ページ1に含まれる内容の要旨
GE Consumer & Industrial
Technical Service Guide
JUNE 2006
Advantium 120
SCB 1000
SCB 1001
ZSC 1000
ZSC 1001
31-9141
GE Appliances
General Electric Company
Louisville, Kentucky 40225
– 1 –
ページ2に含まれる内容の要旨
IMPORTANT SAFETY NOTICE The information in this service guide is intended for use by individuals possessing adequate backgrounds of electrical, electronic, and mechanical experience. Any attempt to repair a major ap pli ance may result in personal injury and property damage. The man u fac tur er or seller cannot be responsible for the in ter pre ta tion of this in for ma tion, nor can it assume any liability in connection with its use. WARNING To avoid personal injury, disconnect power before
ページ3に含まれる内容の要旨
PRECAUTIONS TO BE OBSERVED BEFORE AND DURING SERVICING TO AVOID POSSIBLE EXPOSURE TO EXCESSIVE MICROWAVE ENERGY. A. DO NOT OPERATE OR ALLOW THE OVEN TO BE OPERATED WITH THE DOOR OPEN. B. IF THE OVEN OPERATES WITH THE DOOR OPEN, INSTRUCT THE USER NOT TO OPERATE THE OVEN AND CONTACT THE MANUFACTURER IMMEDIATELY. C. MAKE THE FOLLOWING SAFETY CHECKS ON ALL OVENS TO BE SERVICED BEFORE ACTIVATING THE MAGNETRON OR OTHER MICROWAVE SOURCE, AND MAKE REPAIRS AS NECESSARY: 1. INTERLOCK OPERATION.
ページ4に含まれる内容の要旨
Table of Contents Blower Assembly ..............................................................................................................................................................32 Capacitor and Diode .......................................................................................................................................................30 Cavity Light ......................................................................................................................
ページ5に含まれる内容の要旨
Nomenclature Model Number S C B 1 0 0 0 D B B GE Speedcook Technology Exterior Color SC =GE Profi le BB = Black ZS = Monogram CC = Bisque SS = Stainless Steel WW = White Confi guration B = Wall Oven C = Monogram Wall Oven Model Year Designator Model Designator 1000 = Color Model 1001 = Stainless Steel Model Serial Number The fi rst two characters of the serial number Nomenclature identify the month and year of manufacture.
ページ6に含まれる内容の要旨
Introduction The new Advantium oven uses breakthrough Speedcook technology to harness the power of light. The Advantium oven cooks the outside of foods much like conventional radiant heat, while also penetrating the surface so the inside cooks simultaneously. While halogen light is the primary source of power, a "microwave boost” is added with certain foods. Foods cook evenly and fast, retaining their natural moisture. Features and Benefi ts Speedcook Oven - Delivers oven quality food up to fo
ページ7に含まれる内容の要旨
T P C R E E L S E S S T OVEN MICROWAVE O START SPEED BAKE FAVORITE PAUSE BACK HELP COOK EXPRESS RECIPES COOK BROIL CUSTOM WARM DEFROST POWER SPEED COOK REHEAT TIMER CLEAR OPTIONS PROOF TEMP FAN MSG REM MUTE TIMER OFF Turntable Upper Halogen Lamp/Ceramic Heater The turntable must always be in Operates when using speedcook or place, on the oven floor, for all broil. cooking. Be sure the turntable is Window seated securely over the spindle Allows cooking to be viewed while in the center of the ov
ページ8に含まれる内容の要旨
T P C R E E L S E S S T O Control Features With your Advantium oven, you can cook with high-intensity halogen lights, ceramic heaters and convection heating element, and/or conventional microwave energy. OVEN MICROWAVE START FAVORITE SPEED BAKE BACK HELP PAUSE COOK EXPRESS RECIPES COOK BROIL WARM CUSTOM POWER DEFROST REHEAT TIMER OPTIONS SPEED COOK CLEAR PROOF TEMP FAN MSG REM MUTE TIMER OFF LOCK/UNLOCK HOLD 5 SECONDS SPEEDCOOK/Repeat Last Display Press this pad to access the pre-set Shows
ページ9に含まれる内容の要旨
To remind you that you have food in the oven, the Cooking Times oven will display COOK TIME COMPLETED and beep once a minute until you either open the oven door ■ When speedcooking preprogrammed or press the CLEAR/OFF pad. foods, you may see OPTIMIZING COOK TIME in the display several seconds after you press START/PAUSE. The oven automatically senses the electrical voltage level in your home and ORITE adjusts the cooking time up or CIPES down for proper cooking. MER Fan/Vent FAN MSG REM MU
ページ10に含まれる内容の要旨
Speed Cook System Halogen Lamp and Ceramic Heaters • One 500 watt halogen bulb and one 700 watt ceramic heater cook food from above. • One 375 watt ceramic heater cooks food from below. Rear Convection Heat Element • Operates when using bake. Microwave • A microwave “boost” is automatically added with certain foods. • The oven can also be used as a 975 watt microwave oven (Continued Next Page) – 10 –
ページ11に含まれる内容の要旨
Speedcook Power Levels Lower Heater Advantium uses power from a high-intensity The lower heater is a 375 watt ceramic heater. halogen light, ceramic heaters, and microwaves It operates in speedcook, oven/bake, and warm to cook food from the top, bottom, and interior modes. The lower heater assists in browning foods simultaneously, sealing in moisture and fl avor. on the bottom. When using preset Speedcook recipes on the food Microwave Energy menu, power levels are preselected. However, these
ページ12に含まれる内容の要旨
The following chart shows the predicted Thermal Compensation compensation times based on a 12-minute Note: Thermal compensation only occurs when speedcook selection (such as Biscuits, Refr; Large). using a preselect menu item in Speedcook. These items require compensation for accurate and Voltage Compensation Chart consistent cooking results. When cooking several food items consecutively, the Voltage Time Change (Seconds) temperature in the oven may become very high. 108 +180 When Speedc
ページ13に含まれる内容の要旨
Speedcook Power Level Chart Upper Heater Lower Heater Upper Power Lower Power Microwave On Level Level Time On Time On Time Hi 100% 100% 0% Hi Lo 100% 80% 0% Hi 100% 70% 0% Medium Hi Lo 100% 65% 0% Hi 90% 90% 10% Med Lo 90% 65% 10% Hi 80% 70% 20% Med Lo Lo 70% 70% 30% Hi 60% 60% 40% Lo Lo 30% 30% 70% – 13 –
ページ14に含まれる内容の要旨
Installation Advance Planning Electrical Requirements • These ovens may be installed directly into a 27- Single Advantium 120 Installation in. or 30-in. wide oven cabinet. This product requires a 120 volt, 60 Hz, 15 amp • The front surface of the oven will be nearly fl ush circuit and draws 1.8 kilowatts. This product must be with surrounding cabinet doors. connected to a supply circuit of the proper voltage and frequency. • This oven can be installed over any GE or Monogram single electric
ページ15に含まれる内容の要旨
Component Locator Views Front View Control Panel Assembly Convection Fan Assembly Turntable Main Component Locator View Blower Motor Power Transformer Convection Heater Assembly Damper Assembly Capacitor Thermistor Magnetron Fuse and Noise Filter (Continued Next Page) – 15 –
ページ16に含まれる内容の要旨
Top View High Voltage Transformer Diode Damper Assembly Upper Heater Assembly Magnetron Fuse Capacitor Upper Heater TCO Blower Assembly Low Voltage Transformer Power Board Relay Board Bottom View Turntable Motor Lower Heater Assembly (Continued Next Page) – 16 –
ページ17に含まれる内容の要旨
Left Side View Control Panel Assembly Low Voltage Transformer Humidity Sensor Oven Cavity TCO Lower Heater Assembly Right Side View Control Panel Assembly Fuse Blower Assembly Noise Filter Right Side Door Switch Assembly (Continued Next Page) – 17 –
ページ18に含まれる内容の要旨
Control Panel Assembly (Shown separated) Control Panel Display Board Selector Board Control Board Low Voltage Transformer Power Board Relay Board Control Panel Bracket – 18 –
ページ19に含まれる内容の要旨
Control Boards and Panel Connections Power Board CN5 CN8 CN6 CN7 CN11 CN4 CN4 - Control Board CN5 - Humidity Sensor CN6 - Door Secondary Sensing Switch and Damper Door Sensing Switch CN7 - Low Voltage Transformer (Secondary Windings) CN8 - Thermistor CN11 - Relay Board (Continued next page) – 19 –
ページ20に含まれる内容の要旨
Relay Board CN1 CN2 RY7 RY8 RY11 RY9 RY2 CN3 CN1 - Low Voltage Transformer (Primary Winding) CN2 - Connection to Door Switch, Heater, and Turntable Motor CN3 - Control Board RY2 - High Voltage Transformer RY7 - Convection Heater RY8 - Upper Heater (Ceramic) RY9 - Lower Heater RY11 - Upper Heater (Halogen) Control Board CN10 CN9 CN4 CN3 CN13 CN3 - Relay Board CN4 - Power Board CN9 - Selector Board CN10 - Display Board 20-Pin Connector CN13 - Selector Board (Continued next page) – 20 –
