ページ1に含まれる内容の要旨
AIR CONDITIONER
Use & Care Guide
For questions about features, operation/performance, parts,
accessories or service, call: 1-800-253-1301 in the U.S.A.
ACONDICIONADOR
DE AIRE
Manual de Uso y Cuidado
Si tiene preguntas respecto a las características, funcionamiento,
rendimiento, partes, accesorios o servicio técnico,
llame al: 1-800-253-1301 en los EE. UU.
Table of Contents/Índice ..................................... 2
1188081A
ページ2に含まれる内容の要旨
TABLE OF CONTENTS AIR CONDITIONER SAFETY .........................................................2 Starting Your Air Conditioner .......................................................9 Changing Air Direction ...............................................................12 INSTALLATION REQUIREMENTS ................................................3 Normal Sounds...........................................................................12 Tools and Parts .........................................
ページ3に含まれる内容の要旨
IMPORTANT SAFETY INSTRUCTIONS WARNING: To reduce the risk of fire, electrical shock or injury when using your air conditioner, follow these basic precautions: Plug into a grounded 3 prong outlet. Do not use an extension cord. Do not remove ground prong. Unplug air conditioner before servicing. Do not use an adapter. Use two or more people to move and install air conditioner. SAVE THESE INSTRUCTIONS INSTALLATION REQUIREMENTS The location should provide: Grounded electrical outlet within 4 ft
ページ4に含まれる内容の要旨
RESET TEST Specific electrical requirements are listed in the chart below. Through-the-wall installation Follow the requirements for the type of plug on the power supply cord. The wall opening measurements should be: Power supply Height: 16" (40.6 cm) plus twice the thickness of wood used cord Wiring requirements to build frame. 115-volt (103.5 min. - 126.5 max.) Width: 22⁵⁄₈" (57.5 cm) plus twice the thickness of wood used to build frame. 0-12 amps Depth: 2¹⁄₂" (6.4 cm) minimum t
ページ5に含まれる内容の要旨
To test your power supply cord: 1. Plug power supply cord into a grounded 3 prong outlet. WARNING 2. Press RESET. 3. Press TEST (listen for click; Reset button will trip and pop out). 4. Press and release RESET (listen for click; Reset button will is ready for latch and remain in). The power supply cord operation. Electrical Shock Hazard NOTES: The Reset button must be pushed in for proper operation. Plug into a grounded 3 prong outlet. The power supply cord must be replaced if it fai
ページ6に含まれる内容の要旨
Installing Air Conditioner NOTE: Handle air conditioner gently. 5. Extend right-hand curtain outward so you may insert the first screw through the middle hole of the curtain. Using #8 - 18 x ³⁄₈" pan-head screw, screw curtain to middle hole Window installation (on some models) in air conditioner cabinet. NOTE: Attach top channel and side curtains to air conditioner NOTE: This screw is required to correctly attach curtain (top cabinet before placing cabinet in window. to bottom) to the air c
ページ7に含まれる内容の要旨
Option 2—Plastered wall with no molding 3. Cut opening through the wall. Remove and save insulation. If the plastered wall is to be flush with the cabinet and no molding NOTES: is used, the wood frame must be set ¹⁄₂" (13 mm) into the inside Dimension for depth depends on wall thickness and type wall. of molding. Do not block louvers in air conditioner cabinet. A B C Use 1" (2.5 cm) or thicker lumber for wood frame. D A B C A. Plastered wall C. Wood frame A. Outside width B. Inside w
ページ8に含まれる内容の要旨
6. Insert one of the #8 x ³⁄₄" round-head screws through 2. Use a level to check that cabinet is level side to side. hole and into lower window sash. Insert one of the #6 - 32 x ¹⁄₄" pan-head screws through threaded hole in top of curtain. A B C A A. Level 3. Check that air conditioner cabinet is tilted to the outside so that water will run to the outside. 4. Reuse the insulation to seal opening between cabinet and frame. 5. Use existing holes and 6 - #8 x ¹⁄₂" wood screws (not A. Hole
ページ9に含まれる内容の要旨
4. Install foam seal in the gap between air conditioner base and cabinet. Push foam seal in at the sides and trim any excess WARNING material. Electrical Shock Hazard Plug into a grounded 3 prong outlet. A Do not remove ground prong. Do not use an adapter. A. Foam seal Do not use an extension cord. 5. Remove the 2 front panel screws from air conditioner base. Failure to follow these instructions can result in death, 6. Insert front tabs of front panel into top of cabinet and swing fire, or
ページ10に含まれる内容の要旨
NOTES: Fan Speed When the air conditioner is off, the Room indicator light is lit and the display shows the current room temperature. NOTE: The Fan Speed button will operate only when Cool, Fan If the room temperature is below 55ºF (13ºC), the display will Only or Power Saver mode has been selected. show 55ºF (13ºC). If the room temperature is above 99ºF 1. Press FAN SPEED until you see the indicator light come on (37ºC), the display will show 99ºF (37ºC). for the setting you desire.
ページ11に含まれる内容の要旨
To change the temperature display from °F to °C: To see or change the remaining time (in hours): 1. Turn off the air conditioner. 1. Press TIMER once after it has been programmed. Hour indicator light will turn on, and display will show remaining 2. While the air conditioner is off, press and hold down the time. MODE and FAN SPEED buttons while pressing POWER to turn on the air conditioner. 2. While the display is showing the remaining time, you can press the plus or minus button to increas
ページ12に含まれる内容の要旨
To select the fan speed (in Cool, Fan Only or Power Saver 3. Press the plus or minus button to change delay time (1 to 24 hours). mode only): Press TURBO, HIGH or LOW. 4. Press TIMER again or wait 10 seconds. Timer indicator light on air conditioner will remain on. Hour indicator light on air conditioner will turn off, and Room indicator light on air conditioner will turn on. Display on air conditioner will show the current room temperature. To set Timer to turn on air conditioner, changin
ページ13に含まれる内容の要旨
AIR CONDITIONER CARE Your new air conditioner is designed to give you many years of 4. Use a vacuum cleaner to clean air filter. If air filter is very dirty, dependable service. This section tells you how to clean and care wash it in warm water with a mild detergent. Do not wash air for your air conditioner properly. Call your local authorized dealer filter in the dishwasher or use any chemical cleaners. Air dry for an annual checkup. Remember… the cost of this service call filter completely
ページ14に含まれる内容の要旨
The filter is dirty or obstructed by debris. Clean the filter. Air conditioner power supply cord trips (Reset button The inside evaporator and outside condenser coils are pops out) dirty or obstructed by debris. See “Annual Maintenance.” There is excessive heat or moisture (open container Disturbances in your electrical current can trip (Reset button will pop out) the power supply cord. Press and cooking, showers, etc.) in the room. Use a fan to exhaust release RESET (listen for cl
ページ15に含まれる内容の要旨
ASSISTANCE OR SERVICE To avoid unnecessary service calls, please check the Please record your model's information. “Troubleshooting” section. It may save you the cost of a service Whenever you call to request service on your appliance, you call. If you still need help, follow the instructions below. need to know your complete model number and serial number. You can find this information on the model and serial number label. See “Electrical Requirements” for model and serial number If you n
ページ16に含まれる内容の要旨
Notes 16
ページ17に含まれる内容の要旨
SEGURIDAD DEL ACONDICIONADOR DE AIRE Su seguridad y la seguridad de los demás es muy importante. Hemos incluido muchos mensajes importantes de seguridad en este manual y en su electrodoméstico. Lea y obedezca siempre todos los mensajes de seguridad. Este es el símbolo de advertencia de seguridad. Este símbolo le llama la atención sobre peligros potenciales que pueden ocasionar la muerte o una lesión a usted y a los demás. Todos los mensajes de seguridad irán a continuación del símbolo de adve
ページ18に含まれる内容の要旨
Piezas suministradas (en algunos modelos) Instalación en la ventana (en algunos modelos) Verifique que estén todas las piezas en el paquete de piezas. Medidas de la abertura de la ventana: Ancho: 27" (68,6 cm) mínimo a 40" (101,6 cm) máximo B Altura: 16¹⁄₄" (41,3 cm) mínimo A H C D E F G A. Obturadores de espuma (2) E. Tornillos de cabeza de cono A achatado Phillips #10 - 12 x B. Soporte de seguridad para B ³⁄₈"(3) la ventana F. Tornillos de cabeza de cono C. Tornillos de cabeza de
ページ19に含まれる内容の要旨
RESET TEST Requisitos eléctricos Método recomendado para la puesta a tierra ADVERTENCIA Este acondicionador de aire debe ser puesto a tierra. Este acondicionador de aire está equipado con un cable de suministro de energía provisto de un enchufe con tres terminales. Para reducir a un mínimo el peligro de posibles choques eléctricos, el cable debe ser enchufado en un contacto apropiado de pared de tres terminales conectado a tierra de acuerdo con todos los códigos y reglamentos locales. Si
ページ20に含まれる内容の要旨
3. Presione TEST (Prueba) (escuche el chasquido, el botón de reposición se atrapa y salta). ADVERTENCIA 4. Presione y suelte RESET (escuche el chasquido, el botón de reposición queda asegurado y se mantiene asegurado). El cable de suministro de energía está listo para su funcionamiento. NOTAS: El botón de reposición debe presionarse para el funcionamiento adecuado. Peligro de Choque Eléctrico El cable de suministro de energía debe ser reemplazado si no Conecte a un contacto de pared de
