ページ1に含まれる内容の要旨
®
CoreBuilder 5000 ATM
®
Backbone SwitchModule
User Guide
http://www.3com.com
Part Number 10013037
Published November 1999
ページ2に含まれる内容の要旨
3Com Corporation Copyright © 1999, 3Com Corporation. All rights reserved. No part of this documentation may be 5400 Bayfront Plaza reproduced in any form or by any means or used to make any derivative work (such as translation, Santa Clara, California transformation, or adaptation) without written permission from 3Com Corporation. 95052-8145 3Com Corporation reserves the right to revise this documentation and to make changes in content from time to time without obligation on the part of 3Com
ページ3に含まれる内容の要旨
CONTENTS ABOUT THIS GUIDE Introduction 1 Audience 1 How to Use This Guide 1 Conventions 2 Related Documents 3 3Com Documents 3 Reference Documents 4 SNMP and MIB-Based Information 4 ATM and LAN Documents 5 1 NTRODUCTION I ATM Backbone SwitchModule Overview 1-1 ATM Backbone SwitchModule Features 1-1 Seamless ATM Migration 1-1 Multiple Redundancy Levels 1-2 ATM Forum Specification Compliance 1-2 CoreBuilder 5000 Chassis Compatibility 1-2 Switched Virtual Circuit Capacity 1-2 Emulated LAN (ELAN) Ca
ページ4に含まれる内容の要旨
PacketChannel Backplane Description 1-8 Slot Restrictions Per Backplane 1-8 Sample ATM Backbone SwitchModule Configurations 1-10 Basic Configuration 1-10 Dual-Homing Configuration 1-11 Dual-Homing/Module Redundancy Configuration 1-12 2 MULATION VERVIEW LAN E O General Definition of LAN Emulation 2-1 LAN Emulation Components 2-3 General LANE Components 2-3 LAN Emulation Client (LEC) 2-3 LAN Emulation Configuration Server (LECS) 2-3 LAN Emulation Server (LES) 2-3 Broadcast and Unknown Server (BUS
ページ5に含まれる内容の要旨
3 CONFIGURING THE ATM BACKBONE SWITCHMODULE Configuration Tools 3-1 Distributed Management Module 3-2 Advanced Management Tools 3-2 Transcend Network Control Services for UNIX 3-2 Transcend Network Management Software for Windows 3-3 Third-Party SNMP-Based Tools 3-4 Setting Up DMM Access 3-5 Setting Up Direct Terminal Access to the DMM 3-5 Configuring TELNET Access to the DMM 3-5 Configuration Process Overview 3-6 Configuration Components 3-6 LAN Emulation Configuration 3-6 Bridge Configuration
ページ6に含まれる内容の要旨
ATM Interface Parameters 4-9 ATM ILMI Configuration 4-10 ATM Q93b Parameters 4-10 ATM QSAAL Parameters 4-11 ATM Signal Configuration 4-11 ATM Statistics 4-12 ATM Traffic Description 4-12 ATM VCCs 4-13 SHOW BPORT_LEC 4-13 BPORT_LEC Configuration 4-14 BPORT_LEC Statistics 4-15 BPORT_LEC Status 4-15 BPORT_LEC Server Circuits 4-16 BPORT_LEC LE_ARP Table 4-16 SHOW SONET 4-17 SHOW SONET Status 4-17 SHOW SONET Statistics 4-18 SHOW IGMP SNOOPING 4-19 Using Graphical Interface Tools 4-20 CoreBuilder 500
ページ7に含まれる内容の要旨
6 TROUBLESHOOTING Troubleshooting Using LEDs 6-1 Troubleshooting Base Module LEDs 6-1 Verifying Base Module LED Operation 6-1 Reading the Base Module LEDs 6-2 Determining Corrective Action 6-3 Troubleshooting ATM OC-3 Card LEDs 6-4 Recovering from Problems 6-5 Verifying DMM Communication 6-5 Verifying Software Versions 6-6 Verifying Critical Parameters 6-7 Verifying ATM OC-3 Card Functions 6-7 Verifying ATM Signaling Functions 6-8 Verifying LEC Functions 6-9 Verifying Bridging Configuration 6-11
ページ8に含まれる内容の要旨
B TECHNICAL SUPPORT Online Technical Services B-1 World Wide Web Site B-1 3Com Knowledgebase Web Services B-1 3Com FTP Site B-2 3Com Bulletin Board Service B-2 Access by Analog Modem B-2 Access by Digital Modem B-3 3Com Facts Automated Fax Service B-3 Support from Your Network Supplier B-3 Support from 3Com B-3 Returning Products for Repair B-5 INDEX 3COM CORPORATION LIMITED WARRANTY
ページ9に含まれる内容の要旨
FIGURES 1-1 ATM Backbone SwitchModule Hardware Components 1-4 1-2 ATM Backbone SwitchModule Base Configuration 1-6 1-3 ATM Backbone SwitchModule with Redundant ATM OC-3 Card 1-7 1-4 Example Base Configuration 1-10 1-5 Example Dual-Homing Configuration 1-11 1-6 Example Dual-Homing/Module Redundancy Configuration 1-12 2-1 LAN Emulation Function 2-2 2-2 ATM Backbone SwitchModule Function 2-2 2-3 General LAN Emulation Components 2-3 2-4 ATM Backbone SwitchModule LANE Components 2-4 2-5 LAN Emulation
ページ10に含まれる内容の要旨
ページ11に含まれる内容の要旨
TABLES 1 Notice Icons 2 2 Text Conventions 2 1-1 Supported Standards and MIBs 1-4 1-2 SwitchModule Installation Per Backplane 1-8 4-1 Other Vbridge IGMP Snooping Options 4-4 6-1 Base Module LED Status 6-2 6-2 Base Module LED Corrective Actions 6-3 6-3 ATM OC-3 Card LED Corrective Actions 6-4 A-1 Environmental Specifications A-1 A-2 Mechanical Specifications A-1 A-3 Power Specifications A-2 A-4 ATM Backbone SwitchModule Fiber Optic Specifications A-2
ページ12に含まれる内容の要旨
ページ13に含まれる内容の要旨
ABOUT THIS GUIDE Introduction This guide describes how to install, configure, and manage the 3Com ® CoreBuilder 5000 ATM Backbone SwitchModule. If the information in the release notes shipped with your product differs from the information in this guide, follow the release note instructions. Audience This guide is intended for the following people at your site: n Network manager or administrator n Trained hardware installer or service personnel How to Use This The following table shows the loc
ページ14に含まれる内容の要旨
2 ABOUT THIS GUIDE Conventions The following tables list conventions used throughout this guide: Notice Icons Table 1 Icon Type Description Information Note Information notes call attention to important features or instructions. Caution Cautions alert you to personal safety risk, system damage, or loss of data. Warning Warnings alert you to the risk of severe personal injury. Table 2 Text Conventions Convention Description Enter vs. Type When the word enter is used in this guide, it means
ページ15に含まれる内容の要旨
Related Documents 3 Text Conventions (continued) Table 2 Convention Description Text represented as This typeface is used to represent displays that screen display appear on your terminal screen. For example: NetLogin: Text represented as This typeface is used to represent commands that commands you enter. For example: SETDefault !0 -IP NETaddr = 0.0.0.0 Keys Specific keys are referred to in the text as Return key or Escape key, or they may be shown as [Return] or [Esc]. If two or more ke
ページ16に含まれる内容の要旨
4 ABOUT THIS GUIDE n CoreBuilder 5000 Integrated System Hub Installation and Operation Guide — Provides information on the installation, operation, and configuration of the CoreBuilder 5000 Integrated System Hub. This guide also describes the principal features of the CoreBuilder 5000 Fault-Tolerant Controller Module. n CoreBuilder 5000 Distributed Management Module User Guide — Provides information on the CoreBuilder 5000 Distributed Management Module’s operation, installation, and config
ページ17に含まれる内容の要旨
Related Documents 5 n Kastenholz, F. and McCloghrie, K., Evolution of the Interfaces Group of MIB-II, RFC 1573, FTP Software and Hughes LAN Systems, January 1994. n Brown, T. and Tesink, K., Definitions of Managed Objects for the SONET/SDH Interface Type, RFC 1595, Bell Communications Research, March 1994. n Ahmed, M. and Tesink, K., Definitions of Managed Objects for ATM Management Version 8.0 using SMIv2, RFC 1695, Bell Communications Research, August 1994. n LAN Emulation Client Managem
ページ18に含まれる内容の要旨
6 ABOUT THIS GUIDE
ページ19に含まれる内容の要旨
INTRODUCTION 1 This chapter describes the features and components of the 3Com ® CoreBuilder 5000 ATM Backbone SwitchModules and how ATM Backbone SwitchModules operate. This chapter contains the following sections: n ATM Backbone SwitchModule Overview n ATM Backbone SwitchModule Architecture n ATM Backbone SwitchModule Descriptions n PacketChannel Backplane Description n Sample ATM Backbone SwitchModule Configurations ATM Backbone CoreBuilder 5000 ATM Backbone SwitchModules are high-performance
ページ20に含まれる内容の要旨
1-2 CHAPTER 1: INTRODUCTION Multiple Redundancy Levels You can configure the ATM Backbone SwitchModule for two levels of redundancy: n PHY Redundancy — A secondary ATM OC-3 card provides PHY redundancy. If the primary ATM OC-3 card or attached cable fails or performance fails or is no longer receiving light, the redundant ATM OC-3 card becomes active to maintain operations, if PHY switchover is enabled. n Module Redundancy — Adding a second ATM Backbone SwitchModule to the CoreBuilder 5000
