ページ1に含まれる内容の要旨
TOSHIBA AMERICA INFORMATION SYSTEMS
STORAGE DEVICE DIVISION
IRVINE, CALIFORNIA
SD-R2002
CD-RW/DVD-ROM COMBINATION MOBILE DRIVE
USER MANUAL
ページ2に含まれる内容の要旨
CONTENTS Introduction..............................................................................1 Setup ........................................................................................3 Using the CD-RW/DVD-ROM Combo Drive............................4 Troubleshooting.......................................................................6 Specifications ..........................................................................7 Drive Connectors..................................
ページ3に含まれる内容の要旨
INTRODUCTION – SD-R2002 General Features CD-RW disc write/rewrite at 1X, 2X and 4X 3-way Disc Eject (eject button, software, emergency eject hole) Average Access Time CD 120ms DVD-ROM 140ms Horizontal or Vertical Mount 2MByte Buffer Playback interchangeability for CD-ROM and DVD-ROM discs Regionalization (RPC2 compliance) (DVD) BUS Interface ATAPI Types of Disc Formats Supported – Write: • Applicable Write Format CD-R, CD-RW: Disc at once, Track at once, Session at once
ページ4に含まれる内容の要旨
Front Panel Figure 1.SD-R2002 CD-RW/DVD Combo Drive Front Panel Loading Load disc using tray. Tray Busy The LED lights green or amber when the drive is operating (LED is amber when drive is Indicator writing.) Eject The Eject button is used to open the disc tray so you can install or remove a disc. Button Emergency The emergency eject hole is to be used only when the Loading Tray will not open when Eject button is pressed. Eject Hole
ページ5に含まれる内容の要旨
SETUP – SD-R2002 Toshiba recommends that only trained professionals install this CD-RW/DVD-ROM Combo drive into your laptop/notebook. Installation Notes • The SD-R2002 CD-RW/DVD-ROM Combo drive has no jumpers that need to be set • Mounting orientation: 15° (horizontally), 15° vertically (volume control in down position), 30° (drive with volume control in up position). • When mounting drive use 4 M2-PO.4 tapping holes located on the left and right sides of drive. • When mounting d
ページ6に含まれる内容の要旨
USING THE CD-RW/DVD-ROM Combo Drive – SD-R2002 Drive Operation Inserting Media To insert media perform the following steps: Figure 1.Inserting Disc 1. Open the drive's loading tray by pressing the Eject Button and pulling out the tray. 2. Place media disc into drive's loading tray, and lightly press down on the inner portion of the disc. 3. Gently close the disc tray. Removing Media To remove media disc from the drive, perform the following steps: 1. Open the loading tray by
ページ7に含まれる内容の要旨
Regional Coding Region Protection Coding (RPC) of DVD Discs: this feature is supported on DVD Players and is used with DVD-Video Discs (i.e. movies). Currently, the motion picture industry has divided the world into different regional "zones." These regions or "zones" correlate to the regional markets into which the motion picture industry releases movies. Simply put, RPC Codes are placed on Movie Discs marketed throughout the world based on the region of the world where they are being so
ページ8に含まれる内容の要旨
TROUBLESHOOTING – SD-R2002 Problem Solution Disc tray cannot be opened • Check that there is power to drive. • Use Emergency Eject instructions to open tray. Drive is not recognized by • Is the drive connected properly? Are all cables plugged in system properly (e.g. Power Cable, Interface Cable and Audio Cables). • Is the software driver loaded? On a step-by-step (F8) Boot of the system is the CD-RW/DVD-ROM Combo drive recognized? (BIOS / DOS reports "device driver not found
ページ9に含まれる内容の要旨
SPECIFICATIONS –SD-R2002 General Interface: ATAPI Compatible CD-RW/DVD-ROM Standard - Write: Write Formats: Disc at once, Track at once, session at once, Packet Write CD-R, CD-RW: Write Disc: CD-DA, CD+(E)G, CD-MIDI, CD-TEXT, CD-ROM, CD-ROM XA, CD-R, CD-RW: MIXED MODE CD, CD-I, CD-I BRIDGE (Photo-CD, Video-CD), Multi- session CD (Photo-CD, CD-Extra, Portfolio) Compatible DVD-ROM Standard - Read: DVD: DVD-ROM (DVD-5, DVD-9, DVD-10, DVD-18) DVD-R CD-ROM: CD-DA, CD+(E)G, CD
ページ10に含まれる内容の要旨
Performance Rotational Speed DVD 3,792rpm (2.5 - 6X) DVD-VIDEO 1,377 – 2,222rpm (1.6 – 2.4X) CD-ROM 5,100rpm (24X) CD-RW, Video-CD, CD-DA 1,200 – 2,000rpm (4 – 5.7X) CD-R (write) 1,980rpm (4X) CD-RW (write) 1,980rpm (4X) Transfer Rate DVD-ROM 3,357 – 8,112KB/second (6X) DVD VIDEO 2,163 – 2,245KB/second (2.4X) CD-ROM mode 1: 1,552 – 3,600KB/second(24X) mode 2: 1,770 - 4,106KB/second (24X) Random Access Time 140ms DVD 120ms CD Data Error Rate -15 10 Max
ページ11に含まれる内容の要旨
Environmental Ambient Temperature Operating 5° to 45° C (41° to 113° F) Storage -10° to 60° C (14° to 140° F) Shipping -40° to 65° C (-40° to 149° F) Temperature Gradient Operating 11° C /hour (max) Storage/Shipping 20° C /hour (max) Relative Humidity Operating 8% to 80% Storage/Shipping 5% to 95% (wet bulb 40° C max) Vibration 2 Operating (5 to 500 Hz) (read) 2.45 m/s (0.25G) (O-P) 2 Operating (5 to 500Hz) (write) 2.45 m/s (0.25G) (O-P) 2 Non-operating (10 to 500Hz)
ページ12に含まれる内容の要旨
Drive Connectors – SD-R2002 Figure 1.SD-R2002 DVD Writeable Drive Rear Panel – Connector ATAPI A 50-pin ATAPI interface connector is found at the rear of the SD-R2002 CD-RW/DVD- ROM Combo drive. Connecting cable should use Japan Aviation Electronics Industry Connector Limited KX14-50Series L or equivalent connector. Table 1.Interface Pin Assignments PIN I/O SIGNAL NAME PIN I/O SIGNAL NAME NO. NO. 1 O Audio L-CH 2 O Audio R-CH 3 Audio Ground 4 Digital Ground 5 I /RESET 6
