ページ1に含まれる内容の要旨
TOSHIBA
Storage Device Division
DVD WRITEABLE
DRIVE
SD-R5272
using
Nero6 OEM Suite 3 Software
Installation Instructions
VERSION 1.0
FEBRUARY 2004
ページ2に含まれる内容の要旨
DVD WRITEABLE DRIVE Installation Instructions For the following Drive: SD-R5272 TOSHIBA AMERICA INFORMATION SYSTEMS, INC. STORAGE DEVICE DIVISION 9740 Irvine Blvd. Irvine, CA 92618 Contents of this manual are subject to change without prior notice. © 2004 TOSHIBA AMERICA INFORMATION SYSTEMS, INC. All rights reserved Printed in USA P/N 460031-A0
ページ3に含まれる内容の要旨
Limited Warranty Toshiba America Information Systems, Inc. Storage Device Division 9740 Irvine Boulevard, Irvine, California 92618 1-949-583-3000 What does my limited warranty cover? Toshiba America Information Systems, Inc. (“Toshiba”) warrants the Toshiba Storage Product (“Product”) you have purchased from Toshiba or from a Toshiba authorized dealer is free from defects in materials or workmanship under normal use during the warranty period. This limited warranty extends only to the original
ページ4に含まれる内容の要旨
Disclaimer and limitation of remedy ALL OTHER EXPRESS AND IMPLIED WARRANTIES FOR THIS PRODUCT, INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE AND/OR NONINFRINGEMENT OF THIRD PARTY RIGHTS, ARE HEREBY DISCLAIMED. TOSHIBA EXPRESSLY DISCLAIMS ALL WARRANTIES NOT STATED IN THIS LIMITED WARRANTY. ANY IMPLIED WARRANTIES THAT MAY BE IMPOSED BY LAW ARE LIMITED IN DURATION TO THE TERM OF THIS EXPRESS LIMITED WARRANTY. SOME COUNTRIES, STATES OR JURISDICTIONS DO NOT
ページ5に含まれる内容の要旨
Table of Contents Checking your Kit Packaging ....................................................................... 1 System Requirements.................................................................................... 1 Media Recommendations ............................................................................. 1 Setting Jumpers ............................................................................................. 2 Placing DVD Writeable Drive inside your computer ...........
ページ6に含まれる内容の要旨
Congratulations on your purchase of a Toshiba DVD-R/-RW Combo drive and Kit. The following information will help you in the simple installation of your new DVD Writeable drive. CHECKING YOUR KIT PACKAGING Please unpack your DVD Writeable drive kit, and assure that you have the follow- ing items: Toshiba DVD Writeable Drive Blank Media (1) Nero6 OEM Suite 3 Software CD DVD Writeable Drive Installation Instructions (this manual) Quick Start Guide Mounting screws (4) IDE BUS cable Audio ca
ページ7に含まれる内容の要旨
The following steps must be performed to properly install your DVD Writeable drive. Set drive’s jumpers Connect audio cable Attach IDE BUS cable Connect power cable Mount DVD Writeable Drive Install Nero6 Ultra Edition Software SETTING JUMPERS The mode select jumpers are six (6) straight pins located on the rear of the DVD Writeable Drive. By placing a jumper on the pins, you can select the following functions: CS: – Drive is configured using host interface signal CSEL SL: – Configures dri
ページ8に含まれる内容の要旨
1. Remove computer cover and faceplate if required (refer to your computer system’s manual for removal information). 2. If the DVD Writeable drive is replacing a CD-ROM, disconnect all connectors and remove the CD-ROM presently installed in your system. 3. Your Toshiba DVD Writeable drive can be placed in any free half-height drive slot at the front of your computer. (It can be mounted horizontally or vertically.) 4. Carefully start sliding the DVD Writeable drive into the opening with the disc
ページ9に含まれる内容の要旨
Connect secondary IDE BUS cable to the DVD Writeable drive, assuring that pin 1 of the cable (side with red stripe) is connected to pin 1 on the drive. • If the DVD Writeable drive is the only drive connected on the secondary IDE BUS cable: connect drive to the last set of pins on IDE BUS cable. If there is a device (i.e. CD-ROM) connected to the secondary IDE BUS cable: connect the DVD Writeable drive to the open middle connector. The DVD Writeable drive should then be jumpered to SL (slave
ページ10に含まれる内容の要旨
COMPLETING INSTALLATION After you have connected all the necessary cables, push the DVD Writeable drive completely into the computer’s drive slot. Mount the drive per your computer’s instructions using the screws included in your kit. If you are using other screws, assure that the screw length does not exceed 3±0.5mm (measured from outside surface of side or bottom of drive to tip of screw). Replace the computer cover and all outer screws. ATAPI CD/DVD Software Driver: Toshiba’s optical drives d
ページ11に含まれる内容の要旨
MEDIA After installing Nero6 OEM Suite 3 software your system is ready to use. Some important things to remember when using your DVD Writeable drive: Do not insert more than one CD or DVD disc into the drive at a time. Do not insert anything other than a CD or DVD disc into drive. Use media that is the correct size and shape. Use media that meets write/read requirements listed in the Specifications (see page 8). EMERGENCY EJECT CAUTION! The following procedure is intended only as a last reso
ページ12に含まれる内容の要旨
DVD WRITEABLE DRIVE FRONT PANEL The photo below illustrates the following features of the SD-R5272 DVD Writeable drive’s front panel: DVD WRITEABLE DRIVE BACK PANEL The photo below illustrates the following features of the SD-R5272 DVD Writeable drive’s back panel: TECHNICAL SUPPORT Technical support can be obtained by calling 503/615-4364 or by sending an email to: toshibatech@teleplan.com or visiting our website at: http://www.sdd.toshiba.com 7
ページ13に含まれる内容の要旨
SPECIFICATIONS DATA CAPACITY DVD-ROM, DVD-RAM 2,048 Byte/Block CD-ROM 2,048 Byte/Block (mode 1) 2,336 Byte/Block (mode 2) ROTATIONAL SPEED DVD (single) 7,580rpm (5 - 12X CAV) 5,053rpm (3.3 - 8X CAV) DVD (dual) DVD-R, DVD+R (read) 5,053 - 5,560rpm (4 - 8X PCAV) DVD-RW, DVD+RW (read) 3,790 - 5,560rpm (4 - 6X PCAV) DVD-RAM (V2.1) 1,400 - 3,300rpm (2X ZCLV) DVD-R, DVD+R (write) 4,100 - 6,800rpm (4/5/8X ZCLV) DVD-RW, DVD+RW (write) 2,200 - 5,560rpm (4X CLV) CD-ROM, CD-R: 8,561rpm (17.2 - 40X CAV) CD-
ページ14に含まれる内容の要旨
460031-A0 P/N 460031-A0
