ページ1に含まれる内容の要旨
DIAMOND VIEW MONITORS DIAMOND VIEW MONITORS DIAMOND VIEW MONITORS DIAMOND VIEW MONITORS
A REGISTERED TRADE MARK OF MITSUBISHI ELECTRIC AUSTRALIA PTY. LTD.
1554R
Colour Monitor
15” (38.1cm) CRT Size,
13.9” (35.4cm) Max. Viewable Area
User’s Manual
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
Table of Contents Safety Instructions for Display Monitors........................................................................................ii Maintenance................................................................................................................................................iii Chapter 1 Introduction ......................................................................................................................................1 Unpacking the Package........
ページ4に含まれる内容の要旨
ページ5に含まれる内容の要旨
Copyright Copyright © 2000 Mitsubish Electric Australia Pty. Ltd All rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system or translated into any language or computer language, in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual or otherwise, without the prior written permission of this company. Disclaimer Mitsubish Electric Australia Pty. Ltd makes no representations or warranties, e
ページ6に含まれる内容の要旨
Safety Instructions for Display Monitors 1. The AC plug isolates this equipment from the AC Power supply. 2. Unplug the monitor from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning. 3. Slots and openings in the cabinet and the back or bottom are provided for ventilation. They must not be blocked or covered. This computer monitor should never be placed near or over a radiator or heat register, or in a built-in installation
ページ7に含まれる内容の要旨
Maintenance ✘ Do not expose the monitor to direct sunlight or heat. ✘ Do not spill liquid onto the monitor. ✘ Do not attempt to open the monitor. You may be hurt by electric shock. For service, call your place of purchase. Opening your monitor may also void warranty. ✘ Do not use your monitor when magnets or electronic products are operating nearby. ✘ Do not use harsh chemicals or strong cleaning solvents to clean the monitor screen. Wipe it with clean, soft clothes applied with m
ページ8に含まれる内容の要旨
ページ9に含まれる内容の要旨
Introduction 1 Unpacking the Package Check following items. If they are missing or damaged, consult your place of purchase immediately. Colour monitor Swivel base User’s manual Power cord Locate the model name and the serial number labeled on the back of your monitor. Write down the related information of your monitor and dealer in the space on page ii for future reference. Features Your 1554R has the following features: Plug’n Play Compatibility With its DDC1
ページ10に含まれる内容の要旨
Power Saving Function The power management complies with VESA DPMS standard. When the system is idle (off mode), the monitor automatically cuts its power consumption up to 95%. Green Commitment No CFCs are used in the manufacturing process of your monitor. It complies with the US government’s Energy Star standards and the rigorous standards of the Scandinavian countries. Power Management The power management of this monitor complies with these VESA power saving modes: Mode Powe
ページ11に含まれる内容の要旨
Getting Started 2 Installing the Monitor This monitor is equipped with an autosensing power supply for voltage ranges 100~240V AC, 50~60Hz. To install the monitor : 1. Make sure that the system power is turned off. 2. Please refer to the instructions below to connect the signal cable through D-SUB . 3. Connect the power cord to the monitor and attach it to power source. 4. Turn on the computer and the monitor. 3
ページ12に含まれる内容の要旨
Connecting through D-SUB signal connector 1. Make sure that the system power is turned off. 2. Connect the computer end of the D-SUB cable to the 15-pin output connector on the video board of your computer. To connect the monitor to an older type Apple Macintosh through a D-Sub cable, you need to use an Apple Macintosh signal adaptor to connect the video signal port of your computer to the monitor signal cable. Adaptors are available from Mitsubishi Electric Australia. Pleas
ページ13に含まれる内容の要旨
Adjusting the Monitor 3 Control Functions The monitor digital control functions are located on the front panel (see the illustration below). They are described in the following sections. 1. Power Switch Pincushion Horizontal Size 2. Adjust Vertical Center Contrast 3. Select Vertical Size Brightness Trapezoid Horizontal Phase Rotation 5
ページ14に含まれる内容の要旨
Select / Adjust Press the SELECT + or - button to cycle through the adjustment options to choose H-Phase, H-Size, V-Center, V-Size, Contrast, Brightness, Trapezoid, Pincushion and Rotation. And then press ADJUST + or - button to change the settings. Recall Recall all settings to factory defaults by pressing both function keys of SELECT + and ADJUST - . Timing Setting By making adjustments of your video card settings, you can set the timing and the refresh rate to your preferences
ページ15に含まれる内容の要旨
Troubleshooting and Useful Hints 4 Troubleshooting Make sure that your monitor is properly installed if you encounter any trouble using this product (For hardware installation, see Chapter 2, Getting Started). If the problems persist, check this chapter for possible solutions. There is no picture on the screen. Check: Video sync signal. The video sync signal from the graphics card must be as specified for the monitor. Power saving mode. Press any key and move the mouse
ページ16に含まれる内容の要旨
Need More Help? If your problems remain after checking this manual, please contact your place of purchase or contact: Australia Visit the Mitsubishi Electric Australia web site at www.mitsubishi-electric.com.au Or contact the Service Department for your state: New South Wales and Australian Victoria and Tasmania Capital Territory 4 / 303 Burwood Hwy 348 Victoria Road East Burwood, 3151
ページ17に含まれる内容の要旨
Specifications 5 Picture Tube Size 15” (38.1cm) diagonal Type FST Dot pitch 0.28mm Surface coating AG, AS coating Maximum Viewable Size 13.9” (35.4cm) diagonal Power Supply (Universal) Input voltage 100~240 V AC, 50~60 Hz (Universal) Power consumption(Max.) 75 w Max. Resolution 1024 x 768 Horizontal Frequency 30-54 KHz Vertical Frequency 50-120 Hz Video Bandwidth 65 MHz Video Input mini D-sub connector Adjustable Timing 6 factory presets, 10 user modes User’s Con
