ページ1に含まれる内容の要旨
RamWorks
2 MEG Plus
Memory Expander
This guide tells you how to install and configure your
RamWorks 2 - MEG PLUS Memory Expander card. The
RamWorks 2 MEG PLUS Memory Expander is an
accessory printed circuit card for both the RamWorks II
and RamWorks III extended memory cards. (The 2 MEG
PLUS will not work with the original RamWorks card. The
original RamWorks had only two rows of RAM chips with
a maximum capacity of 512K.)
When installed on either RamWorks II or III, it will
provide an a
ページ2に含まれる内容の要旨
Limited Warranty & Disclaimer Applied Engineering warrants the 2 MEG PLUS card and memory chips installed by or purchased from Applied Engineering against defects in material and workmanship for a period of 1 year from the date of original retail purchase. If you discover a defect, Applied Engineering will, at its option, repair or replace the
ページ3に含まれる内容の要旨
Installing the 2 MEG+ - - First, TURN OFF THE POWER SUPPLY. - - Remove the cover from your IIe. - - Discharge any static electricity on your body by touching the IIe power supply case before touching any of the components. * Warning! Don’t ZAP your chips! There are many static sensitive components in the IIe and on the RamWorks and 2 MEG+ Memory Expander cards. Be sure that you touch the power supply case before continuing. - - Remove the RamWorks card. - - Carefully line up the pins on the un
ページ4に含まれる内容の要旨
- - Now, re-install the expanded RamWorks following the installation instructions in your user’s manual Testing Your 2 MEG+ After installing the Expander card, you should test it by running the RamWorks Memory Test on the AppleWorks 2 Expander disk (Version 1.3) or the Super AppleWorks Desktop Expander disk. The test will display X’s on empty sockets and bad chips. Those sockets containing good chips will be displayed as clear rectangles. Adding Even More Memory... There are sixteen RAM
ページ5に含まれる内容の要旨
It is extremely important to insert the Expander’s memory chips properly. The illustration shows the correct orientation of the RAM chips and which memory chip sockets are allocated to each block on the 2 Meg+ Expander. Note the position of the notch (or dot on some chips). Each RAM chip should have all legs fully seated in the socket and in the correct position. OOPS! If power is applied to a chip that is plugged in backwards, the chip will probably be zapped immediately.
ページ6に含まれる内容の要旨
Block A $10 $11 $12 $13 #14 $15 $16 $17 $30 $3l $32 $33 $34 $35 $36 $37 Block B $50 $51 $52 $53 $54 $55 $56 $57 $70 $71 $72 $73 $74 $75 $76 $77 Problems? If you require more information on using the expanded memory, please see your RamWorks II or RamWorks III Users Manual. If you encounter any difficulties in the installation or use of the card, contact the dealer from whom you purchased the card. Most dealers are knowledgeable about the products they sell and will
