ページ1に含まれる内容の要旨
SV500 Pyrolytic Oven
Manual for Installation, Use and Maintenance
Passionate about style
Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY
T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.eu
ページ2に含まれる内容の要旨
Important This appliance must only be used for the purpose for which it is intended, i.e. domestic cooking. Any other use could be dangerous and may lead to premature failure of the appliance. This appliance is not designed to be used by people (including children) with reduced physical, sensorial or mental capacity, or who lack experience or knowledge about it, unless they have had supervision or instructions on how to use the appliance by someone who is responsible for their safety. Under no
ページ3に含まれる内容の要旨
Important Read the user instructions carefully before using the oven for the first time. Clean the oven regularly. Remove spills as soon as they occur. Always use oven gloves when removing shelves and trays from the ovens. Do not allow children near the oven when in use. Do not lean on the oven door, or place heavy items on the door. Make sure that children do not climb or sit on the door when it is open. Do not pull the oven by the handle. Do not allow fat or oils to build up on the oven shel
ページ4に含まれる内容の要旨
9 9 3 2 Using your oven A B C D E Fig.2 A Display B Temperature Control Knob C Function Control Knob D Oven Light E Shelf supports 3 6 4 8 7
ページ5に含まれる内容の要旨
The Control Panel and Display A B C D I E F H G Fig.3 A Clock display B Door lock indicator C Eco cooking indicator D Minute minder indicator E End time indicator F Cooking time indicator G Time setting keys H Timer selection key I Temperature display 4
ページ6に含まれる内容の要旨
Fitting Out Your Appliance 1. Side racks (E on fig. 4) The side racks allow five different cooking heights for the drip tray and shelf. When cooking using the grill functions and rotisserie, use the drip tray or shelf at height 5 to collect the juices from the food. 2. Drip tray (figure 4) Fig. 4 The enamel drip tray can be used for baking cakes or placed underneath the shelf to collect the juices from grilling. Avoid placing roasts or meats directly in the drip tray, as this will cause s
ページ7に含まれる内容の要旨
General Settings and Use Clock To set the clock when the time and the clock indicator are flashing (for example, when the oven is first switched on) touch or until the correct time shows on the display, then touch to confirm the selection. The oven will beep to confirm the selection and the clock and clock indicator will stop flashing. To set the clock once the time has been set (when the clock is not flashing) touch and hold for three seconds until the clock and the clock indicator flas
ページ8に含まれる内容の要旨
General Settings and Use To programme the oven Turn the function control knob to the required programme. The display will flash the temperature preset for the programme (as detailed on page 8) and start cooking immediately. To change the temperature, turn the temperature control knob until the required temperature shows on display. The temperature will flash on the display whilst the oven heats up. Once the oven has reached the required temperature, the oven will beep three times and the tem
ページ9に含まれる内容の要旨
General Settings and Use Oven functions Each of the oven functions uses different elements within the oven to offer you the best choice of cooking every time. The cooking functions are explained below. The pyrolytic functions are explained on page xxx. 1. Fan Oven – preset 180˚ (range available 35-235˚) Using the fan element and the fan, this cooking function blows the hot air into and around the oven cavity. Temperatures are achieved quicker, reducing or even removing the need for preheating
ページ10に含まれる内容の要旨
General Settings and Use 7. Full Grill – preset 275˚ (range available 180-275˚) The grill function radiates the heat from the grill element. The fully temperature variable grill is ideal for grilling anything up to a full family meal (full grill) This function can be used in conjuction with the rotisserie, which will turn until the door is opened. When the rotisserie is used, put the drip tray on the lowest shelf level. FOR EACH GRILL FUNCTION, PLEASE NOTE: • Always grill with the oven door c
ページ11に含まれる内容の要旨
Pyrolysis Programmes This oven can clean itself by a process known as pyrolysis, heating the cavity to a temperature of 500˚C. This will burn off the residue from spattering and spillages caused by cooking. Pyrolytic programmes should be used when the oven smokes during preheating or cooking or if the oven smells even when cold. It is not necessary to run a pyrolytic programme after every use of the oven, as shown in the table below. Do not wait until the oven is coated in grease to run
ページ12に含まれる内容の要旨
Cleaning and Maintenance IMPORTANT: Always disconnect the appliance from the power supply before undertaking any cleaning or maintenance. You should always allow the oven to cool fully after use before undertaking any cleaning or maintenance. You should only use non-abrasive cleaners. Any abrasive cleaners (including Cif) will scratch the surface and could erase the control panel markings. You should not cleaning products with a chlorine or acidic base. Any spillages should be cleaned off im
ページ13に含まれる内容の要旨
26 Replacing the Halogen ven Light O WARNING: Ensure the applian ce is switched o before replacing the lamp to avoid the possibility of electric sho ck. – Let the ven o acvity and the heating elements to cool down; – Swi tc Top Right Lamp: – Remove the rot pecti ve cover C (fig. 8); – Repla ce the halogen lamp B with a new one sui table for high temperatures having the following specifications: 230V and same power (check watt power as tamped in the lamp itself) of the s repla ced lamp. IMPORTA
ページ14に含まれる内容の要旨
Care and Maintenance Cleaning the interior of the door Open the door completely and insert two of the red stoppers supplied with the oven, as shown in figure 10. Then insert the other two red stoppers in the A slots, as shown in figure 11. Lever the stoppers to lift the frame and the glass from the door, as shown in figure 12. Fig. 10 Remove the inner frame and the panes of glass as shown in figure 13, ensuring you put them on a soft flat surface to prevent damage. A Fig. 11 Fig. 12 Fig. 13
ページ15に含まれる内容の要旨
Care and Maintenance Clean the panes of glass using a soft sponge and washing up liquid. Do not soak the glass in water. Do note use abrasive cleaning products, metallic scrapers or scouring sponges. These could scuff the surface and cause the glass to shatter. Rinse with clean water and dry off with a lint-free cloth. Fig. 14 The inner glass assembly can be removed for cleaning if necessary. Each pane of glass has a black corner pad which much be replaced in their original position, as s
ページ16に含まれる内容の要旨
Troubleshooting If the oven is not functioning correctly, check the advice below prior to calling CDA Customer Care. Problem Possible Cause Advice Check the oven is switched on at the The oven does not heat up There is no power supply to the oven cooker point and the fuse/circuit breaker has not activated. The padlock on the display is flashing Door lock system fault Call CDA Customer Care The oven light is not working Light fault Replace the bulb The pyrolysis programmes do not start The do
ページ17に含まれる内容の要旨
Installation Important If the oven is being installed into a built under oven housing unit ensure that the front rail at the top of the unit is not installed as it could restrict ventilation. Ensure that air can flow freely around the housing area. If the oven is being installed into a fully enclosed built-under oven housing unit it may be necessary to cut a small slot in the top of the plinth fitted under the unit. Cut a section 400mm wide and a minimum of 15mm high to allow air to pass unde
ページ18に含まれる内容の要旨
Mains Electricity Connection Warning! This appliance must be earthed We recommend that the appliance is connected by a qualified electrician, who is a member of the N.I.C.E.I.C. and who will comply with the I.E.E. and local regulations. This appliance is intended to be connected to fixed wiring and is not suitable for connection to a 13A plug or 13A supply. This appliance is intended to be connected to fixed wiring by a double pole switch, having a contact separation of at least 3mm in all po
ページ19に含まれる内容の要旨
18
ページ20に含まれる内容の要旨
To contact our Customer Care Department, or for Service, please contact us on the details below. Passionate about style Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.eu
