ページ1に含まれる内容の要旨
SyncMaster 2494HS/2494HM
LCD Monitor
User Manual
ページ2に含まれる内容の要旨
Safety Instructions Notational Note These safety instructions must be followed to ensure your safety and prevent property dam- age. Make sure to read the instructions carefully and use the product in the correct manner. Warning / Caution Otherwise, it may result in death or personal injury. Otherwise, it may result in personal injury or property damage. Notational Conventions Important to read and under- Prohibited stand at all times Disconnect the plug from the Do not disassemble outlet Grou
ページ3に含まれる内容の要旨
Safety Instructions Ensure that the power plug is plugged into the power outlet firmly and correctly. • Otherwise, this may result in fire. Do not forcefully bend or pull the power plug and do not place any heavy material on it. • Otherwise, this may result in fire. Do not connect multiple appliances to the same power outlet. • Otherwise, this may cause fire due to overheating. Do not disconnect the power cord while using the product. • Otherwise, this may result in damage to the product due
ページ4に含まれる内容の要旨
Safety Instructions DO NOT PLACE CANDLES, MOSQUITO REPELLANT, CIG- ARETTES AND ANY HEATING APPLIANCES NEAR THE PRODUCT. • Otherwise, this may result in fire. Keep heating appliances as far away from the power cord or the product as possible. • Otherwise, this may result in electric shock or fire. Do not install it in a badly ventilated location such as a bookcase or closet. • Otherwise, this may result in fire due to an increase in the in- ternal temperature. Put down the monitor carefully.
ページ5に含まれる内容の要旨
Safety Instructions Clean the product using a soft cloth with a monitor cleaner only. If you must use a cleaner other than the monitor cleaner, dilute it with water at a ratio of 1:10. When cleaning the power plug pins or dusting the power outlet, clean it with a dry cloth. • Otherwise, it may result in fire. When cleaning the product, make sure to disconnect the power cord. • Otherwise, it may result in electric shock or fire. When cleaning the product, disconnect the power cord and clean i
ページ6に含まれる内容の要旨
Safety Instructions When you drop the product or the case is broken, turn the power off and disconnect the power cord. Contact a Service Center. • Otherwise, this may result in electric shock or fire. If thunder or lightening is occurring, do not touch the power cord or antenna cable. • Otherwise, this may result in electric shock or fire. Do not try to move the monitor by pulling only the wire or the signal cable. • Otherwise, it may fall and result in electric shock, damage to the product o
ページ7に含まれる内容の要旨
Safety Instructions When using headphones or earphones, do not turn the volume too high. • Having the sound too loud may damage your hearing. If you continually move closer to the product screen, your eye- sight may be failing. To ease eye strain, take at least a five-minute break after every hour of using the monitor. Do not install it in an unstable location such as an unstable rack or uneven surface or a location exposed to vibrations. • Otherwise, it may fall and cause personal injury an
ページ8に含まれる内容の要旨
Safety Instructions Do not drop any objects onto the product or cause any impact to the product. • Otherwise, this may result in electric shock or fire. Do not use a humidifier or kitchen table near the product. • Otherwise, this may result in electric shock or fire. When there is a gas leak, do not touch the product or the power plug but ventilate immediately. • If a spark occurs, it may cause an explosion or fire. If the product has been turned on for a long time, the display panel becomes
ページ9に含まれる内容の要旨
Safety Instructions • Adjust the angle so that light is not reflected on the screen. • Place your arms perpendicular to your sides and allow your arms to be level with the back of the hand. • Keep your elbow at 90 degrees. • Keep your knees at greater than 90 degrees, and keep your heels firmly on the floor. Keep your arms lower than your heart.
ページ10に含まれる内容の要旨
SyncMaster 2494HS Introduction Package Contents Note Please make sure the following items are included with your monitor. If any items are missing, contact your dealer. Contact a local dealer to buy optional items. Unpacking Type 1 Monitor and HAS stand Type 2 Monitor and HAS-USB stand Type 3 Monitor and Simple stand Type 4
ページ11に含まれる内容の要旨
Introduction Monitor and Simple-USB stand Note MagicRotation program can not be provided as Simple Stand does not support Pivot function. List of Parts Quick Setup Guide Warranty Card User's Guide (Not available in all loca- tions) D-Sub Cable Power Cord Option USB Cable Cable holding ring Sold separately DVI Cable Stereo Cable HDMI Cable Headphones
ページ12に含まれる内容の要旨
Introduction Note • USB cable is only provided when the stand type is HAS-USB or SIMPLE-USB. • Cable holding ring is only provided when the stand type is SIMPLE or SIMPLE-USB. Your Monitor Initial Settings Select the language using the up or down key. The displayed content will disappear after 40 seconds. Turn the power button off and on. It will be displayed again. It can be displayed up to three (3) times. Make sure to adjust the resolution of your PC before reaching the maximum count. Note
ページ13に含まれる内容の要旨
Introduction MENU button [MENU/ ] Opens the on-screen menu and exits from the menu. Also use to exit the OSD menu or return to the previous menu. Customized Key You can customize key assignment for the Custom button according to your preferences. Note You can configure the Customized key for a required function via Setup > Customized Key. Volume button When OSD is not on the screen, push the button to adjust volume. >> Click here to see an animation clip Adjust buttons [ ] Adjust items in the m
ページ14に含まれる内容の要旨
Introduction Rear Note The configuration at the back of the monitor may vary from product to product. POWER S/W / POWER POWER S/W Switch the product on and off. POWER Connect the power cord for your monitor to the POWER port on the back of the product. HDMI IN / DVI IN(HDCP) / RGB IN HDMI IN Connect the HDMI IN terminal at the back of your product to the HDMI terminal of your digital output device using a HDMI cable. DVI IN(HDCP) Connect the DVI cable to the DVI IN (HDCP) port on the back of yo
ページ15に含まれる内容の要旨
Introduction AUDIO IN Connect the audio cable for your product to the audio port on the back of your computer. AUDIO OUT Headphone output terminal USB connection ter- minal (Option) UP (USB upstream port) Connect the UP port of the product and the USB port of the computer with the USB cable. DOWN (USB downstream port) Connect the DOWN port of the USB product and a USB device with the USB ca- ble. Note To use DOWN (Downstream Port), you have to connect the UP (Upstream Ca- ble ) to the PC.
ページ16に含まれる内容の要旨
Introduction Using the Anti-Theft Kensington Lock 1. Insert the locking device into the Ken- sington slot on the Monitor and turn it in the locking direction . 2. Connect the Kensington Lock cable. 3. Fix the Kensington Lock to a desk or a heavy stationary object. Stand Stopper (Only ap- plied to HAS or HAS-USB type stand.) Remove the fixing pin on the stand to lift the product up and down. Note See Connecting Cables for further information regarding cable connections. Package Contents SyncMas
ページ17に含まれる内容の要旨
Introduction Monitor and HAS-USB stand Type 3 Monitor and Simple stand Type 4 Monitor and Simple-USB stand Note MagicRotation program can not be provided as Simple Stand does not support Pivot function. List of Parts Quick Setup Guide Warranty Card User's Guide (Not available in all loca- tions)
ページ18に含まれる内容の要旨
Introduction List of Parts D-Sub Cable Power Cord Option USB Cable Cable holding ring Cleaning Cloth Sold separately DVI Cable Stereo Cable HDMI Cable Headphones Note • USB cable is only provided when the stand type is HAS-USB or SIMPLE-USB. • Cable holding ring is only provided when the stand type is SIMPLE or SIMPLE-USB. • Cleaning Cloth is only provided for highly polished black products as a product feature. Your Monitor Initial Settings Select the language using the up or down key. T
ページ19に含まれる内容の要旨
Introduction Front Note Touch them lightly with your fingers to use them. MENU button [MENU/ ] Opens the on-screen menu and exits from the menu. Also use to exit the OSD menu or return to the previous menu. Customized Key You can customize key assignment for the Custom button according to your preferences. Note You can configure the Customized key for a required function via Setup > Customized Key. Volume button When OSD is not on the screen, push the button to adjust volume. >> Click here to
ページ20に含まれる内容の要旨
Introduction Note If you select the digital mode, you must connect your monitor to the graphic card's DVI port using the DVI cable. >> Click here to see an animation clip AUTO button Use this button for auto adjustment. >> Click here to see an animation clip Power button [ ] Use this button for turning the product on and off. Power Indicator This light is lit when operating normally, and blinks once when your ad- justments are saved. Note See PowerSaver described in the manual for further info
