ページ1に含まれる内容の要旨
into the primary IDE port on your computer’s motherboard (see your
computer manual to determine the location of the primary IDE port).
d. Make sure the BLACK connector on the cable is plugged into your
U Series X 10 Installation Guide
existing hard drive.
Existing
ST310014A
e. Plug the GRAY connector into hard drive
BLACK
Publication Number: 100216029, Rev. A connector
your new Seagate hard drive, as
shown in the figure at right and
The easiest way to install your drive
below.
DiscWizard , avai
ページ2に含まれる内容の要旨
Partitioning and formatting using Windows utility software 2. Does the computer recognize the drive? Make sure the master/ slave jumpers are set correctly on both hard drives. Verify that the Caution. Partitioning or formatting a drive erases all the data on that ! drive. Make sure you select the correct drive! drive is detected by the system CMOS or Setup program. a. Insert a bootable startup diskette or CD and restart your computer. 3. Does Scandisk find any defects? Run Scandisk from the com
