Renesas R8C/23の取扱説明書

ページ1に含まれる内容の要旨

Renesas Starter Kit for R8C/23
Quick Start



LCD module



Application Board Interface

E8a header


Reset switch
LCD module
connector
User LEDs
CAN connector

E8a emulator

Application Board Interface

Analog adjust

LIN connector

User switches







D007114_11_S01_V03

ページ2に含まれる内容の要旨

1. Installation Do not connect the E8a emulator hardware until the software support has been installed. 1. Insert the CD into your computer’s CD-ROM drive. The CD should automatically run the installation program. If the installer does not start, browse to the CD root folder and double click on “setup.exe”. 2. The installer will ask you which language is to be used, please choose the appropriate one. 3. On the first screen of the installer proper, click . 4. The License Agreement w

ページ3に含まれる内容の要旨

26. Select the Debug build configuration in the left hand drop down list on the toolbar. 27. Click on the “Build” icon to compile, assemble and link the project. 4. Programming and Debug 28. Ensure the “SessionR8C_E8a_SYSTEM” session in the right hand drop down list on the toolbar is selected. 29. Click the button on the debug toolbar. 30. The “Emulator mode” dialog will be shown. Select the correct MCU group and device type (e.g. R8C/23 Group and R5F21237 f

ページ4に含まれる内容の要旨

36. Right click on the download module listed in the left hand pane and select “Download”. The code will be downloaded to the microcontroller. This may take several seconds. 37. Click the button. The code will run and you will see the LEDs flash on the board. 38. Click the button. The code will stop and the source code will be opened at the current program counter. 5. Next Step After you have completed this quick start procedure, please review the tutoria