. Do not let electricity bonds touch t
ページ6に含まれる内容の要旨
6 Installation • This appliance is not connected to a combustion products evacuation device. It must be installed and connected in accordance with current installation regulations. Particular attention must be given to the relevant requirements regarding ventilation. • The use of a gas cooking appliance cause heat and moisture in the room in which it is installed. Make sure that the ventilation in the kitchen is good: keep natural venti- lation holes open or install a mechanical ventilation devi
ページ7に含まれる内容の要旨
Installation 7 Important safety requirements This hob must be installed in accordance with the Gas Safety (Installation and Use) Regula- tions (Current Edition) and the IEE Wiring Regulations (Current Edition). For appliances installed in the Republic of Ireland please refer to NSAI- Domestic Gas Instal- lation I.S. 813 Current Editions and the ETCI Rules for Electrical Installations. Provision for ventilation Detailed recommendations are contained in the following British Standards Codes Of Pra
ページ8に含まれる内容の要旨
8 Installation 1 2 3 1 End of shaft with nut 2 Washer 3 Elbow Connection to the gas supply should be with either rigid or semi-rigid pipe, i.e. steel or cop- per. The connection should be suitable for connecting to R 1/2 (1/2 BSP male thread). When the final connection has been made, it is essential that a thorough leak test is carried out on the hob and installation. Make sure that the main connection pipe does not exert any strain on the hob. If you use flexible metal pipes make sure that they
ページ9に含まれる内容の要旨
Installation 9 1. Light the burner. 2. Turn the knob on the minimum position. 3. Remove the knob. 4. With a thin screwdriver, adjust the by-pass screw position. 1 1 The by-pass screw – If you change from natural gas 20 mbar to liquid gas, fully tighten the by-pass screw in. – If you change from liquid gas to natural gas 20 mbar, undo the by-pass screw ap- proximately 1/4 of a turn (1/2 of a turn for Triple Crown burner). WARNING! Make sure the flame does not go out when you quickly turn the knob
ページ10に含まれる内容の要旨
10 Installation This hob is designed to be connected to a 230 V 50 Hz AC electrical supply. Before switching on, make sure the electricity supply voltage is the same as that indicated on the hob rating plate. The rating plate is located on the bottom of the hob. The hob is supplied with a 3 core flexible supply cord incorporating a 3 amp plug fitted. In the event of having to change the fuse, a 3 amp ASTA approved (BS 1362) fuse must be used. 1 2 3 4 5 1 Green and Yellow 2 3 amp fuse 3 Brown 4 C
ページ11に含まれる内容の要旨
Installation 11 Replacement of the connection cable To replace the connection cable use only H05V2V2-F T90 or equivalent type. Make sure that the cable section is applicable to the voltage and the working temperature. The yellow/ green earth wire must be approximately 2 cm longer than the brown (or black) phase wire. Building In min. 600 mm min. 450 mm min. 650 mm A min. 55 mm 30 mm 10 mm 560 mm 11 mm 3 mm 11 mm A - supplied seal A B A - supplied seal B - supplied brackets Possibilities for inse
ページ12に含まれる内容の要旨
12 Product description b) Space for connections Kitchen unit with oven The hob recess dimensions must obey the indication and the kitchen unit must be equipped with vents to let a continuous supply of air. The electrical connection of the hob and the oven must be installed separately for safety reasons and to let easy remove oven from the unit. 2 2 50 cm 120 cm 2 2 180 cm 360 cm MANUFACTURER: ELECTROLUX ITALIA S.p.A. C.so Lino Zanussi, 30 33080 PORCIA (PN) - ITALIA PRODUCT DESCRIPTION Cooking su
ページ13に含まれる内容の要旨
Operation 13 OPERATION Ignition of the burner WARNING! Be very careful when you use open fire in kitchen environment. Manufacturer decline any responsibility in case misuse of the flame Always light the burner before you put cookware. To light the burner: 1. Turn the control knob counterclockwise to the maximum position ( ) and push it down. 2. Keep the control knob pushed for approximately 5 seconds; this will let thermocouple to warm up. If not, the gas supply will be interrupted. 3. Adjust
ページ14に含まれる内容の要旨
14 Helpful hints and tips 1 Burner cap 2 Burner crown 3 Ignition candle 4 Thermocouple WARNING! Do not keep the control knob pushed for more than 15 seconds. If the burner does not light after 15 seconds, release the control knob, turn it into off posi- tion and try to light the burner again after minimum 1 minute. In the absence of electricity you can ignite the burner without electrical device; in this case approach the burner with a flame, push the relevant knob down and turn it counter-clock
ページ15に含まれる内容の要旨
Care and cleaning 15 WARNING! Use pots and pans with diameter applicable to the dimension of burner. Do not use cooking vessels on the hotplate that overlap its edges. Burner Diameters of cookware Triple Crown 180 - 260 mm Front Semi-rapid 120 - 180 mm Rear Semi-rapid 120 - 220 mm Auxiliary 80 - 160 mm WARNING! Pots must not enter the control zone. WARNING! Make sure pot handles do not protrude over the front edge of the cooktop and that pots are centrally positioned on the rings in order to ach
ページ16に含まれる内容の要旨
16 Care and cleaning • Stainless steel parts wash with water, and then dry with a soft cloth. • The pan supports are not dishwasher proof; they must be washed by hand. • When you wash the pan supports by hand, take care when you dry them as the enamel- ling process occasionally leaves rough edges. If necessary, remove stubborn stains using a paste cleaner. • Make sure you position the pan supports correctly after cleaning. • To make burners work correctly, make sure that the arms of the pan supp
ページ17に含まれる内容の要旨
What to do if… 17 WHAT TO DO IF… Problem Possible cause Remedy There is no spark when lighting • There is no electrical supply • Make sure that the unit is the gas connected and the electrical supply is switched on. • Control the fuse. If the fuse is released more than one time, refer to a qualified electrician. • Burner cap and crown are • Make sure that the burner placed uneven cap and crown are in correct positions. The flame is blow out immedi- • Thermocouple is not heated • After lightning
ページ18に含まれる内容の要旨
18 Technical data 1 2 3 MOD. MOD. MOD. TYPE PROD.NO. 230V-50Hz PROD.NO. PROD.NO. SER.NO. IP20 0049 SER.NO SER.NO 03 IT MADE IN ITALY DATA DATA MODEL MODEL 1 Stick it on Guarantee Card and send this part 2 Stick it on Guarantee Card and keep this part 3 Stick it on instruction booklet These data are necessary to help you quickly and correctly. These data are available on the supplied rating plate. • Model description ................. • Product number (PNC) ................. • Serial Number (S.
ページ19に含まれる内容の要旨
Environment concerns 19 Electric supply: 230 V ~ 50 Hz 3 core flexible cable with non rewireable plug fitted with a 3 amp cartridge fuse Gas connection: G 1/2 " Category: II2H3+ Gas supply: G20 (2H) 20 mbar Appliance class: 3 By-pass diameters Burner Ø By-pass in 1/100 mm. Auxiliary 28 Semi-rapid 32 Triple Crown 56 Gas burners NORMAL POWER NORMAL REDUCED LPG NATURAL GAS POWER POWER (Butane/Propane) G30/G31 (3+) G20 (2H) 20 mbar 28-30/37 mbar BURNER G30 G31 28–30 inj. 1/100 inj. 1/100 37 mbar kW
ページ20に含まれる内容の要旨
20 Packaging material The packaging materials are friendly to the environment and can be recycled. The plastic components are identified by marking: >PE<,>PS<, etc. Discard the packaging materials as household waste at the waste disposal facilities in your municipality.
