ページ1に含まれる内容の要旨
TS32M~1GCF80
TS32M~1GCF80 80X CompactFlash Card
TS32M~1GCF80
1. Description 1.1 Feature
The Transcend CF 80X is a High Speed Compact • RoHS compliant products
Flash Card with high quality Flash Memory assembled • Compliant with CompactFlash® specification V3.0
on a printed circuit board.
• Single Power Supply: 5V ± 10% / 3.3V ± 5%
• Compliant to CompactFlash, PCMCIA, and ATA
standard s
Placement
• t r o p p u S e d o I m O P e d o
ページ2に含まれる内容の要旨
TS32M~1GCF80 TS32M~1GCF80 80X CompactFlash Card TS32M~1GCF80 1.3 Ordering Information Part Number Mode Description Transfer mode True IDE mode DMA Fixed Disk Multiword DMA mode 0~4, PIO mode 0~6 TS32M~1GCF80 PCMCIA mode Non-DMA Removable Disk N/A CF80 True IDE mode Non-DMA Fixed Disk PIO mode 0~4 TS32M~1GCF80-P PCMCIA mode Non-DMA Removable Disk N/A 1.4 CHS and Capacity Product Name Cylinder Head Sector Capacity TS32MCF80 62 16 63 29
ページ3に含まれる内容の要旨
TS32M~1GCF80 TS32M~1GCF80 80X CompactFlash Card TS32M~1GCF80 2.Product Specification n o t a c c i i e f i p S d s r a h t C c a l a f p m o . C 2 1 Transcend Transcend Information Inc. 3 1 V 1 .
ページ4に含まれる内容の要旨
TS32M~1GCF80 TS32M~1GCF80 80X CompactFlash Card TS32M~1GCF80 2.2 Block Diagram Transcend Information Inc. 4 1 V 1 .
ページ5に含まれる内容の要旨
TS32M~1GCF80 TS32M~1GCF80 80X CompactFlash Card TS32M~1GCF80 3. Electrical Interface 3.1 Pin Assignment and Pin Type 4 PC Card Memory Mode PC Card I/O Mode True IDE Mode Pin Signal Pin Signal Pin In, Out Pin Signal Pin In, Out In, Out Type Pin Num Num Name Type Name Type Type Num Name Type Type 1 GND Ground 1 GND Ground 1 GND Ground 2 D03 I/O I1Z, OZ3 2 D03 I/O I1Z, OZ3 2 D03 I/O I1Z, OZ3 3 D04 I/O
ページ6に含まれる内容の要旨
TS32M~1GCF80 TS32M~1GCF80 80X CompactFlash Card TS32M~1GCF80 4 PC Card Memory Mode PC Card I/O Mode True IDE Mode Pin Pin In, Out Pin Pin In, Out Pin Pin In, Out Signal Name Signal Name Signal Name Num Type Type Num Type Type Num Type Type 33 -VS1 O Ground 33 -VS1 O Ground 33 -VS1 O Ground 34 -IORD I I3U 34 -IORD I I3U 34 -IORD I I3Z 35 -IOWR I I3U 35 -IOWR I I3U 35 -IOWR I I3Z 3 36 -WE I
ページ7に含まれる内容の要旨
TS32M~1GCF80 TS32M~1GCF80 80X CompactFlash Card TS32M~1GCF80 3.2 Signal Description Signal Name Dir. Pin Description A10 – A00 I 8,10,11,12, These address lines along with the -REG signal are used to select the following: (PC Card Memory Mode) 14,15,16,17, The I/O port address registers within the CompactFlash Storage Card , the 18,19,20 memory mapped port address registers within the CompactFlash Storage Card, a byte in the card's infor
ページ8に含まれる内容の要旨
TS32M~1GCF80 TS32M~1GCF80 80X CompactFlash Card TS32M~1GCF80 -CD1, -CD2 O 26,25 These Card Detect pins are connected to ground on the CompactFlash Storage (PC Card Memory Mode) Card. They are used by the host to determine that the CompactFlash Storage Card is fully inserted into its socket. -CD1, -CD2 This signal is the same for all modes. (PC Card I/O Mode) -CD1, -CD2 This signal is the same for all modes. (True IDE Mode) Signal Na
ページ9に含まれる内容の要旨
TS32M~1GCF80 TS32M~1GCF80 80X CompactFlash Card TS32M~1GCF80 D15 - D00 31,30,29,28, I/O These lines carry the Data, Commands and Status information between the host (PC Card Memory Mode) 27,49,48,47, and the controller. D00 is the LSB of the Even Byte of the Word. D08 is the LSB 6,5,4,3,2, of the Odd Byte of the Word. 23, 22, 21 This signal is the same as the PC Card Memory Mode signal. D15 - D00 (PC Card I/O Mode) D15 - D00 I
ページ10に含まれる内容の要旨
TS32M~1GCF80 TS32M~1GCF80 80X CompactFlash Card TS32M~1GCF80 -IORD I 34 This signal is not used in this mode. (PC Card Memory Mode) This is an I/O Read strobe generated by the host. This signal gates I/O data onto -IORD the bus from the CompactFlash Storage Card when the card is configured to use (PC Card I/O Mode) the I/O interface. In True IDE Mode, this signal has the same function as in PC Card I/O Mode. -IORD (True
ページ11に含まれる内容の要旨
TS32M~1GCF80 TS32M~1GCF80 80X CompactFlash Card TS32M~1GCF80 -REG This signal is used during Memory Cycles to distinguish between Common I 44 (PC Card Memory Mode) Memory and Register (Attribute) Memory accesses. High for Common Memory, Attribute Memory Select Low for Attribute Memory. -REG The signal shall also be active (low) during I/O Cycles when the I/O address is (PC Card I/O Mode) on the Bus. -DMACK This is a DMA Acknowledge sig
ページ12に含まれる内容の要旨
TS32M~1GCF80 TS32M~1GCF80 80X CompactFlash Card TS32M~1GCF80 -VS1 O 33 Voltage Sense Signals. -VS1 is grounded on the Card and sensed by the Host -VS2 40 so that the CompactFlash Storage Card CIS can be read at 3.3 volts and -VS2 is (PC Card Memory Mode) reserved by PCMCIA for a secondary voltage and is not connected on the Card. -VS1 This signal is the same for all modes. -VS2 (PC Card I/O Mode) -VS1 This signal is the same for all
ページ13に含まれる内容の要旨
TS32M~1GCF80 TS32M~1GCF80 80X CompactFlash Card TS32M~1GCF80 3.3 Electrical Specification The following tables indicate all D.C. Characteristics for the CompactFlash Storage Card. Unless otherwise stated, conditions are: Vcc = 5V ±10% Vcc = 3.3V ± 5% Absolute Maximum Conditions Input Power 3.3.1 Input Leakage Current Transcend Information Inc. 13 1 V 1 .
ページ14に含まれる内容の要旨
TS32M~1GCF80 TS32M~1GCF80 80X CompactFlash Card TS32M~1GCF80 3.3.2 Input Characteristics 3.3.2.1 CompactFlash interface I/O at 5.0V Parameter Symbol Min. Max. Unit Remark Supply Voltage VCC 4.5 5.5 V High level output voltage V V -0.8 V OH CC Low level output voltage VOL 0.8 V 4.0 V Non-schmitt trigger High level input voltage V IH 1 2.6 V Schmitt trigger 0.8 V Non-schmitt trigger Low level input voltage VIL 1 1.79 V Schmi
ページ15に含まれる内容の要旨
TS32M~1GCF80 TS32M~1GCF80 80X CompactFlash Card TS32M~1GCF80 3.3.2.2 CompactFlash interface I/O at 3.3V Parameter Symbol Min. Max. Unit Remark Supply Voltage V 3.135 3.465 V CC High level output voltage VOH VCC-0.8 V Low level output voltage V 0.8 V OL 2.4 V Non-schmitt trigger High level input voltage V IH 1 1.67 V Schmitt trigger 0.6 V Non-schmitt trigger Low level input voltage V IL 1 1.07 V Schmitt trigger 2 Pull up resist
ページ16に含まれる内容の要旨
TS32M~1GCF80 TS32M~1GCF80 80X CompactFlash Card TS32M~1GCF80 3.3.3 Output Drive Type 3.3.4 Output Drive Characteristics Transcend Information Inc. 16 1 V 1 .
ページ17に含まれる内容の要旨
TS32M~1GCF80 TS32M~1GCF80 80X CompactFlash Card TS32M~1GCF80 3.4 Signal Interface Electrical specifications shall be maintained to ensure data reliability. 10 10 Item Signal Card Host -CE1 -CE2 Ω ≧ ≧ Ω Pull-up to V 500 K R 50 K and CC Control Signal -REG shall be sufficient to keep inputs inactive 1 -IORD when the pins are not connected at the host. -IOWR -OE 1,2 Pull-up to V 500 K Ω ≧ R ≧ 50 K Ω . CC -WE 1,2,9, RESET Pull-up
ページ18に含まれる内容の要旨
TS32M~1GCF80 TS32M~1GCF80 80X CompactFlash Card TS32M~1GCF80 meeting all AC timing requirements: 50 pF at a DC current of 400 μ A low state and 100 μ A high state. 5) Status Signals: the socket shall present a load to the card no larger than 50 pF 10 at a DC current of 400 μ A low state and 100 μ A high state, including pull-up resistor. The card shall be able to drive at least the following load 10 while μ μ meeting all AC timing requirements:
ページ19に含まれる内容の要旨
TS32M~1GCF80 TS32M~1GCF80 80X CompactFlash Card TS32M~1GCF80 3.5 Attribute Memory Read Timing Figure: Attribute Memory Read Timing Diagram Transcend Information Inc. 19 1 V 1 .
ページ20に含まれる内容の要旨
TS32M~1GCF80 TS32M~1GCF80 80X CompactFlash Card TS32M~1GCF80 3.6 Configuration Register (Attribute Memory) Write Timing Figure: Configuration Register (Attribute Memory) Write Timing Diagram Transcend Information Inc. 20 1 V 1 .
