ページ1に含まれる内容の要旨
5
4
3
2
1
ALL
™
Say What?! Wireless Chime
This package includes (Style of push button and chime may vary from illus-
tration):
• Wireless chime • Wireless push button with demostration batteries
• Hardware pack • Audio cable (Model 1204 Only)
This chime requires 3 “C” alkaline batteries for the chime and 4 “AA”
alkaline batteries for the transmitter (Not Included). In typical use, alka-
line batteries will last up to six months.
1. Install 4 type “AA” alkaline batteries in push button.
Open back
ページ2に含まれる内容の要旨
3. Test functions. Temporarily position chime and push button where you want them mounted. Press push button to verify chime and push button work properly. If chime does not sound, see Troubleshooting. 4. Adjust volume. The chime is equipped with a High/Low switch located on the left side. Slide the switch to either High or Low to adjust volume. 5. Mount push button and chime. Use either a screw or double sided tape to mount push button. To mount with screw, determine where push button will be l
ページ3に含まれる内容の要旨
7654321 Code and Tune Settings Code Settings Note: Most installations will not require you to change any jumpers on your chime and push button. This manual includes operating instructions for different types of chimes. All chimes work on the same principle and use the same channel setting infor- mation. Please read all instructional information and note any specific infor- mation pertaining to your particular chime. The push button and chime communicate by using a code that can be changed by rem
ページ4に含まれる内容の要旨
Chime Tune Settings Your wireless chime has different selectable tune modes: 4 prerecorded sounds and 1 setting that cycles through the 4 prerecorded sounds (model 1204 adds the ability to record up to 10 seconds of audio via the audio cable or built-in microphone, see instructions below). To select different tune modes, slide switch located on right side of chime to numbers 1 through 4 to select the prerecorded sound desired. Select “All” to allow chime to cycle through the 4 prerecorded sounds
ページ5に含まれる内容の要旨
Troubleshooting Chime does not sound: • Make sure push button and chime codes are the same (See page 3). • Check orientation of push button and chime batteries (See markings in- side push button and chime). • Check charge of push button and chime batteries, replace if necessary. •Verify push button and chime are within 50 feet of each other. Batteries seem OK, but the chime does not work when installed: • Do not mount chime or push button on metal or near metal studs. This reduces the transmitt
ページ6に含まれる内容の要旨
ONE YEAR LIMITED WARRANTY This is a “Limited Warranty” which gives you specific legal rights. You may also have other rights which vary from state to state or province to province. For a period of one year from the date of purchase, any malfunction caused by factory defective parts or workmanship will be corrected at no charge to you. Batteries are not covered. To obtain a refund or a replacement, return the product to the place of purchase. Not Covered - Repair service, adjustment and calibrati
