ページ1に含まれる内容の要旨
LV1561w, LV1561ws, LV1561x,
CQ1569, and CQ1569x LCD Monitors
User Guide
ページ2に含まれる内容の要旨
© 2009, 2011 Hewlett-Packard Development Company, L.P. Microsoft, Windows, and Windows Vista are either trademarks or registered trademarks of Microsoft Corporation in the United States and/or other countries. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services . Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical or editorial errors or omissions conta
ページ3に含まれる内容の要旨
About This Guide This guide provides information on setting up the monitor, installing drivers, using the on-screen display menu, troubleshooting and technical specifications. WARNING! Text set off in this manner indicates that failure to follow directions could result in bodily harm or loss of life. CAUTION: Text set off in this manner indicates that failure to follow directions could result in damage to equipment or loss of information. NOTE: Text set off in this manner provides important supp
ページ4に含まれる内容の要旨
iv About This Guide
ページ5に含まれる内容の要旨
Table of contents 1 Product Features ............................................................................................................................................ 1 LCD Monitors ....................................................................................................................................... 1 2 Safety and Maintenance Guidelines .............................................................................................................. 2 Important Safety I
ページ6に含まれる内容の要旨
Entering User Modes ......................................................................................................... 22 Energy Saver Feature ........................................................................................................ 22 Plug & Play DDC2B Feature .............................................................................................. 22 Appendix C Agency Regulatory Notices ................................................................................
ページ7に含まれる内容の要旨
1 Product Features LCD Monitors The LCD (liquid crystal display) monitors have an active matrix, thin-film transistor (TFT) panel. The monitor models and features include: ● 39.5 cm (15.6-inch) viewable area display ● 1366 x 768 resolution, plus full-screen support for lower resolutions ● Non-glare panel with an LED backlight that provides better clarity and consumes less energy than traditional CCFL backlights (LV1561x and CQ1569x models) ● Tilt capability ● Video signal input to support VGA an
ページ8に含まれる内容の要旨
2 Safety and Maintenance Guidelines Important Safety Information A power cord is included with the monitor. If another cord is used, use only a power source and connection appropriate for this monitor. For information on the correct power cord set to use with the monitor, refer to the Power Cord Set Requirements on page 25 in Appendix C. WARNING! To reduce the risk of electric shock or damage to the equipment: • Do not disable the power cord grounding feature. The grounding plug is an important
ページ9に含まれる内容の要旨
Maintenance Guidelines To enhance the performance and extend the life of the monitor: ● Do not open the monitor cabinet or attempt to service this product yourself. Adjust only those controls that are covered in the operating instructions. If the monitor is not operating properly or has been dropped or damaged, contact an authorized HP dealer, reseller, or service provider. ● Use only a power source and connection appropriate for this monitor, as indicated on the label/ back plate of the monitor
ページ10に含まれる内容の要旨
Cleaning the Monitor 1. Turn off the monitor and unplug the power cord from the back of the unit. 2. Dust the monitor by wiping the screen and the cabinet with a soft, clean antistatic cloth. 3. For more difficult cleaning situations, use a 50/50 mix of water and Isopropyl alcohol. CAUTION: Spray the cleaner onto a cloth and use the damp cloth to gently wipe the screen surface. Never spray the cleaner directly on the screen surface. It may run behind the bezel and damage the electronics. CAUTION
ページ11に含まれる内容の要旨
3 Setting Up the Monitor To set up the monitor, ensure that the power is turned off to the monitor, computer system, and other attached devices, then follow the instructions below. Installing the Monitor Base To install the monitor base: 1. Place the base on a smooth, flat surface. 2. Align the pedestal column on top of the base and press down to install. 3. Using both hands, position the monitor over the pedestal base. NOTE: Do not install the base if the monitor will be used on a wall, swing a
ページ12に含まれる内容の要旨
Identifying Rear Components Figure 3-2 Rear Components Component Function 1 AC Power Connector Connects the AC power cord to the monitor. 2 VGA Connector Connects the VGA (15-pin D-Sub) cable to the monitor. 3 Audio Port (select Connects the audio cable (provided with select models) to models) the monitor. 6 Chapter 3 Setting Up the Monitor
ページ13に含まれる内容の要旨
Connecting the Cables 1. Place the monitor in a convenient, well-ventilated location near the computer. 2. Connect the power cable to the AC power connector on the back of the monitor. WARNING! To reduce the risk of electric shock or damage to the equipment: Do not disable the power cord grounding plug. The grounding plug is an important safety feature. Plug the power cord into a grounded (earthed) electrical outlet that is easily accessible at all times. Disconnect power from the equipment by u
ページ14に含まれる内容の要旨
CAUTION: Burn-in image damage may occur on monitors that display the same static image on screen for a prolonged period of time. To avoid burn-in image damage on your monitor screen, you should always activate a screen saver application or turn off the monitor when it is not in use for a prolonged period of time. Image retention is a condition that may occur on all LCD screens. Mounting the Monitor You can remove the monitor base to mount the monitor on a wall, a swing arm, or other mounting fix
ページ15に含まれる内容の要旨
7. Refer to the user manual that came with the optional mounting fixture additional mounting instructions. Figure 3-4 Removing the Monitor Base Mounting the Monitor 9
ページ16に含まれる内容の要旨
Locating the Rating Labels The rating labels on the monitor provide the spare part number, product number, and serial number. You may need these numbers when contacting HP about the monitor model. The rating labels are located on the back of the monitor. 10 Chapter 3 Setting Up the Monitor
ページ17に含まれる内容の要旨
4 Operating the Monitor Installing the Driver You can install the monitor-driver INF and ICM files from the CD (included with select models) or download from the Internet. Installing from the CD To install the .INF and .ICM files on the computer from the CD: 1. Insert the CD in the computer CD-ROM drive. The CD menu is displayed. 2. Select the language. 3. View the Monitor Driver Software Readme file. 4. Select Install Monitor Driver Software. 5. Follow the on-screen instructions. 6. Ensure that
ページ18に含まれる内容の要旨
Table 4-1 Monitor Front Panel Controls Control Function 1 Auto/OK When the OSD is open, press to select the menu. When the OSD is closed, press to activate the auto-adjustment function. 2 – (Minus) When the OSD is closed, press to activate the volume adjustment bar. When the OSD is open, press – to navigate through the OSD menu or change the setting of a selected function; adjusts volume (for models with speakers). 3 + (Plus) When the OSD is closed, press to activate the volume adjustment bar.
ページ19に含まれる内容の要旨
Adjusting the Monitor Settings The monitor settings can be adjusted from the On-Screen Display (OSD) menu. To access the OSD and adjust screen settings base on your viewing preference, do the following: 1. If the monitor is not already on, press the power button to turn on the monitor. The power indicator will light up. 2. To access the OSD menu, press the Menu button. 3. To navigate through the Main Menu, press the – or + buttons. Once the desired function is highlighted, press the Menu button
ページ20に含まれる内容の要旨
Table 4-2 OSD Menu (continued) Icon Main Menu Submenu Description Horizontal Position Adjusts the position of the screen image left and right. Vertical Position Adjusts the position of the screen image up and down. Custom Scaling Selects the method on how displayed information on the monitor will be formatted. Select: ● Fill to Screen - image fills the entire screen and may look distorted or elongated because of non-proportional scaling of height and width ● Fill to Aspect Ratio - image is size
