ページ1に含まれる内容の要旨
Xserve
FireWire Cable
Replacement Instructions
Follow the instructions in this sheet carefully. Failure to follow these instructions could
damage your equipment and void its warranty.
Note: Online instructions covering customer-installable parts are available at
http://www.info.apple.com/installparts/.
Tools Required
No tools are required for this procedure. You may, however, find a Phillips screwdriver
useful in releasing the thumbscrews at the front of the server.
Opening t
ページ2に含まれる内容の要旨
4. If the server is in the locked position (the yellow security LED on the front panel is on), use the Allen key that came with the server to unlock it. 5. If the cable management arm is not in use, unplug all external cables except the power cord. 6. Touch the server’s metal case to discharge any static electricity. Important: Always ground yourself by touching the server’s case before you touch any parts or install any components inside the server. To avoid static electricity bu
ページ3に含まれる内容の要旨
9. Grasp the thumbscrews and slide the bottom housing forward part way to expose the two chassis levers. (Figure 2) 10. While depressing both levers, pull the bottom housing all the way forward and remove it from the rack. Figure 2 11. Place the bottom housing on a sturdy, flat surface and ESD mat. 12. Put on the ESD wrist strap. Xserve FireWire Cable - 3
ページ4に含まれる内容の要旨
Removing the Installed FireWire Cable 1. Disconnect the FireWire cable from the front panel board. (Figure 3) 2. Disconnect the FireWire cable from the drive interconnect board and remove the cable from the server. Figure 3 Installing the Replacement FireWire Cable Connect the replacement FireWire cable to the drive interconnect board and the front panel board. Closing the Server 1. Carefully slide the bottom housing back into the rack. 2. Tighten the front thumb screws to secure
ページ5に含まれる内容の要旨
Apple Computer, Inc. © 2002 Apple Computer, Inc. All rights reserved. This document is protected under U.S. Copyright Law and International Treaties, and no part of this document may be reproduced in any form without written permission from Apple. Apple is not responsible for typographical, printing, or inadvertent errors. Apple Computer, Inc. 1 Infinite Loop Cupertino, CA 95014-2084 USA + 1 408 996 1010 http://www.apple.com Apple, the Apple logo, Mac, Macintosh, and the Mac logo are t
