ページ1に含まれる内容の要旨
Jumper settings for this drive are shown below
Drive is master
or single drive
Drive is slave
Use cable select
U Series 9 ce Installation Guide
ST3160022ACE, ST3120025ACE and ST380012ACE
Drive is master with non-
ATA-compatible slave
ATA Interface Disc Drives
Master/slave jumpers (see table for key to jumper settings)
Publication Number: 100271708, Rev. B, December 2003
2. Mount the drive and attach cables
The easiest way to install your drive
a. Slide the drive into a 3.5-inch drive bay. Yo
ページ2に含まれる内容の要旨
of this sheet. are installed correctly. 4. Partition and format the drive 2. Does the computer recognize the drive? Make sure the master/ slave jumpers are set correctly on all installed hard drives. Verify that Before your new drive can store data, it must be partitioned (assigned one the drive is detected by the system CMOS or Setup program. or more drive letters) and each partition must be formatted. You can parti- tion and format the drive using DiscWizard or using programs built into 3. Doe