ページ1に含まれる内容の要旨
INSTRUCTION MANUAL
DP-ST22
DP-ST21
DP-ST20
PLASMA MONITOR (DISPLAY)
STAND
S
T
A
N
Thank you for purchasing the Daewoo Electronic Plasma Monitor stand. This stand is
D
specifically designed only for the Daewoo Plasma Display. To ensure the safe operation of
the unit, please read these instructions before installing.
ページ2に含まれる内容の要旨
TABLE OF CONTENTS ............................ 1. Check for enclosed parts 1 ...................... 2. Important Safety Instructions 2 ................................. 3. Assembly Instructions 3 ......................... 4. Disassembling Instructions 5 1. PLEASE CHECK FOR THE ITEMS SHOWN BELOW STAND M5 SCREWS (1) (2) 1
ページ3に含まれる内容の要旨
PLASMA DISPLAY STAND 2. IMPORTANT SAFETY INSTRUCTIONS PLEASE FOLLOW THESE INSTRUCTIONS FOR YOUR SAFETY PLEASE KEEP THESE INSTRUCTIONS FOR YOUR SAFETY AND TO PREVENT ANY DAMAGE TO THIS UNIT. WARNING : Disregarding When handling Display glass, be careful not apply any pressure on it. these instructions can result in WARNING serious injury. CAUTION : Disregarding these instructions will result in the CAUTION mistreatment of the unit and can result in injury or damage to the unit. When assembling,
ページ4に含まれる内容の要旨
3. ASSEMBLING INSTRUCTIONS HOW TO DISPOSE OF THE PLASMA MONITOR WRAPPER 1 . . First dispose of the wrapping band and Afterwards, dispose of the Styrofoam raise the top box to open. and remove the vinyl covering. 2 HOW TO DISPOSE OF THE PROTECTIVE CAP. . . Place a protective covering over the As shown below, unscrew the screws and surface you will be working on and lay the take out both of the protective caps. plasma display as shown below. 3
ページ5に含まれる内容の要旨
PLASMA DISPLAY STAND ASSEMBLING THE PLASMA DISPLAY STAND 3 . . Slide the stand under the plasma display Open and take out the stand from the like the picture below. box and remove wrapper. . Use the enclosed 2 M5 screws to secure the assembled stand. M5 Screws S (Picture of a properly installed stand T and display) A N D 4
ページ6に含まれる内容の要旨
4. DISASSEMBLING INSTRUCTIONS DISASSEMBLING PLASMA DISPLAY STAND . . Place a protective covering over the Completely unscrew the secured 2 surface you will be working on and lay the screws. plasma display as shown below. . Pull the stand away from the plasma display to disassemble. 5
