ページ1に含まれる内容の要旨
TOSHIBA AMERICA INFORMATION SYSTEMS
STORAGE DEVICE DIVISION
IRVINE, CALIFORNIA
MK5002MPL (HDD1232)
1.8-INCH HARD DISK DRIVE
USER MANUAL
Rev 02
11/2006
ページ2に含まれる内容の要旨
CONTENTS Introduction..............................................................................1 Setup ........................................................................................2 Using the HDD .........................................................................3 Specifications ..........................................................................4 Drive Connectors.....................................................................6
ページ3に含まれる内容の要旨
INTRODUCTION – MK5002MPL (HDD1232) HARD DISK DRIVE General Features • 1.8" sized drive • 1 Platter • 5.007 Gigabytes* • 5mm High • 15ms Average Seek Time • ATA(1 - 5) Interface • Ultra66 Supported • 256KB Buffer • Rotational speed of 3,990rpm • MTTF 300,000 Hours • 68-pin ATA and PC Card ATA Interface *Toshiba defines a megabyte (MB) as 1,000,000 bytes and a gigabyte (GB) as 1,000,000,000 bytes. 1
ページ4に含まれる内容の要旨
SETUP – MK5002MPL (HDD1232) HARD DISK DRIVE Caution: Your Hard Disk Drive is a precision device and even a small drop onto any surface can cause damage. Electronstatic discharge can also damage the drive. You should ground yourself prior to handling the drive. Figure 1. MK5002MPL Side View Installation Notes • Do not apply any force to the top cover, except the screw areas on top cover. Maximum force to the specified area is 2N • Locate PC Card Type II slot and gently slide
ページ5に含まれる内容の要旨
USING THE HARD DISK DRIVE – MK5002MPL (HDD1232) HARD DISK DRIVE Backing up Data Files To avoid data loss, regularly back up the data files on the hard disk drive. 3
ページ6に含まれる内容の要旨
SPECIFICATIONS –MK5002MPL (HDD1232) HARD DISK DRIVE General Model MK5002MPL (HDD1232) Interface ATA-1/2/3/4/5 (68-pin PC Card ATA Functionality Formatted Capacity 5.027GB* Rotational Speed 3,990rpm Avg. Rotational Latency 7.52/ms Spin-up Time 3sec (typical) Buffer 256Kb Seek Time Average 15 Maximum 26 Internal Transfer Rate 93 ~ 125 Mbits/sec (max) Host Transfer Rate Ultra DMA mode 66.7Mbytes/sec PIO Mode 16.6Mbytes/sec Interleave Factor 1:1 *Toshiba defines a m
ページ7に含まれる内容の要旨
Power Consumption 3.3V 5V 1.2W typ 1.9W typ Start 1.3W typ 2.0W typ Seek 1.2W typ 1.9W typ Read 1.3W typ 2.0W typ Write 0.5W typ 0.10W typ Sleep 0.10W/GB avg 0.16W/GB avg Energy Consumption Efficiency Shock 2 Operating 1,960m/s (200G)(2msec) 2 Non-Operating 9,800m/s (1000G)(1msec) Physical Height 0.2 (5.0mm) Width 2.13" (54.0mm) Depth 3.37" (85.6mm) Weight .94oz (55g) typ Regulatory The drive satisfies the following standards: Underwriters Laborato
ページ8に含まれる内容の要旨
DRIVE CONNECTORS –MK5002MPL (HDD1232) HARD DISK DRIVE Figure 1. MK5002MPL HDD - INTERFACE CONNECTOR Interface Connector Drive Side Connector MCD-D50 Series by DDK Connectors Recommended Host Side Connector MCD-D50 Series by DDK Connectors 6
ページ9に含まれる内容の要旨
Interface Signals DRIVE INTERFACE SIGNALS PIN SIGNAL PIN SIGNAL 1 RESET 2 GROUND 3 DD 7 4 DD 8 5 DD 6 6 DD 9 7 DD 5 8 DD 10 9 DD 4 10 DD 11 11 DD 3 12 DD 12 13 DD 2 14 DD 13 15 DD 1 16 DD 14 17 DD 0 18 DD 15 19 GROUND 20 OPEN 21 DMARQ 22 GROUND 23 DIOW/STOP 24 GROUND 25 DIOR/ 26 GROUND -DMARDY HSTROBE 27 IORDY/ 28 CSEL -DMARDY/- DSTROBE 29 DMACK 30 GROUND 31 INTRQ 32 IOCS16 33 DA1 34 PDIAG 35 DA0 36 DA 2 37 CS0 38 CS1 39 DASP 40 GROUND 41 3.3V (LOGIC) 42 3.3V (MOTO
